Uranium recovery from UCF liquid waste by nanoporous MCM-41: breakthrough capacity and elution behavior studies

Adsorption and recovery of uranium by nanoporous MCM-41 from aqueous solutions (synthetic solution and uranium conversion facility liquid waste) were investigated by use of a fixed-bed column (1.2 cm diameter and 3.0 cm height). Adsorption was carried out at flow rates 0.2 and 0.5 mL min^?1, which correspond to retention times of 10 and 6 min. The maximum breakthrough capacity for uranium ions was achieved by use of nanoporous MCM-41 at the optimum pH of 3.6 and flow rate 0.2 mL min^?1 (61.95 μg g^?1). The Thomas and Yan models were applied to the experimental data, by use of linear regression, to determine the characteristics of the column for process design. The breakthrough curves calculated from the models were in good agreement with the experimental data. The elution behavior of uranium on nanoporous MCM-41 was studied with different eluents; the results showed that 0.1 M HCl is good eluent for uranium recovery. The regenerated column could be used in a multitude of adsorption–desorption cycles.     

Rational synthesis of Pt spheres with hollow interior and nanosponge shell using silica particles as template

Here we report a facile and efficient method to prepare Pt spheres with hollow interior and nanosponge shell with high surface area. Such a unique Pt nanostructure can effectively improve the electrocatalytic performance of Pt catalysts by facilitating the access of electroactive species to the full-extent Pt surface.     

Application of Sol–Gel Based Poly(ethylene glycol)/Multiwalled Carbon Nanotubes Coated Fiber for SPME of Methyl tert-Butyl Ether in Environmental Water Samples

In this research, the sol–gel technology was applied for the preparation of solid-phase microextraction fibers for extracting of methyl tert-butyl ether (MTBE) from environmental water samples. For this purpose, two different polymers such as poly(ethylene glycol) (PEG) and combination of PEG and multiwall carbon nanotubes (MWCNTs) were prepared using sol–gel technology as coating procedure for the fibers. The pre-concentration process followed by GC–FID determination was used and the results evidenced that pre-concentration factor for PEG/CNTs fiber was approximately five times higher than PEG. Parameters affecting the extraction efficiency such as temperature, extraction time, stirring speed and salt effect for each fiber were investigated and optimized. On the optimal conditions, the linear range for MTBE with PEG and PEG/CNT fibers were 10–3,000 and 1–1,000 ng mL^?1 and the detection limits (S/N = 3) were 1.0 and 0.3 ng mL^?1, respectively. The sol–gel PEG/CNTs fiber has good performance and therefore relatively better figures of merit and experimental results such as thermal stability (up to 320 °C), average of life time (over 150 times) and repeatability (RSD < 4) in comparison to conventional PDMS/Carboxen fiber, which was already reported for determination of MTBE.     

New Insights into Sulfur Deposition on Gold Using Dithiobisphthalimide as a New Precursor

Dithiobisphthalimide is used as a new precursor for the spontaneous deposition of sulfur on gold surfaces in acetonitrile. Characterization of the modified surfaces is achieved using X‐ray photoelectron spectroscopy (XPS), electrochemistry and scanning tunneling microscopy (STM). The reported results indicate that the sulfur deposition is an efficient and fast process and that high coverages can be reached very quickly. Sequential high‐resolution STM in air allows the direct observation, for the first time, of the mobility of the usually observed rectangular structures as individual units. It also shows the reversible association/dissociation of these rectangles. The nature of these structures is highly debated in the literature and the present work provides new insights into their nature through the use of a new sulfur precursor under non‐traditional conditions. To explain our results we consider these structures as simple sulfur adlayers on the gold surface.     

Stemmosides C and D, two novel unusual pregnane glycosides from Solenostemma argel: structural elucidation and configurational study by a combined NMR-quantum mechanical strategy

Stemmosides C and D, two novel pregnane glycosides characterized by an unusual C-17 side chain were isolated from the pericarps of Solenostemma argel. In addition, stemmoside D displays an uncommon 14β proton configuration, apparently being the first pregnane isolated from plants known to have a 15 keto, cis CD ring junction. Their structures have been established by ESIMS and NMR experiments. The relative configuration of the molecules was determined using a strategy based on the simulation of ¹H, ¹³C, and J coupling NMR parameters. DFT calculations of ¹H and ¹³C chemical shifts, and of the ¹H homonuclear spin–spin coupling constants were performed with the mPW1PW91 functional using the 6-31G(d,p) basis set on the fully optimized geometries of all the possible stereoisomers.     

A Deadly Organometallic Luminescent Probe: Anticancer Activity of a ReI Bisquinoline Complex

The photophysical properties of [Re(CO)₃(L ‐N₃)]Br (L ‐N₃=2‐azido‐N,N‐bis[(quinolin‐2‐yl)methyl]ethanamine), which could not be localized in cancer cells by fluorescence microscopy, have been revisited in order to evaluate its use as a luminescent probe in a biological environment. The Re^I complex displays concentration‐dependent residual fluorescence besides the expected phosphorescence, and the nature of the emitting excited states have been evaluated by DFT and time‐dependent (TD) DFT methods. The results show that fluorescence occurs from a ¹LC/MLCT state, whereas phosphorescence mainly stems from a ³LC state, in contrast to previous assignments. We found that our luminescent probe, [Re(CO)₃(L ‐N₃)]Br, exhibits an interesting cytotoxic activity in the low micromolar range in various cancer cell lines. Several biochemical assays were performed to unveil the cytotoxic mechanism of the organometallic Re^I bisquinoline complex. [Re(CO)₃(L ‐N₃)]Br was found to be stable in human plasma indicating that [Re(CO)₃(L ‐N₃)]Br itself and not a decomposition product is responsible for the observed cytotoxicity. Addition of [Re(CO)₃(L ‐N₃)]Br to MCF‐7 breast cancer cells grown on a biosensor chip micro‐bioreactor immediately led to reduced cellular respiration and increased glycolysis, indicating a large shift in cellular metabolism and inhibition of mitochondrial activity. Further analysis of respiration of isolated mitochondria clearly showed that mitochondrial respiratory activity was a direct target of [Re(CO)₃(L ‐N₃)]Br and involved two modes of action, namely increased respiration at lower concentrations, potentially through increased proton transport through the inner mitochondrial membrane, and efficient blocking of respiration at higher concentrations. Thus, we believe that the direct targeting of mitochondria in cells by [Re(CO)₃(L ‐N₃)]Br is responsible for the anticancer activity.