Estimation of diffusion and permeability coefficients of CO2 in polymeric membranes by FTIR method

Infrared spectra of CO₂ sorbed in rubbery and glassy polymeric membranes were measured to examine the relationships between the spectroscopic data and the physical properties of the membranes. The two peaks observed in the spectra of CO₂ were attributed to the R branch and P branch of CO₂ sorbed in the membranes based on the consideration that both peaks were observed at a temperature above the glass transition temperature of the membranes. Apparent diffusion coefficients of CO₂ in the membranes were measured from the desorption kinetics of CO₂ detected by FTIR spectroscopy. The solubility coefficients of CO₂ were also estimated from absorbance spectra of CO₂ sorbed in the membranes using Lambert-Beer's rule. The permeability, solubility, and diffusion coefficients estimated by the FTIR method were found to correlate well with the coefficients obtained by conventional methods such as vacuum-pressure or sorption isotherm methods. © 1996 John Wiley & Sons, Inc.     

三甲基硅烷基丙炔与五甲基二硅烷基丙炔共聚物膜及其气体透过性

研究了三甲基硅烷基丙块与五甲基二硅烷基丙块共聚物〔poly(TMSP-co-PMDSP)〕的成膜特点。poly(TMSP-co-PMDSP)膜的气体透过系数分别为:P_(O2):4×10~3～12×10~3,P_(N2):3×10~3～8×10~3和P_(CO2):2×10~4～4×10~4barrer,气体透过稳定性低,透过行为偏离第二Fick定律,过系数下降,其中溶解系数降低的比例远大于扩散系数的增加比例,在含有凝聚性气体的环境里,膜的气体透过出现表面吸附控制的特征。     

Fe K‐Edge X‐ray Absorption Fine Structure Determination of γ‐Al2O3‐Supported Iron‐Oxide Species

The structure of FeO_x species supported on γ‐Al₂O₃ was investigated by using Fe K‐edge X‐ray absorption fine structure (XAFS) and X‐ray diffraction (XRD) measurements. The samples were prepared through the impregnation of iron nitrate on Al₂O₃ and co‐gelation of aluminum and iron sulfates. The dependence of the XRD patterns on Fe loading revealed the formation of α‐Fe₂O₃ particles at an Fe loading of above 10 wt %, whereas the formation of iron‐oxide crystals was not observed at Fe loadings of less than 9.0 wt %. The Fe K‐edge XAFS was characterized by a clear pre‐edge peak, which indicated that the Fe?O coordination structure deviates from central symmetry and that the degree of Fe?O?Fe bond formation is significantly lower than that in bulk samples at low Fe loading (<9.0 wt %). Fe K‐edge extended XAFS oscillations of the samples with low Fe loadings were explained by assuming an isolated iron‐oxide monomer on the γ‐Al₂O₃ surface.     

Simple separation of isomeric sialylated N-glycopeptides by a zwitterionic type of hydrophilic interaction chromatography

Asparagine-linked oligosaccharides (N-glycans) usually show structural heterogeneity, especially in proteins with sialylated N-glycans and, therefore, their structural analysis is still very difficult. A zwitterionic type of hydrophilic interaction chromatography column with sulfobetaine functional groups (called a ZIC-HILIC column) was applied to the separation of tryptic peptides of alpha-1-acid glycoprotein. It was demonstrated that the ZIC-HILIC separation column has a selectivity for sialylated N-glycopeptides and a high capability for separation based on the structural recognition of sialylated N-glycan isomers as well as for the previously reported neutral N-glycans and N-glycopeptides. The retention characteristics of neutral and sialylated N-glycans derivatized with 2-aminopyridine (PA N-glycans) demonstrate that the retentions of the N-glycans are based primarily on hydrophilic interaction with the water-rich liquid layer generated on the surface of the ZIC-HILIC column. In addition, the electrostatic repulsion interaction shielded with counter ions effectively tunes the separation and recognition of sialylated N-glycan isomers.     

Novel gas chromatography-mass spectrometry database for automatic identification and quantification of micropollutants

A novel gas chromatography-mass spectroscopy (GC-MS) database for identification and quantification of micropollutants in environmental and food samples is reported. GC retention times, calibration curves, and mass spectra of nearly 700 chemicals were registered in the database, and the GC retention times of registered chemicals in actual samples were predicted from the retention times of n-alkanes measured before sample analysis. Differences between predicted and actual retention times were less than 3 s, an accuracy that is nearly identical to that obtained by analysis of standard substances. After the retention times were predicted, a calibration file for the GC-MS instrument was created from the predicted retention times, calibration curves, and mass spectra of the registered chemicals. With the resulting calibration file, automated identification of all the chemicals in actual samples was possible without the use of standards, and the identification method was as reliable as conventional methods. When the GC inlet, column, and tuning conditions were adjusted using GC-MS performance check standards, relative standard deviations of 20% or less for determination values could be obtained. More than 90% of the chemicals in the database could be detected at a sensitivity sufficient for all practical purposes (100 pg or less). Because each chemical in the database, to which new substances can easily be added, can be determined in 1 h, micropollutants in samples can be analyzed efficiently and inexpensively.     

Two-dimensional hydrophilic interaction chromatography coupling anion-exchange and hydrophilic interaction columns for separation of 2-pyridylamino derivatives of neutral and sialylated N-glycans

A novel chromatographic approach coupling anion-exchange (diethylaminoethylene) and hydrophilic-interaction (amide or zwitterionic type) columns was developed for the separating of 2-pyridylamino derivatives of N-glycans (PA-N-glycans). This is a kind of on-line, two-dimensional (2D) separation approach in hydrophilic-interaction chromatography (called the 2D-HILIC method), analogous to that of coupling cation- (or anion-, or mixed ion-) exchange and reversed-phase columns in hydrophobic interaction (reversed-phase) chromatography. The efficiency of the 2D-HILIC method was tested with biantennary neutral and sialylated PA-N-glycan standards by properly combining linear gradient elutions of water-acetonitrile and spiked-salt (ammonium acetate) elutions. The retention time RSDs of all the peaks in three sequential runs of a 100 min cycle are less than 0.52%, which indicates a reasonably good repeatability of the 2D-HILIC method. Then, the method was applied to a complex mixture of PA-N-glycans from human serum proteins. It was demonstrated that the neutral PA-N-glycans and mono-, di-, tri-, and tetrasialylated PA-N-glycans are able to be eluted in turn according to the number of sialic acids in an automated (programmed) single run.     

Synthesis and light‐emitting properties of carbazole‐based copolymers bearing cyano‐substituted arylenevinylene chromophore

Two arylenevinylene compounds bearing the cyano group at α‐position ( 6 ) and β‐position ( 9 ) from the dialkoxylphenylene unit were synthesized, in which the molecular termini were functionalized with 3‐bromocarbazole. The Suzuki coupling copolymerization of these compounds with 1,4‐bis[(3′‐bromocarbazole‐9′‐yl)methylene]‐2,5‐didecyloxybenzene and 9,9‐dihexylfluorene‐2,7‐bis(boronic acid) was carried out to obtain copolymers ( cp67 and cp97 ) containing the cyano‐substituted arylenevinylene fluorophore of 7 mol %. Model compounds ( 6 ′ and 9 ′) corresponding to the arylenevinylene fluorophore were also prepared. The UV spectra of copolymers resembled that of homopolymer hp with no arylenevinylene segment in both CHCl₃ solution and thin film. The emission maxima of copolymers in CHCl₃ (394 nm) agreed with that of homopolymer indicating that the emission bands originated from the carbazole‐fluorene‐carbazole segment. The emission maximum wavelength of copolymer cp67 in thin film (477 nm) indicated fluorescence from the cyano‐substituted arylenevinylene fluorophore because of the occurrence of fluorescence resonance electron transfer. In contrast, copolymer cp97 showed fluorescence at 528 nm to suggest the formation of a new emissive species such as a charge‐transfer complex (exciplex). © 2009 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 48: 91–98, 2010     

Quantitative visualization of temperature field in non-luminous flame by flame reaction technique

Abstract  

An experimental technique for measuring a temperature field in an axisymmetric non-luminous flame is developed using the flame reaction technique combined with the inverse Abel transformation. Flame visualization is carried out using alkali metal solution of Potassium (K), which is supplied to a premixed methane/air flame in a form of spray mist. The basic principle of this technique is based on the measurement of local emission intensity distribution visualized by the flame reaction, which is a function of temperature according to the Maxwell–Boltzmann statistics of thermodynamics. The relationship between the local intensity and the temperature is obtained from the calibration study, in which the local intensity is evaluated from the line of sight intensity by the inverse Abel transformation, and the temperature is measured by thermocouple. This technique is successfully applied to the measurement of local temperature distribution in steady and flickering premixed methane/air flame. The temperature field in the flickering flame indicates that the local temperature oscillates periodically with the flickering frequency, and the highest temperature is found along the flame front and in the merging region.     

Direct monitoring of DNA cleavages catalyzed by an ATP-dependent deoxyribonuclease on a 27 MHz quartz-crystal microbalance

Kinetic studies of enzymatic DNA cleavage reactions (the enzyme binding, hydrolysis along DNA strands, and then release of the enzyme from the completely hydrolyzed ssDNA) were carried out on a 27 MHz quartz-crystal microbalance.