The direct detection of a hydrogen bond in the solid state by NMR through the observation of a hydrogen-bond mediated (15)N [bond] (15)N J coupling

A new method for detecting hydrogen bonds in the solid state is presented. Using two-dimensional NMR correlation experiments, it is shown that a hydrogen-bond mediated J coupling can be observed in a powder under magic-angle spinning conditions, even though the J coupling is 2 orders of magnitude smaller than the dominant anisotropic interactions encountered in solid-state NMR. Specifically, the observation of a pair of peaks in a two-dimensional 15N-15N solid-state INADEQUATE experiment due to two nitrogens that have no covalent connectivity is attributed to the presence of a J coupling across a linking hydrogen bond.     

Prediction of the behaviour of organic pollutants using cloud point extraction

A preconcentration study based on the cloud point phenomenon was carried out for a set of triazine herbicides, three of them chloro-substituted and three of them methylthio-substituted. Concentration factors and recoveries were calculated as function of the percentage of the non-ionic surfactant Triton X-114 employed. From these values, obtained from a cloud point extraction (CPE) procedure, the distribution coefficient between the Triton X-114 micelles and water, Kc, prior to CPE was calculated for each triazine and related to the corresponding octanol-water partition coefficient, Kow. In order to confirm the results obtained with the triazine herbicides, two sets of data from chemically different organic pollutants--organophosporous and chlorophenols--obtained from the literature were assessed, concluding that they display a similar behaviour to that of the triazine herbicides. This can be used to predict the CPE behaviour of other organic pollutants from their octanol-water partition coefficients. The Kc values were compared with the analyte concentration ratio in the surfactant-rich phase and aqueous phase (Ksa) with a view to obtaining a link between the analyte behaviour prior to and after cloud point extraction procedures.     

Global optimization of ionic Mg(n)F(2n) (n=1-30) clusters

The global optimization basin-hopping (BH) method has been used to locate the global minima (GM) of Mg(n)F(2n) (n=1-30) clusters using a Born-Mayer-type potential. Some of the GM were particularly difficult to find, requiring more than 1.5 x 10(4) BH steps. We have found that both the binding energy per MgF2 unit and the effective volume of the GM isomers increase almost linearly with n, and that cluster symmetry decreases with cluster size. The data derived from the BH runs reveal a growing density of local minima just above the GM as n increases. Despite this, the attraction basin around each GM is relatively large, since after all their atomic coordinates are randomly displaced by values as high as 2.0 bohrs, the perturbed structures, upon reoptimization, relax back to the GM in more than 50% of the cases (except for n=10 and 11). The relative stabilities derived from energy second differences suggest that n=8,10,13,15, and 20 are probably the magic numbers for these systems. Mass spectrum experiments would be very useful to clarify this issue.     

Screening the origin and weathering of oil slicks by attenuated total reflectance mid-IR spectrometry

The combination of attenuated total reflectance-fourier transform mid-infrared spectrometry (ATR-FTMIR) and multivariate pattern recognition is presented as a fast and convenient methodology to ascertain the source product an oil slick comes from and to evaluate the extent of its weathering. Different types of hydrocarbons (including crude oils, several heavy distillates and the Prestige's heavy fuel oil) were spilled on metallic containers designed ad hoc and their fate monitored by ATR-FTMIR. Not only environmental conditions were considered for weathering but artificial IR- and UV-irradiation. Pattern-recognition studies revealed that the different hydrocarbons clustered at different locations on the score plots and that the samples corresponding to each oil became ordered according to the extent of their weathering. Among them, fuel oil samples coming from the recent disaster of the Prestige tanker off the Galician shoreline showed a distinctive behaviour. Comparison of natural-, IR- and UV-weathering of a crude oil showed that IR solar radiation can be important in oil-weathering, in addition to broadly-reported UV degradation.     

Tandem on-line continuous separation and determination of arsenic by inductively coupled plasma atomic emission spectrometry

The principle of tandem on-line continuous separation techniques as an alternative means of introducing samples into plasmas was applied to the development of a sensitive, selective and convenient method for the determination of arsenic by inductively coupled plasma atomic emission spectrometry (ICP-AES). Arsenic is continuously extracted as AsI₃ into xylene from the sample dissolved in 0.1 M potassium iodide solution in 7.2 M hydrochloric acid. The xylene phase (containing the analyte) is continuously mixed on-line with NaBH₄ in dimethylformamide and acetic acid solutions. Arsine is thus continuously generated directly from the organic phase and is separated in a gas—liquid separation device which prevents most of the xylene phase vapour from reaching the ICP. The system was optimized for the continuous extraction of AsI₃, the direct generation of arsine from xylene and the final ICP determination of arsenic. Finally, the tandem on-line continuous separation ICP detection system was applied to the determination of arsenic in real samples (white metal, cast iron, cupro-nickel and orchard leaves standard materials). Very good agreement between the experimental results and the certified values was obtained.     

Nitrosation of Phenolic Compounds: Effects of Alkyl Substituents and Solvent

Summary.  Nitrosation reactions of phenol, o-cresol, 2,6-dimethylphenol, o-tert-butylphenol, 2-hydroxyacetophenone, and 2-allylphenol in water and water/acetonitrile were studied. Kinetic monitoring of the reactions was accomplished by spectrophotometric analysis of the nitrosated products at 345 nm. The dominant reaction was C-nitrosation via a mechanism consisting of an attack on the nitrosatable substrate by NO⁺/NO₂H₂ ⁺ followed by a slow proton transfer. The values of the rate constants of phenolic C-nitrosation were increased by electron donating substituents, and a good Hammett correlation was observed with ρ = −6.1. The results also revealed the strong effect of pH and the permitivity of the reaction medium on the rate constant, whose maximum values were observed for pH ≈ 3, decreasing strongly for higher pH values. The study in water/acetonitrile with up to 25% acetonitrile showed that it is possible to inhibit the reaction strongly by increasing the percentage of the organic component. The conclusions drawn show that (i) it is possible to predict the rate of nitrosation of phenolics as a function of the meta-substituents on the phenol ring and (ii) the nitrosation of phenolics can be strongly inhibited by increasing the pH of the reaction medium as well as by lowering its dielectric constant. Received July 13, 2001. Accepted (revised) September 18, 2001     

Comparative study of separation and determination of triazines by micellar electrokinetic capillary chromatography and nonaqueous capillary electrophoresis: application to residue analysis in natural waters

The separation and determination of a mixture of chloro- and methylthiotriazines in water samples by both micellar electrokinetic capillary chromatography (MEKC) and nonaqueous capillary zone electrophoresis (NA-CZE) were compared. The characteristics of both methods proved to be very similar in terms of separation efficiency and analysis times, but application of these methods for the analysis of triazines in natural waters, with a prior preconcentration step, revealed significant differences. A preconcentration step by solid-phase extraction (SPE) with Oasis HLB cartridges was accomplished for the determination of triazines at sub-ppb levels in drinking and river waters; when NA-CZE was used after this SPE step, electropherograms with fewer interferences and more stable baselines were obtained than when separation was carried out using MEKC. Another aspect related to the application to real samples was the lack of precision encountered upon evaluating the electrophoretic signals generated when using SPE coupled with NA-CZE. Here, we demonstrate the importance of choosing an appropriate internal standard for analyte quantification. It is recommended that a triazine belonging to the same family as that of the triazine to be determined should be used as internal standard.     

Determination of pesticides and some metabolites in different kinds of milk by solid-phase microextraction and low-pressure gas chromatography-tandem mass spectrometry

A new analytical method is proposed to determine more than 40 multiclass pesticides in different kinds of processed (whole, skimmed and powdered) and unprocessed (goat and human) milk samples using solid-phase microextraction (SPME). A comparative study between headspace (HS) and direct immersion (DI) was carried out. The effect of milk dilution and the use of acid to reduce the influence of the matrix in DI-SPME mode were also evaluated. DI of the SPME fiber into previously diluted and acidified milk samples achieved the best sensitivity results. Pesticides were determined using low-pressure gas chromatography-tandem mass spectrometry (LP-GC-MS/MS). Both of the selected techniques have been shown to be effective at reduce fat interference and can determine analytes present at very low concentrations (limits of quantification between 0.02 and 1.00 g L^–1). Performance characteristics such as linearity, recovery, precision, and lower limits, together with an estimation of the measurement uncertainty using validation data, are presented for each pesticide. All of the pesticides presented recovery rates of between 81 and 110% and precision values lower than 12% (expressed as the relative standard deviation). The overall uncertainty of the method was estimated at three different concentrations (10, 25 and 50 g L^–1) and was lower than 25.5% in all cases. The proposed analytical methodology was applied to the analysis of target pesticides in 35 samples: 15 commercial, 3 human and 17 goat milk samples. The metabolite p,p-DDE was the compound most frequently found in both the breast and goat milk samples, at concentration levels <20 g L^–1. However, pesticide residues were not found in any of the other 15 commercial milk samples (skimmed, powdered and whole milk) analyzed.     

Kit for instant 99mTc labeling of the antimicrobial peptide ubiquicidin 29-41

Summary The ubiquicidin 29-41 fragment (UBI) is a cationic antimicrobial peptide. The aim of this study was to develop an instant kit formulation for the preparation of ^99mTc-UBI 29-41 in high radiochemical yield and to evaluate its use as an infection imaging agent in humans. The components were selected to produce a direct ^99mTc labeling, presumably to the amine groups of Lys and Arg7. ^99mTc-UBI 29-41 obtained from the lyophilized kit showed radiochemical purity of >97% with an average target/non-target ratio of 2.3±0.6 in positive infection sites at 2 hours. Kits were stable at 4 °C for over 6 months.     

Cobalt-mediated approach for the synthesis of terpene-based hybrids

[structure: see text] Dicobalt-beta-pinene hybrids of types I and II have been prepared using a Nicholas reaction between propargyl derivatives, obtained from commercial (1R)-(-)-myrtenal, and different aromatic nucleophiles. The method is suitable for the preparation of densely functionalized bio-organometallic natural product-based hybrids, as demonstrated by the preparation of a beta-pinene-neoclerodane hybrid.