Evaluation of different quantitative approaches for the determination of noneasily ionizable molecules by different atmospheric pressure interfaces used in liquid chromatography tandem mass spectrometry: Abamectin as case of study

The liquid chromatography tandem mass spectroscopy residue determination of compounds without any acidic or basic centers such as abamectin has been investigated. Several approaches regarding the interface used and adduct formation have been compared. The low acidity of the hydroxyl groups only made deprotonation feasible using the atmospheric pressure chemical ionization (APCI) interface. To obtain sufficient sensitivity for residue analysis, the Ion Sabre APCI interface was necessary. However, the sensitivity attained was lower than for monitoring adducts in positive ion mode. Using electrospray ionization, different adducts with Na+, NH4+, and Li+ were tested and compared. The best results were obtained for the ammoniated adduct in electrospray ionization (ESI) because of its high sensitivity and the presence of several product ions with similar abundance. The highest sensitivity was reached using an in-source fragment as precursor ion, leading to a limit of detection (LOD) of 2 microg/L with low relative standard deviation. The relatively high abundance of other transitions allowed abamectin confirmation at concentrations close to the LOD (6 microg/L). Alkali ions were found to be a suitable alternative to determine and confirm abamectin at residue levels. The [M + Na]+ also presented various product ions with similar abundance, which allowed confirmation at LOD levels. However, this LOD was found to be almost four times higher than with [M + NH4]+ because of the poor sensitivity of the transitions obtained. Although the use of Li+ facilitated the fragmentation of the adduct [M + Li]+, with similar sensitivity to [M + NH4]+, this fragmentation preferentially generated only one product ion, which did not allow confirmation at concentration levels lower than 15 microg/L. The use of APCI for monitoring adducts was also feasible, but with less sensitivity. The sensitivity increased with the Ion Sabre APCI, although it was still five times lower than with ESI. Other adduct formers such as Co2+ and Ni2+ also were tested with unsatisfactory results.     

Synthesis, characterization and optical properties of pi-conjugated systems incorporating closo-dodecaborate clusters: new potential candidates for two-photon absorption processes

Non-centrosymmetric pi-conjugated systems incorporating closo-dodecaborate clusters, [NC-C6H4-C(H=N(H)-B12H11]-(2), [NC-C6H4-C(H)=C(H)-C(6)H(4)-C(H)=N(H)-B12H11]-(3), and [NC-C6H4-C(H)=C(H)-C6H4-C(H)=C(H)-C6H4-C(H)=N(H)-B12H11]-(4) have been synthesized by reaction of the monoamino derivative of B12, [B12H11NH3]-(1), with various arylaldehydes, R-C6H4-CHO. These Schiff base-like compounds were fully characterized by multinuclear NMR spectroscopy and mass spectrometry. In order to evaluate these boron rich pi-systems as potential materials for two-photon absorption (TPA) processes, UV linear absorption curves were recorded for 3 and 4, and comparatively studied with those of the boron-free pi-systems NC-C6H4-C(H)=N-CH3(5) and NC-C6H4-C(H)=C(H)-C6H4-C(H)=N-CH3(6). The donor effect of the boron cluster was evidenced by a shift to the lower energy of the absorption band in the spectra of systems incorporating B12. The two photon absorption (TPA) spectrum of compound , obtained by the up-conversion method, shows a resonance at 720 nm with a cross-section sigma(TPA) of 35 x 10(-50) cm(4) s photon(-1) molecule(-1). This value suggests the potential of B12 clusters to be used as new donor groups for the synthesis of non-linear materials.     

Considerations on the modelling and optimisation of resolution of ionisable compounds in extended pH-range columns

The problems associated to the modelling and optimisation of the chromatographic resolution of mixtures involving ionisable solutes at varying pH and acetonitrile content are discussed. Several retention models that separate the contributions of solute, column and stationary phase, were used. The retention was predicted with low errors in large pH domains (2-12), which was an essential requirement to face the optimisation of resolution. The selected mixture was particularly problematic under the viewpoint of resolution, owing to the excessively diverse acid-base behaviour of solutes. This variety led to sudden drops in retention at different pH for each solute, yielding numerous peak crossing, which made finding shared regions of high resolution especially difficult. Conventional resolution diagrams for these situations are scarcely informative, since both the overall and the worst elementary resolutions drop to zero if at least two compounds remain overlapped, even when all the others are baseline resolved. A new chromatographic objective function is proposed to address this drawback. This function, called "limiting peak count", is based on the limiting peak purity concept, and measures the success in the resolution focusing on the resolved solutes, in contrast to conventional resolution assessments that attend mainly to the least resolved solutes. Limiting peak count yields the same result as conventional assessments when full resolution is possible, but it is also able to discriminate the maximal resolving power in low-resolution situations. It offers a different perspective to that given by the complementary mobile phases approach, and the computation is far simpler.     

Effect of polymer molecular weight on the polymer/surfactant interaction

A thermodynamic analysis of the interaction between fourteen different molar mass poly(ethylene oxide)s (PEO) and sodium dodecyl sulfate (SDS) based on the measured surfactant-binding isotherms is given. The surfactant-binding isotherms were determined by the potentiometric method in the presence of 0.1 M inert electrolyte (NaBr). It was found that there is no PEO/SDS complex formation if M(PEO) < 1000. In the molecular weight range 1000 < M(PEO) < 8000, the critical aggregation concentration (cac) and the surfactant aggregation number are decreasing as the polymer molecular weight increases. The saturated bound surfactant amount is proportional to the number concentration of the polymer in this molecular weight range. If M(PEO) exceeds approximately 8000, the cac does not depend on the polymer molar mass, and the saturated bound amount of the surfactant becomes proportional to the mass concentration of the polymer. It was also observed that independently of the polymer molecular weight the surfactant aggregation number increases as the equilibrium surfactant monomer concentration increases from the cac to the critical micellar concentration (cmc). Finally, it was demonstrated that only one polymer molecule is involved in the complex formation independently of the polymer molecular weight.     

Mass transfer determining parameter in facilitated transport through di-(2-ethylhexyl) dithiophosphoric acid activated composite membranes

Activated composite membranes (ACMs) containing di-(2-ethylhexyl) dithiophosphoric acid (D2EHDTPA) as a carrier have been found to facilitate the transport and separation of several cations. This paper describes an approach to the chemical characterisation of the transport phenomena of Zn²⁺, Cd²⁺, Cu²⁺, Ni²⁺, Sn²⁺ and In³⁺ by an ACM. The selectivity of D2EHDTPA based ACM towards different metal ions is presented and discussed focusing in Zn²⁺ and Cd²⁺ transport and recovery. Selectivity demonstrates that zinc ions are removable from mixtures due to the different extraction strength of D2EHDTPA. Such selectivity is based on the differences of the dynamic behaviour of the metal ions transport. In addition, a correlation of the chemical behaviour of those ACM systems with the corresponding solvent extraction systems has been found.     

Influence of synthesis methods on tungsten dispersion, structural deformation, and surface acidity in binary WO3-ZrO2 system

WO3-ZrO2 catalysts were synthesized by precipitating the aqueous solutions of zirconium oxynitrate and ammonium metatungstate with ammonium hydroxide. The white slurry precipitate was treated under three different conditions. In the as-made materials, the amorphous phase was formed in the aged and refluxed samples, while well-crystallized tetragonal and monoclinic phases were obtained in the hydrothermally treated sample. The real amount of tungsten loaded in the samples was similar for the three samples, independently of the treatments; however, the tungsten surface atomic density in the annealed WO3-ZrO2 samples varied between 6 and 9 W atoms/nm2. Two different contrast types of aggregates were determined by scanning electron microscopy, the white particles which are rich in W, and the gray ones which are rich in zirconium; both of them were formed in the calcined solids prepared under aging or reflux condition. A very high dispersion of tungsten species on the zirconia surface was achieved in the hydrothermally treated sample. The degree of the interaction between WO(x) and ZrO2 surface strongly modified the Zr-O bond lengths and bond angles in the structure of tetragonal zirconia as proved by X-ray diffraction analysis and the Rietveld refinement. The catalyst obtained under hydrothermal condition exhibited the highest dispersion of tungsten species in the zirconia, which in turn causes strong structural deformation of the tetragonal ZrO2 phase responsible of the strongest surface acidity and, consequently, the optimum catalytic activity for n-hexane isomerization.     

Substituent effects on the SmI2/Pd(0)-promoted carbohydrate ring-contraction of 5-alkynylpyranosides

The effect of substituents on the reactivity and stereoselectivity of the SmI₂/Pd(0)-promoted ring-contraction of 5-alkynylpyranosides has been examined using substrates substituted only at selected positions. While formation of 2-ethynylcyclopentanols takes place efficiently, an internal alkyne did not afford the expected product. The presence of peripheral alkoxy substituents leads to variable stereoselectivities that depend on the number and orientation of such groups. Thus, an isolated OBn substituent at C(3) (carbohydrate numbering) exerts a significant stereochemical control while additional substitution with the same group at C(4) either enhances or drastically reduces stereoselectivity depending on its orientation (α or β, respectively).     

A New Gamma-Ray Spectrum Catalog for PGAA

A major obstacle to the use of the prompt gamma activation analysis (PGAA) method has so far been the lack of a suitable library. Therefore, new measurements have been performed at the PGAA facility at Budapest Research Reactor (BRR) in order to create a prompt -ray catalog for qualitative and quantitative analysis. Prompt -ray energies and associated k ₀-factors have been determined by internal standardization. The resulting catalog contains prompt -ray data from neutron capture and other reactions such as (n,), and decay -ray data from short-lived reaction products. Data have been measured for nearly all stable elements, from hydrogen to uranium. Generally, data for several isotopes are given, to enable isotopic analysis as well.     

Investigation of organosilicon radicals : II. Methylsilyl radicals

CNDO/2 calculations for a series of Me_xH₃?_xSi (where x = 0,1,2,3) free radicals confirm the suggestion, based on electron spin resonance measurements and chemical evidence, that these radicals are not planar. The deviation from planarity decreases with increasing number of methyl groups, but the angle between the carbonsilicon bond and the plane of an assumed planar configuration is the same for methylsilyl, dimethylsilyl, and trimethylsilyl radicals.     

Asymmetric diels-alder reactions : facile preparation and structure of sulfonamido-isobornyl acrylates

The crystalline chiral auxiliaries $\text{2}$,$\text{3}$ and $\text{4}$ were prepared from camphor-10-sulfonyl chlorides in 2 steps. Their readily accessible acrylates underwent efficient asymmetric diels-alder additions to cyclopentadiene, the topicity of which agrees with X-ray evidence.