Measurement of small-signal and large-signal responses of packaged laser modules at high temperature

In this paper, the pulsed injection method is extended to measure the chip temperature of various packaged laser modules, such as the DFB laser modules, the FP laser modules, and the EML laser modules. An optimal injection condition is obtained by investigating the dependence of the lasing wavelength on the width and period of the injection pulse in a relatively wide temperature range. The small-signal frequency responses and large-signal performances of packaged laser modules at different chip temperature are measured. The adiabatic small-signal modulation characteristics of packaged LD are first extracted. In the large-signal measurement, the effects of chip temperature, bias current and driving signal on the performances of the laser modules are discussed. It has been found that the large-signal performances of the EML modules depend on the different red-shift speeds of the DFB and EAM sections as chip temperature varying, and the optimal characteristics may be achieved at higher temperature.     

合成1，3－二（3－羟丙基）四甲基二硅氧烷的新方法

用二乙氧基二甲基硅烷与３－氯丙醇反应，合成了新化合物３－氯丙氧基乙氧基二甲基硅烷，然后用格氏反应代替Ｗａｌｔｅｒ的钠缩合反应，最后经水解制备了１，３－二（３－羟丙基）四甲基二硅氧烷，总收率为４２．０％。     

Synthesis of polypiperazine-amide thin-film membrane on PPESK hollow fiber UF membrane

A new interfacial polymerization (IP) procedure is developed in order to synthesize polypiperazine-amide thin-film membrane on the inner surface of poly(phthalazinone ether sulfone ketone) (PPESK) hollow fiber ultrafiltration (UF) membrane.A hollow fiber composite membrane with good performance was prepared and studied by FT-IR and scanning electron microscopy.     

胍类化合物的合成进展

胍类化合物是精氨酸残体的一部分，它在具有生物活性的蛋白质、肽中起着重要作用，从天然产物分离得到的胍类化合物大部分具有生理活性，如抗病毒、抗肿瘤、抗艾滋病等。所以，在温和条件下高产率的合成胍类化合物显得非常重要。本文综述了胍类化合物的合成进展。参考文献32篇。     

2-（2＇-羟基-3’-甲氧基苯基）-5，6-二硝基苯并咪唑的阴离子识别

设计并合成了2-（2’-羟基-3’-甲氧基苯基）-5，6-二硝基苯并咪唑化合物（1），通过X射线单晶衍射研究了该化合物的固态结构．利用紫外-可见光谱技术研究了其对阴离子的识别，发现化合物1能够在DMSO中对AcO^-，H2PO4^-，OH^-的3种离子进行有效识别，同时溶液由原来的黄色变成红色，实现裸眼检测．     

Dynamic Study of Gemini Surfactant and Single-chain Surfactant at Air／Water Interface

Molecular dynamics (MD) simulation are used to study the properties of gemini surfactant of ethyl-α,ω-bis(dodecyldimethylammonium bromide) (C12C2C12) and dodecyl-trimethylammonium bromide (DTAB) at the air/water interface, respectively. In the two systems,t he surfactant concentrations are both 28 wt.%, and other conditions are also the same. After reaching the thermodynamic equilibrium, the concentration profiles, the radial distributions functions (RDF) and the mean squared displacement (MSD) are investigated. The results reveal that the surface activity of C12C2C12 surfactant is higher than DTAB surfactant.     

A New Asterosaponin from the Starfish Culcita novaeguineae

A new asterosaponin named novaeguinoside A, along with a known saponin, asteronyl pentaglycoside sulfate, was isolated from the starfish Culcita novaeguineae. The new compound was identitied to be sodium 6α-O-{β-D-fucopyranosyl-(1→2)-β-D-fucopyranosyl-(1→4)-[β-D-quinovopyranosyl-(1→2)]-β-D-xylopyranosyl-(1→3)-[β-D-quinovopyranosyl}-5α-pregn-9(11)-en-20-one-3β-yl-sulfate by extensive spectral analysis and chemical evidence.     

Alkaloids from stems of Ervatamia yunnanensis

Six indole alkaloids were isolated from the stems of Ervatamia yunnanensis. Among them, yunnanensine (I) is new. The other five are known alkaloids, namely: 19,20-E-vallesamine (II), 19s-heyneanine (HI), ibogaine (IV), ibogamine (V), coronaridine (VI). The structural elucidation of the alkaloids was based on spectral means.     

Theoretical studies of mechanisms of cycloaddition reaction between difluoromethylene carbene and acetone

Mechanisms of the cycloaddition reaction between singlet difluoromethylene carbene and acetone have been investigated with the second‐order Møller–Plesset (MP2)/6‐31G* method, including geometry optimization and vibrational analysis. Energies for the involved stationary points on the potential energy surface (PES) are corrected by zero‐point energy (ZPE) and CCSD(T)/6‐31G* single‐point calculations. From the PES obtained with the CCSD(T)//MP2/6‐31G* method for the cycloaddition reaction between singlet difluoromethylene carbene and acetone, it can be predicted that path B of reactions 2 and 3 should be two competitive leading channels of the cycloaddition reaction between difluoromethylene carbene and acetone. The former consists of two steps: (i) the two reactants first form a four‐membered ring intermediate, INT2, which is a barrier‐free exothermic reaction of 97.8 kJ/mol; (ii) the intermediate INT2 isomerizes to a four‐membered product P_2b via a transition state TS2b with an energy barrier of 24.9 kJ/mol, which results from the methyl group transfer. The latter proceeds in three steps: (i) the two reactants first form an intermediate, INT1c, through a barrier‐free exothermic reaction of 199.4 kJ/mol; (ii) the intermediate INT1c further reacts with acetone to form a polycyclic intermediate, INT3, which is also a barrier‐free exothermic reaction of 27.4 kJ/mol; and (iii) INT3 isomerizes to a polycyclic product P₃ via a transition state TS3 with an energy barrier of 25.8 kJ/mol. © 2006 Wiley Periodicals, Inc. Int J Quantum Chem, 2007