Separation of the enantiomers of phenprocoumon and warfarin by high-performance liquid chromatography using a chiral stationary phase. Determination of the enantiomeric ratio of phenprocoumon in human plasma and urine

The enantiomers of the chiral coumarin-type anticoagulants phenprocoumon, warfarin and p-chlorophenprocoumon were separated by high-performance liquid chromatography on a chiral stationary phase (Nucleosil-Chiral 2) and normal-phase conditions. Chromatographic peak identification was performed with authentic reference compounds of the enantiomers and on-line UV spectra comparison. This method was applied to the determination of the enantiomeric ratio of phenprocoumon in plasma and urine extracts from patients under racemic drug therapy. The limit of detection (50 and 80 ng/ml) and precision (less than 5%) of the method are adequate for pharmacokinetic and enantioselective disposition studies, respectively, of phenprocoumon. No racemization was detected during the extraction procedures.     

Diffraction dissociation of nuclei in 450 GeV/c proton-nucleus collisions

Diffractive dissociation of nuclei (Be, Al, W) in collisions with 450 GeV/c protons,pApX, has been measured with the HELIOS spectrometer at the CERN Super Proton synchrotron. The dependence of the single-diffraction cross-section on the nuclear massA can be parametrized as _SD mb×A ^0.35±0.02, showing the peripheral nature of the process. The differential cross-section d_SD=(3.8±0.3)mb ×A ^0.35±0.02, is exponential with the slope parameter, increasing from 6.2±0.4 (GeV/c)^–2 for beryllium to 7.9±0.5 (GeV/c)^–2 for tungsten. The slope parameter also increases with increasing massM _X of the diffractively produced state. The rapidity, multiplicity, and transverse-momentum distributions of the particles of the diffractively produced stateX show a longitudinal phase-space population and are remarkably insensitive to the nuclear mass. This, together with theA ^1/3 dependence of _SD, suggests that the dominant process of nuclear diffractive excitation is the dissociation of single nucleons.Deceased     

Inductively-coupled plasma atomic emission spectroscopic determination of trace impurities in ZrO2-powder

Four independent procedures including one using slurry nebulization ICP-AES were developed for the trace analysis of ZrO₂ powders. They were evaluated with respect to detection limits, blank values, interferences, accuracy and precision. For the procedures I–III ZrO₂ powder was decomposed by fusion with a 10-fold excess of NH₄HSO₄ and subsequent dissolution of the melt in either water or, after evaporation of NH₄HSO₄, in diluted HNO₃. In procedure I the solution was directly analyzed by ICP-AES, which was optimized with the aid of a simplex algorithm. In procedure II Zr was separated by extraction from 6 mol/l HNO₃ with a 0.5 mol/l solution of 2-thenoyltrifluoroacetone (TTA) in xylene. More than 99.5% of the Zr was removed and more than 95% of the trace elements retained. In procedure III the matrix was separated by its precipitation as ZrOCl₂·8 H₂O from a (1:4) HCl-acetone medium. More than 98% of Zr were removed and more than 90% of the trace elements were retained. In procedure IV the ZrO₂ powder was dispersed by ultrasonic treatment in water acidified with HCl (pH 2) and the slurry was directly analyzed by ICP-AES using a Babington nebulizer. The optimization and the analytical features of this procedure will be described in a subsequent paper. In all procedures the calibration was performed by standard addition and matrix matching was not necessary. The detection limits varied from 0.3 g/g (Ca) to 10 g/g (Al). The standard deviations obtained were 1–10% depending on the element and its concentration in the sample. The results of the procedures for 6 commercially available fine ZrO₂ powders were found to agree for Al, Ca, Fe, Mg, Na, Ti and Y. A good agreement between the results of the procedures using matrix separation was also observed for Cu, Mn, V, but the concentrations of these elements found by methods without matrix separation were considerably higher. Except for Ca and Mg the blank values encountered were below the detection limits.On leave from Department of Analytical Chemistry, Technical University, PL-00-664 Warsaw, Poland     

Electrochemical studies and square-wave voltammetric determination of fenofibrate in pharmaceutical formulations

The electrochemical reduction of fenofibrate at a hanging mercury drop electrode (HMDE) was investigated by cyclic voltammetry, square-wave voltammetry, and chronoamperometry. Different buffer solutions were used over a wide pH range (3.0–10.0). The best definition of the analytical signals was found in borate buffer (pH 9.0)–tetrabutylammonium iodide mixture containing 12.5% (v/v) methanol at –1.2 V (versus Ag/AgCl). According to cyclic voltammetric studies, the reduction was irreversible and diffusion controlled. The diffusion coefficient was 2.38×10^–6 cm² s^–1 as determined by chronoamperometry. Under optimized conditions of square-wave voltammetry, a linear relationship was obtained between 0.146–4.96 g mL^–1 of fenofibrate with a limit of detection of 0.025 g mL^–1. Validation parameters such as sensitivity, accuracy, precision, and recovery were evaluated. The proposed method was applied to the determination of fenofibrate in pharmaceutical formulations. The results were compared with those obtained by a published high-performance liquid chromatography method. No difference was found statistically.     

Determination of plasma amitriptyline by electron-capture gas chromatography after oxidation to anthraquinone.

A selective procedure is described for the determination of amitriptyline in plasma. The method involves extraction, separation of amitriptyline from its metabolites and subsequent oxidation by ceric sulphate in 5.4 M sulphuric acid. The oxidation product, anthraquinone, is determined by means of electron-capture gas chromatography. The metabolites were separated by a column chromatographic extraction technique. The choice of oxidation reagent, optimum conditions for the oxidation, and the electron-capture properties of anthraquinone are discussed. The method can be used to determine down to 2 ng of amitriptyline in a plasma sample; the relative standard deviation at the 50-ng level was 4.0% (n = 8). The levels of amitriptyline found in a series of plasma samples are compared with those obtained by gas chromatography with use of nitrogen-specific detection; the two techniques gave coincident results.     

The first tetranuclear vanadium(V) peroxo complex: Preparation, vibrational spectra and X-ray crystal structure of K6[V4O4(O2)8(PO4)]·9H2O

The vanadium(V) peroxo phosphato complex K₇[V₄O₄(O₂)₈(PO₄)]·9H₂O has been obtained from the KVO₃---KH₂PO₄---KOH---H₂O₂---H₂O---C₂H₅OH system. The X-ray structural analysis revealed a tetranuclear anionic structure in which two dinuclear [V₂O₂(O)₂)₂(μ-η¹ : η²-O₂)₂] units are connected by the μ₄-PO₄ group.     

Microwave assisted hydrothermal synthesis of tin niobates nanosheets with high cycle stability as lithium-ion battery anodes

SnNb₂O₆ and Sn₂Nb₂O₇ nanosheets were synthetized via microwave assisted hydrothermal method, and innovatively employed as anode materials for lithium-ion battery. Compared with Sn₂Nb₂O₇ and the previously reported pure Sn-based anode materials, the SnNb₂O₆ electrode exhibited outstanding cycling performance.