Synthesis of substituted carbazoles by a vinylic to aryl palladium migration involving domino C-H activation processes

Substituted carbazoles are readily prepared in good yields by the palladium-catalyzed cross-coupling of alkynes and N-(3-iodophenyl)anilines. This process proceeds by carbopalladation of the alkyne, heteroatom-directed vinylic to aryl palladium migration, and ring closure involving two consecutive C-H activation processes. The process has also been expanded to the synthesis of an indole. [Structure: see text]     

Cu-Mg/Al复合氧化物催化碳颗粒物燃烧性能的研究

恒定二价与三价阳离子比为3(nM2+/nM3+=3),采用共沉淀法制备不同Cu含量的系列水滑石前驱物, 800 ℃焙烧4 h形成复合氧化物(CuO质量百分数分别为0％、5％、10％、15％、20％、30％、40％)用作柴油车排放碳颗粒物燃烧的催化剂,并采用XRD、BET、TG-DSC、FT-IR、TPR等表征手段研究了Cu、Mg含量对材料前驱物物化性能的影响及对其衍生复合氧化物催化碳颗粒物燃烧性能的影响．结果表明,Cu、Mg含量对材料的热稳定性、比表面和催化氧化活性有显著的影响. Mg有助于提高催化剂的热稳定性; Cu含量增加,催化剂比表面下降,但比表面不是影响催化剂活性的主要因素. CuO含量为15％时,催化剂具有最好的催化活性和稳定性,碳颗粒物的起燃温度(T10)和半转化温度(T50)分别为336 ℃和409 ℃.在CuO含量≤30％时可以形成结构完整的水滑石前驱物, CuO含量为40％时出现Cu(OH)2杂相; CuO含量< 20％时,经高温焙烧可得到均匀的复合氧化物, CuO含量≥20％时出现CuO偏析． TPR结果表明焙烧温度和复合氧化物的组成决定了材料的可还原性能．     

Rheological properties of the aqueous mixtures of cationic-anionic surfactants

The rheological properties of the aqueous mixtures of cationic-anionic surfactants, both in single-phase systems and in aqueous two-phase systems, have been studied. Bizarre rheological properties —negative thixotropy, viscoelasticity and hihg viscosity of shear rate dependent at relatively low concentration — have been observed. An unusual viscosity change, that is, viscosity lowering with increasing concentration, was obtained. The negative thixotropy might be due to the existence of lamellar or sheet-like micelles, viscoelasticity might be induced by rodlike and lamellar or sheet-like micelles, the high viscosity might be a consequence of the formation of network by long rodlike micelles and the concentration-induced viscosity lowering could be interpreted in terms of the decrease of micellar dimensions with concentration.     

Structures of E. coli peptide deformylase bound to formate: insight into the preference for Fe2+ over Zn2+ as the active site metal

E. coli peptide deformylase (PDF) catalyzes the deformylation of nascent polypeptides generated during protein synthesis. While PDF was originally thought to be a zinc enzyme, subsequent studies revealed that the active site metal is iron. In an attempt to understand this unusual metal preference, high-resolution structures of Fe-, Co-, and Zn-PDF were determined in complex with its deformylation product, formate. In all three structures, the formate ion binds the metal and forms hydrogen-bonding interactions with the backbone nitrogen of Leu91, the amide side chain of Gln50, and the carboxylate side chain of Glu133. One key difference, however, is how the formate binds the metal. In Fe-PDF and Co-PDF, formate binds in a bidentate fashion, while in Zn-PDF, it binds in a monodentate fashion. Importantly, these structural results provide the first clues into the origins of PDF's metal-dependent activity differences. On the basis of these structures, we propose that the basis for the higher activity of Fe-PDF stems from the better ability of iron to bind and activate the tetrahedral transition state required for cleavage of the N-terminal formyl group.     

Determination of DNA using sodium 9,10-anthraquinone-2-sulfonate as an in situ photochemical fluorescence probe

An in situ photochemical fluorescence probe method for the determination of DNA with sodium 9,10-anthraquinone-2-sulfonate (AQS) as a photochemical fluorescence probe was developed. It was based on the conversion of AQS into an intensively fluorescent product by irradiating with UV radiation. The photochemical reaction is retarded by DNA. The determination can be carried out by measuring the fluorescence intensity at a fixed time. The calibration graph was linear in the range 0–80 ng ml⁻¹ calf thymus (CT) DNA (r = 0.9991), the limit of detection was 3.2 ng ml⁻¹ CT DNA (n = 9). The kinetic behaviour of the photochemical reaction and the effects of experimental conditions were investigated and discussed in detail. The results of absorption spectra and competitive binding experiments suggested the interaction between AQS and DNA to be intercalative.     

Aggregation of sodium 1-(n-alkyl)naphthalene-4-sulfonates in aqueous solution: micellization and microenvironment characteristics

In aqueous solution, the micellization and microenvironment characteristics of the micelle assemblies of three anionic surfactants, sodium 1-(n-alkyl)naphthalene-4-sulfonates (SANS), have been investigated by steady-state fluorescence and time-resolved fluorescence decay techniques using pyrene, Ru(bpy)3(2+), and 1,6-diphenyl-1,3,5-hexatriene as fluorescence probes. The critical micelle concentrations (cmc's), effective carbon atom numbers (neff's), hydrophilic-lipophilic balances (HLBs), mean micelle aggregation numbers, micropolarities, and microviscosities of these surfactant micelles have been determined. The logarithmic cmc of the alkylnaphthalene sulfonates decreases linearly with an increase in the neff. The logarithmic aggregation number of the alkylnaphthalene sulfonates increases linearly with an increase in the neff. However, in contrast to the alkylsufonates and the alkylbenzene sulfonates, the aggregation for these alkylnaphthalene sulfonate molecules is less sensitive to the increase in the neff. The micropolarity of these alkylnaphthalene sulfonate micelles is less sensitive to the increase in the alkyl chain length and is lower than that of sodium dodecyl sulfate (SDS). The microviscosity of these alkylnaphthalene sulfonate micelles increases with an increase in the alkyl chain length and is lower than those of nonionic surfactants and zwitterionic surfactants. These results suggest that naphthyl rings have a notable effect on the micellization of SANS.     

Trypsin activity assay in substrate-specific one- and two-dimensional gels: a powerful method to separate and characterize novel proteases in active form in biological samples

To separate and identify the proteases, a substrate-specific, sensitive assay in sodium dodecyl sulfate (SDS)-polyacrylamide gels after two-dimensional (2-D) electrophoresis has been developed. This method allows simultaneous determination of protease cleavage specificity, molecular weight, isoelectric point, and if necessary, amino acid sequencing. After isoelectric focusing in immobilized pH gradient (IPG) strips (pH 6-11) (first dimension), trypsin was electrophoresed in 12% SDS polyacrylamide gels (second dimension) copolymerized with Boc-Gln-Ala-Arg-MCA (4-methyl-coumaryl-7-amide). The gels were washed in cold 2.5% Triton X-100 and water, and incubated in assay buffer (6.3 mM Bicine, 100 mM NaCl). Trypsin cleavage of the peptide-MCA generated fluorescent 7-amino-4-methyl-coumarin. In 1-D gels, as low as 500 pg trypsin could be detected and trypsin band volumes correlated linearly with the amounts of trypsin (R(2) = 0.999). In 2-D gels, the lowest amount of trypsin detected was 1 ng. The linear regression of spot volume and loading amount was still good (R(2) = 0.974). To optimize renaturation conditions, 5x5 min washes with 2.5% Triton X-100 and water, respectively, gave the strongest band volume. For fluorescence development, an assay buffer at pH 9 was the best; incubation at 37 degrees C for 30 min was sufficient. The method has application for identifying novel proteases as it does not rely on antibodies.     

Paradigms and paradoxes: patterns and estimation of the entropy of formation of aqueous hydrogen containing mono and polynuclear oxyanions

“Simple” energetic patterns, where simple means the use of parameters derived only from the stoichiometry of these species, are relatively rarely discussed in the literature. In addition, entropy studies have been dominated by derivation of the absolute quantity S° rather than the entropy of formation (TΔ_f S ^o). Relationships between the entropy of formation and different parameters such as negative value of the charge of the species, the number of oxygen atoms, the natural logarithm of the molecular weight, the total number of atoms and the number of central atoms that are gases were recently discussed by us for aqueous polynuclear oxyanions. As shown here hydrogen containing anions do not follow this pattern. In this study, new approaches for the estimation of the entropy of formation of aqueous hydrogen containing mono and polynuclear oxyanions are suggested, evaluated and recommended.     

An Education in Robustness

A case study is presented of the application of robustness analysis to the choice of examination subjects to be made by a 14-year-old girl. The analysis is conducted in terms of the desirable future career options which may be preserved by different combinations of subjects, and also of the balance with topics selected for their intrinsic interest. The approach, which employs very limited technical apparatus, is justified on a number of grounds-in particular, the crucial importance of uncertainty, and the need for understanding and acceptance by a "client" very unlike the corporate manager. Some tentative conclusions are reached on the extension of such methods to other cases of decision-makers with little, if any, resources to control except their own lives.     

Atomic radical—molecule reactions F + CH<Subscript>3</Subscript>C≡CH: mechanistic study

The reaction of atomic radical F with propyne has been studied theoretically using ab initio quantum chemistry methods and transition state theory. The potential energy surface was calculated at the CCSD(T)/aug-cc-pVDZ (single-point) level using the UMP2/6-311++G(d,p) optimized structures. Two reaction mechanisms including the addition–isomerization–elimination reaction mechanism and the directed hydrogen abstraction reaction mechanism are considered. For the hydrogen abstraction reactions, i.e., the most probable evolution pathway in the title reaction, the HF formation occurs via direct abstraction mechanism dominantly and the H atom picked up by the atomic radical F should come mostly from the methyl group of normal propyne. On the other hand, for the addition–isomerization–elimination mechanism, the most feasible pathway should be the atomic radical F attacking on the C≡C triple bond in propyne (CH₃C≡CH) to form a weakly-bound adduct A1 with no barrier, followed by F addition to the C≡C triple bond to form the low-lying intermediate isomer 5. Subsequently, isomer 5 directly dissociates to P3 H₂CCCHF + H via transition state TS₅/P3. The other reaction pathways on the doublet PES are less competitive due to thermodynamical or kinetic factors. Furthermore, based on the analysis of the kinetics of all channels through which the addition and abstraction reaction proceed, we expect that the competitive power of reaction channels may vary with experimental conditions for the title reaction. The present work will provide useful information for understanding the processes of atomic radical F reaction with other unsaturated hydrocarbons. This material is available from author via E-mail.