New synthetic “tricks” using old reagents. A mild method for the conversion of RCONHR′ to RCONHR″

N-Alkyl-N-nitrosoamides, RCON(NO)R′, react with primary aliphatic amines (NH₂R″), in refluxing dichloromethane or at room temperature, to give RCONHR″ in 65–98% yields.     

Structural Study of Silica Xerogel Composites Containing Pd Aggregates

Composites containing Pd aggregates dispersed in amorphous silica are of interest from both a fundamental and applied point of view because of their attractive catalytic properties. The silica powders added with palladium, prepared by the sol-gel method, were studied using X-ray diffraction, and IR- and UV-Vis-spectrophotometry. Silica xerogel samples were prepared using a ethanol/H₂O/TEOS molar ratio of 4:11.6:1 and loaded with sodium tetrachloropalladate. The silica xerogel microstructure of the powders was studied as a function of annealing temperature. Attention was paid to the evolution of the glass matrix as well as the palladium aggregates in the SiO₂ matrix. We found in our samples partial crystallization of the glass matrix in form of quartz and cristobalite phases with palladium oxide and metallic palladium phase at 1000^∘C. The Rietveld refinement method was used in order to determine the percentage of the phase contents.     

Experimental designs and response surface modeling applied for the optimization of metal-cyanide complexes analysis by capillary electrophoresis

The development of capillary zone electrophoresis (CZE) methods for the determination of metal cyanide complexes in real samples showed some problems, such as the low detection signal of Au (CN)2- and the low resolution between Ni(II) and Fe(II) cyanides in gold processing solutions, and the lack of separation of Pt(CN)4(2-) and Pd(CN)4(2-) in the leachates from automobile catalytic converters. To optimize some analytical parameters, the present study thus focused on the application of experimental designs and multiregression models. The following factors were examined by a two-level factorial design: applied voltage, injection time, detection wavelength, buffer ion, ionic strength and buffer modifiers. For optimization of the CZE method, subsequent response-surface experiments with the important factors were made with the two kinds of leaching solutions. Optimal analytical conditions were obtained in each case, giving good detection signals and resolution for the components of the studied leachates.     

Interactions of thiophenes and acidophilic,thermophilic bacteria

The growth and oxygen consumption of a variety of thermophilic, acidophilic bacteria in the presence of thiophene-2-carboxylate (T2C) and dibenzothiophene (DBT) have been determined. T2C was extremely toxic to the acidophiles in comparison with neutrophiles, but appeared to be degraded by a heterotrophicSulfolobus- like thermophile. DBT proved to be unstable at high temperatures, even in the absence of bacteria, and was not a substrate for the thermophiles.     

Application of strategically designed sample composition to the rapid analytical screening of milk samples for polychlorinated biphenyls

Strategically designed sample composition (SSC) is a new technique that decreases the number of analytical determinations needed in routine screening to as few as the number of original sample specimens while providing information that is specific to them. Although this new technique has been applied to environmental studies, this paper describes its first application to food safety studies. Contamination of milk samples with polychlorinated biphenyls (PCBs) was chosen as a case study to show the usefulness and potential of the SSC technique with a fast analytical procedure that involves saponification of the samples and solid-phase microextraction of the PCBs. A total of 20 sample specimens can be analyzed in 11 determinations with excellent predictions of the positive samples and the concentration levels of the contaminants. The robustness of the strategy was investigated and demonstrated.     

Structure and aggregation number of a lyotropic liquid crystal: a fluorescence quenching and molecular dynamics study

The structure and aggregation number of a discotic lyotropic liquid crystal, prepared from tetradecyltrimethylammonium chloride (TDTMACl)/decanol (DeOH)/NaCl/H2O, have been examined using fluorescence quenching of pyrene by hexadecylpyridinium chloride and molecular dynamics (MD). The fluorescence method gives an aggregation number of 258 +/- 25 units (DeOH + TDTMACl). From the MD simulation, a lower limit for the aggregate dimension of 130 units of DeOH + TDTMACl is predicted. A stable oblate aggregate of 240 units was studied in detail. A strong polarization between the ammonium headgroups and chloride ions is observed from the calculated trajectory. DeOH headgroups are located, on average, 0.3 nm more to the interior of the aggregate than the TDTMACl headgroup and contribute to widening the interface by forming H-bonds with water. The radial distribution function of the ammonium headgroup shows that there are 16 water molecules in the first solvation sphere. The diagonal elements of the order parameter tensor of the tail atoms of both surfactants indicate that the interior of the micelle preserves about the same degree of order as at the interface, up to the last three atoms of the aliphatic chain, where the order starts to decrease.     

Highly efficient redox isomerization of allylic alcohols at ambient temperature catalyzed by novel ruthenium-cyclopentadienyl complexes--new insight into the mechanism

A range of ruthenium cyclopentadienyl (Cp) complexes have been prepared and used for isomerization of allylic alcohols to the corresponding saturated carbonyl compounds. Complexes bearing CO ligands show higher activity than those with PPh3 ligands. The isomerization rate is highly affected by the substituents on the Cp ring. Tetra(phenyl)methyl-substituted catalysts rapidly isomerize allylic alcohols under very mild reaction conditions (ambient temperature) with short reaction times. Substituted allylic alcohols have been isomerized by employing Ru-Cp complexes. A study of the isomerization catalyzed by [Ru(Ph5Cp)(CO)2H] (14) indicates that the isomerization catalyzed by ruthenium hydrides partly follows a different mechanism than that of ruthenium halides activated by KOtBu. Furthermore, the lack of ketone exchange when the isomerization was performed in the presence of an unsaturated ketone (1 equiv), different from that obtained by dehydrogenation of the starting allylic alcohol, supports a mechanism in which the isomerization takes place within the coordination sphere of the ruthenium catalyst.     

Benzo[d]-1,2-oxaphospholes as precursors of stabilized C-centered radicals

[reaction: see text] Several benzo[d]-1,2-oxaphosphole 2-oxides were examined as potential precursors of stabilized C-centered radicals. The transient absorption spectra obtained after laser flash photolysis in the presence of di-tert-butyl peroxide showed the features of benzylic radicals with formation and decay kinetics not significantly influenced by the presence of oxygen. In the case of compounds with two possible diastereomeric forms, the C-H bond of the trans-isomers [corrected] is more reactive toward hydrogen abstraction.     

Density and Speed of Sound for Binary Mixtures of a Cyclic Ether with a Butanol Isomer

Densities and speeds of sound of the binary mixtures 1,3-dioxolane + 1-butanol, 1,3-dioxolane + 2-butanol, 1,4-dioxane + 1-butanol, and 1,4-dioxane + 2-butanol have been measured at 25 and 40°C. The excess molar volumes and excess isentropic compressibility coefficients were calculated from experimental data and fitted to a Redlich–Kister polynomial function. Results were analyzed in terms of molecular interactions and compared with literature data.     

Determination of ageing time of spirits in oak barrels using a headspace–mass spectrometry (HS-MS) electronic nose system and multivariate calibration

The aromatic composition of sugar cane spirits and, in general, of alcoholic beverages, is mainly influenced by the ageing process in wood barrels. There are several factors that affect the quality of the final aged product, but the time of the storage in the barrel is perhaps the most important one. Ageing time must therefore be controlled in order to detect counterfeits; however, this parameter is very difficult to control and, at present, there is no analytical method available to determine it. We propose a quantitative method for determining the ageing time of sugar cane spirits in oak barrels by using an electronic nose based on coupling directly a headspace sampler to a mass spectrometer (HS-MS), and multivariate calibration. The method developed is simple and provides, in 5 min, the ageing time of spirits with an accuracy of about 1 month.