Foams and surface rheological properties of β-casein, gliadin and glycinin

Interfacial rheological properties and their suitability for foam production and stability of two vegetable proteins were studied and compared to β-casein. Proteins used ranged from flexible to rigid/globular in the order of β-casein, gliadin and soy glycinin. Experiments were performed at pH 6.7. Network forming properties were characterised by the surface dilational modulus (determined with the ring trough) and the critical falling film length (L_still) at which a stagnant protein film will break. Gliadin had the highest dilational modulus, followed by glycinin and β-casein, whereas glycinin formed the strongest film against fracture in the overflowing cylinder. The rate of decrease in the surface tension was studied at the air–water (Wilhelmy plate method) and the oil–water interface (bursting membrane) and the dynamic surface tension during compression and expansion in the caterpillar. Gliadin had the lowest equilibrium interfacial tensions and β-casein the lowest dynamic surface tension during expansion. Hardly any foam could be formed at a concentration of 0.1 g/l by shaking. At a concentration of 1.4 g/l most foam was formed by β-casein, followed by gliadin and glycinin. It seems that in the first place the rate of adsorption is important for foam formation. For the vegetable proteins, adsorption was slow. This resulted in lower foamability, especially for glycinin.     

Growth and study of single crystals of (Na,K)NbO<Subscript>3</Subscript> solid solutions

(Na, K)NbO₃ crystals with a perovskite structure and a KNbO₃ content up to 40 mol % were grown from flux with the use of the solvent NaBO₂. The dielectric measurements of the crystals grown revealed phase transitions that had never been observed before in ceramic samples.     

On the dispersion of a solute in oscillating flow of a non-Newtonian fluid in a channel

The paper presents an exact analysis of the dispersion of an immiscible solute in a non-Newtonian fluid (known as an incompressible second-order fluid which shows viscoelastic behaviour) flowing slowly in a parallel plate channel in the presence of a periodic pressure gradient. Using a generalized dispersion model which is valid for all times after the solute injection, the diffusion coefficients K _i (τ)(i=1,2,3,…) are obtained as functions of time τ in the case when the initial solute distribution is in the form of a slug of finite extent. The analysis leads to the novel result that K ₂(τ) (which is a measure of the longitudinal dispersion coefficient of the solute) has a steady part S in addition to a fluctuating part D ₂(τ) due to the pulsatility of the flow. It is found that S decreases with increase in the viscoelastic parameter M for given values of the amplitude λ and frequency ω of the pressure pulsation. On the other hand, it is found that at a fixed instant τ, the amplitude of D ₂(τ) increases with increase in M for given values of λ and ω. Further it is shown that at a given instant τ, the amplitude of D ₂(τ) decreases with increase in ω for given λ and M and the profile for D ₂(τ) becomes progressively flatter with increase in ω. Finally the axial distribution of the average concentration θ _m of the solute over the channel cross-section is determined at different instants after the solute injection for several values of M, λ and ω. The present study is likely to have important bearing on the problem of dispersion of tracers in blood flow through arteries.     

Carleman problem for two pairs of functions in a ring

We consider a particular case of the matrix Carleman problem for two pairs of functions in a ring and find a constructive solution of this problem. In addition, we propose an algorithm for the construction of solutions for two infinite systems of smooth transition and for a system of two singular equations of special type. Translated from Ukrainskii Matematicheskii Zhurnal, Vol. 49, No. 5, pp. 662–671, May, 1997     

Thermoplastic polymers quality control

A technique is proposed for improving the accuracy of the heat of fusion of semicrystalline polymers by DSC. The results of three commercially available instruments are compared.     

NATA: 50 years experience with accreditation

 Laboratory accreditation is becoming increasingly accepted around the world as a means of identifying technically competent laboratories. It is also being used as a mechanism for the acceptance of test data both nationally and internationally. The concept and mechanisms of accreditation have been developed over the past 50 years. The first national laboratory accreditation system appeared in Australia in 1947. This organisation, known as the National Association of Testing Authorities (NATA), has since taken a leading role in developing accreditation practices that are now used world-wide in evaluating testing, measurement and calibration laboratories. This paper examines the development of the world's first and largest laboratory accreditation system, and looks at the difficulties and triumphs in gaining acceptance and recognition by government and industry of the benefits of laboratory accreditation. Received: 24 June 1996 Accepted: 25 June 1996     

Molecular electric field mapping of some anions and cations of 2- aminopurine and 6- thioguanine

Electric fields of the anions, cations and neutral forms of 2-aminopurine and 6-thioguanine have been mapped. Certain important features of the maps are similar to those found earlier in the neutral and ionic forms of adenine and guanine. The computed electric field patterns satisfactorily explain reactive sites and biological activity of the molecules.