Irradiation Test of FPGA for BES-Ⅲ

The irradiation effect of FPGA, applied in Front-end Electronics for experiments of High-Energy Physics, is a serious problem. The performance of FPGA, used in the front-end card of Muon Counters of BES-III project, needs to be evaluated under irradiation. SEUs on Altera ACEX 1K FPGA, observed in the experiment under the irradiation of γ ray, 14 and 2.5MeV neutrons, was investigated. We calculated involved cross-section and provided reasonable analysis and evaluation for the result of the experiment. The conclusion about feasibility of applying ACEX 1K FPGA in the front-end card of the readout system of Muon Counters for BES-III was given.     

Three-Party Quantum State Sharing of an Arbitrary Unknown Two-Qubit State Based on Entanglement Swapping and Bell-State Measurements

We propose a scheme for sharing an arbitrary unknown two-qubit state among three parties by using a four-qubit cluster-class state and a Bell state as a quantum channel. With a quantum controlled phase gate (QCPG) operation and a local unitaryoperation, any one of the two agents has the access to reconstruct the original state if he/she collaborates with the other one, whilst individual agent obtains no information. As all quantum resource can be used to carry the useful information, the intrinsic efficiency of qubits approaches the maximal value. Moreover, the present scheme is more feasible with present-day technique.     

基于Marangoni界面效应的数控化学抛光去除函数的研究

 利用基于Marangoni界面效应对化学抛光去除函数的理论及实验进行研究,提出采用湿法化学抛光（刻蚀）方法为大口径高精度光学元件的加工提供新的解决途径。介绍了Marangoni界面效应及其验证实验,运用WYKO轮廓仪对熔石英基片局域刻蚀前后的粗糙度进行检测,结果表明,粗糙度基本无变化,刻蚀前后粗糙度分别为0.72 nm和0.71 nm。基于Preston假设, 建立了数控化学抛光理论模型,运用WYKO干涉仪观察实验现象可知,化学抛光刻蚀曲线基本上成平底陡峭的去除函数曲线,小磨头抛光是倒置的仿高斯函数曲线。     

质量非均匀分布的烟囱在倾倒过程中的力学分析

烟囱倒塌的过程中可能会在某处断裂.本文研究了质量非均匀的烟囱倾倒过程中各部位的受力与扭矩,并通过扭矩极大值点找出烟囱断裂位置.     

F8BT：P3HT共混薄膜的放大自发辐射

研究了聚合物poly（9,9-dioctylfluorene-co-benzothiadiazole）（F8BT）和poly （3-hexylthiophene）（P3HT）共混薄膜的放大自发辐射（ASE）现象,对影响其阈值的两个因素--增益和损耗进行了详细的研究。结果显示,共混聚合物的发光效率随着P3HT所占比例的增加有所降低。当P3HT比例低于20%时,发光效率降低不多,而其损耗则随着P3HT的增加显著减小。F8BT和P3HT混合后,光损耗系数从7.8 cm^-1下降到4 cm^-1左右。这表明F8BT：P3HT共混聚合物光波导的ASE阈值降低主要是由于其损耗的降低而导致的。ASE阈值的降低预示该材料体系容易实现电泵浦激光。     

适用于非常规工作环境中热释电型激光能量计的研制

现有的激光能量计传感器灵敏度系数都与其所处环境温度有关,在-50℃～70℃的温度范围内,灵敏度偏差较大,直接影响测量结果。为了达到消除环境温度的影响,采取在不同环境温度下对热释型能量计的灵敏度进行校准的研究方法。该校准方法与普通激光能量计的校准方法的不同之处在于对热释电型能量计进行校准时,温度由室温扩展到-50℃～70℃的温度范围。利用环境试验箱,每隔10℃固定一个温度点,进行激光能量的测量实验,得到各个温度点所对应的灵敏度修正系数,再借助最小二乘法建立起各个温度点上能量计灵敏度系数同环境温度的函数关系,从而实现了-50℃～70℃的温度范围内激光能量的准确计量。研制能直接工作于非常规工作环境下的热释电型激光能量计,对解决激光能量测量的外场需求有一定现实意义。     

基于SOI的亚波长偏振分束器的研究

运用严格耦合波理论对亚波长光栅的模场分布进行讨论,通过位相匹配方程建立衍射级、光栅矢量和波导传输常数的关系,得到波导光栅实现偏振分束功能时对应的设计参数;针对布拉格反射层良好的反射特性,设计了一种亚波长偏振分束器。为了提高光栅的耦合效率,在基底增加Bragg反射层,将传统偏振分束器的透射光反射,与输入光相干叠加,满足相位匹配条件后耦合输出,使耦合效率大大增加。     

Capacitance of Organic Schottky Diodes Based on Copper Phthalocyanine （CuPc）

The capacitance of an organic Schottky diode based on copper phthalocyanine （CuPc） is investigated. Based on the organic small-signal equivalent model established, we calculate the reverse capacitance CMetal Of the organic Schottky diode with different kinds of metal cathodes （Mg, Al, Au）. It is found that the reverse capacitance of the organic Schottky diode shows behavior as CMg 〉 CAl 〉 CAu at the same frequency, and according to our analysis, the reverse Schottky junction capacitance Cj is expected to have little effect on the reverse capacitance of the organic Schottky diode, and the space-charge limited current capacitance Us is considered to dominate the reverse capacitance, which limits the improvement of frequency characteristics of organic Schottky diodes.     

Tune optimization of the third generation light source storage ring based on Frequency Map Analysis

Tune optimization is necessary to optimize the nonlinearity of the third generation light source storage ring. In this paper we summarize the common strategies for choosing a tune and discuss tune op-timization. Frequency Map Analysis (FMA) is applied as a tune scanning tool to reveal information about nonlinear resonances and guide the tune optimization. The Shanghai Synchrotron Radiation Facility (SSRF) storage ring is taken as a test lattice, and the optimum solutions are presented in this paper. Moreover, the third order regular structural resonances excited by sextupoles are particularly investigated, and it is found that these resonances distort the tune shifts with amplitude and show a stop-band like the linear structural resonances.     

Improved nonlinear optimization in the storage ring of the modern synchrotron radiation light source

In the storage ring of the third generation light sources, nonlinear optimization is an indispensable course in order to obtain ample dynamic acceptances and to reach high injection efficiency and long beam lifetime, especially in a low emittance lattice. An improved optimization algorithm based on the single resonance approach, which takes relative weight and initial Harmonic Sextupole Integral Strength （HSIS） as search variables, is discussed in this paper. Applications of the improved method in several test lattices are presented. Detailed analysis of the storage ring of the Shanghai Synchrotron Radiation Facility （SSRF） is particularly emphasized. Furthermore, cancellation of the driving terms is investigated to reveal the physical mechanism of the harmonic sextupole compensation. Sensitivity to the weight and the initial HSIS as well as dependence of the optimum solution on the convergent factor is analyzed.