Surface friction of hydrogels with well-defined polyelectrolyte brushes

Hydrogels of poly(2-hydroxyethyl methacrylate) (PHEMA) with well-defined polyelectrolyte brushes of poly(sodium 4-styrenesulfonate) (PNaSS) of various molecular weights were synthesized, keeping the distance between the polymer brushes constant at ca. 20 nm. The effect of polyelectrolyte brush length on the sliding friction against a glass plate, an electrorepulsive solid substrate, was investigated in water in a velocity range of 7.5 x 10(-5) to 7.5 x 10(-2) m/s. It is found that the presence of polymer brush can dramatically reduce the friction when the polymer brushes are short. With an increase in the length of the polymer brush, this drag reduction effect only works at a low sliding velocity, and the gel with long polymer brushes even shows a higher friction than that of a normal network gel at a high sliding velocity. The strong polymer length and sliding velocity dependence indicate a dynamic mechanism of the polymer brush effect.     

The Synthesis of Gracillin and Dioscin：TWO Typical Representatives of Spirostanol Glycosides

Two spirostanol saponins(gracillin and dioscin)which have the typical sugar moieties were synthesized facilely by a general approach.     

Static ultrasonic oscillations induced degradation and its effect on the linear rheological behavior of novel propylene based plastomer melts

The ultrasonic degradation of novel propylene based plastomer (DP) melts with different melt viscosities was conducted in a “static” ultrasonic device where the samples were taken from various distances from the tip of an ultrasonic probe. The effects of ultrasonic time, oscillation temperature, ultrasonic intensity and the distance from the ultrasonic probe tip on the degradation behavior of DP melts as well as the ultrasonic degradation effect on the linear rheological behavior of DP melts were studied. The results show that the increase of initial melt viscosity of DP (higher molecular weight) has greater impact on the ultrasonic degradation of DP melt. The molecular weight and intrinsic viscosity of DP decrease with the increase of ultrasonic oscillation time and they approach to a limiting value. The molecular weight distribution of DP increases after ultrasonic degradation. Decreasing oscillation temperature and distance from probe tip and increasing ultrasonic intensity lead to an increase in the degradation of DP melt. The linear rheological behavior measurements of the samples obtained near the ultrasonic probe tip show that ultrasonic oscillations decrease the complex viscosity, zero shear viscosity, viscoelastic moduli, cross modulus, relaxation time and the slope of log G′ − log G″ for DP melts.     

New Nitrogenous Bisabolene‐Type Sesquiterpenes from a Hainan Sponge Axinyssa aff. variabilis

Two new uncommon nitrogenous sesquiterpenes, 11‐ethoxy‐3‐formamidotheonellin ( 1 ) and 7‐ethoxy‐3‐formamidobisabolane‐8,10‐diene ( 2 ), together with two known related sesquiterpenes, 3‐formamidotheonellin (=theonellin formamide; 3 ) and theonellin isothiocyanate ( 4 ), were isolated from the Hainan sponge Axinyssa aff. variabilis. Their structures were determined on the basis of extensive spectroscopic analysis and by comparison of their NMR data with those of known compounds.     

Sesquiterpenoids and Phenylpropane Derivatives from Sonchus uliginosus

Six new compounds were isolated from the whole plant of Sonchus uliginosus, including three eudesmane‐type sesquiterpenoids (1β,6α)‐1,6,14‐trihydroxyeudesm‐3‐en‐12‐oic acid γ‐lactone ( 1 ), (1β,6α)‐1,6,14‐trihydroxyeudesma‐3,11(13)‐dien‐12‐oic acid γ‐lactone ( 2 ), and (1β,6α)‐1,6‐dihydroxy‐14‐O‐[(4‐hydroxyphenyl)acetyl]eudesma‐3,11(13)‐dien‐12‐oic acid γ‐lactone ( 3 ), and three phenylpropane derivatives, 4‐hydroxy‐γ,3,5‐trimethoxybenzenepropanol ( 6 ), γ,3,4,5‐tetramethoxybenzenepropanol ( 7 ), and γ,3,4,5‐tetramethoxybenzenepropanol acetate ( 8 ), together with the two known compounds 4 and 5 . The new structures were elucidated by means of spectroscopic methods, such as IR, EI‐MS, HR‐ESI‐MS, 1D‐ and 2D‐NMR, and by comparison of the spectroscopic data with those reported for structurally related compounds.     

火焰原子吸收光谱法测定茶叶中的锰

介绍悬浮液进样-次灵敏线火焰原子吸收光谱法测定茶叶中的锰的方法。以琼脂为悬浮剂，将茶叶样品均匀、稳定地悬浮于琼脂溶胶中，直接喷入空气-乙炔火焰中，利用锰280.1nm次灵敏线，以工作曲线或标准加入法测定锰的含量，方法简便、快速，用于测定茶叶和桃叶样品中的锰，结果准确。     

肾上腺素在脱氧核糖核酸修饰金电极上的电化学行为及铅离子的影响

用干燥／吸附法制备了脱氧核糖核酸(DNA)修饰金电极(DNA／Au)，采用循环伏安法、计时库仑法、微分脉冲伏安法、交流阻抗以及紫外光谱法研究了肾上腺素(EP)在该电极上的伏安行为及Pb^2 产生的影响。结果表明：在5mmol/L pH7．7Tris底液中，EP在DNA／Au上产生一不可逆的氧化峰(Ep＝0．16V)。该峰较EP在裸金电极上的峰(Ep＝0．11V)电位为正，灵敏度高。在有Pb^2 存在时，峰电位负移，峰高增大。微分脉冲峰高与EP浓度在0．5-75μmol/L范围内呈线性关系。氧化峰为扩散控制为主并兼有弱的吸附性。本文还探讨了其电极反应的机理，认为在无Pb^2 的情况下，EP与DNA的结合是EP嵌入DNA中为主并兼有一定程度的静电吸附。有Pb^2 存在的情况下EP是以EP-Pb^2 嵌入DNA的双螺旋结构中和通过静电吸附在DNA骨架上的Pb^2 为桥梁与DNA结合。     

Time-dependent density functional theory calculations of the photoabsorption of fluorinated alkanes

Time-dependent density functional theory (TD-DFT) calculations of the transition energies and oscillator strengths of fluorinated alkanes have been performed. The TD-DFT method with the non-local B3LYP potential yields transition energies for the methanes, which are smaller by about 10% as compared to the experimental values. An empirical linear correlation was found between the calculated and experimental transition energies both at the B3LYP/DZ+Ryd(C, F) and B3LYP/cc-pVTZ+Ryd(C, F, H) levels for a total of 19 transitions of the fluorinated methanes with linear correlation coefficients of 0.987 for the former and 0.988 for the latter. This empirical correlation for fluorinated methane molecules is found to agree well with the previously obtained empirical correlations between calculated and experimental values for non-fluorinated molecules. The results show that a single empirical-correlation relationship can be used for both non-fluorinated and fluorinated molecules to predict transition energies. This linear relationship is then used to predict the photoabsorption spectra of ethane, propane, butane, and partially and fully fluorinated derivatives. A key result of these calculations is the dominance of Rydberg transitions in the spectral region of interest.     

Controlled ring‐opening polymerization of propylene oxide catalyzed by double metal‐cyanide complex

A double metal‐cyanide catalyst based on Zn₃[Co(CN)₆]₂ was prepared. This catalyst is very effective for the ring‐opening polymerization of propylene oxide. Polyether polyols of moderate molecular weight having low unsaturation (<0.015 meq/g) can be prepared under mild conditions. The molecular weight of polymer is entirely controlled by a reacted monomer‐to‐initiator ratio. The polymers prepared with stepwise addition of monomer exhibit a narrower molecular weight distribution as compared with those prepared with one‐step addition of monomer. Various compounds containing active hydrogen, except basic compounds and low‐carbon carboxylic acid, may be used as initiators. The reaction rate increases with increasing catalyst amount and decreases with rising initiator concentration. Polymerization involves a rapid exchange reaction between the active species and the dormant species. It was also proven that, to a certain extent, the chain termination of this catalytic system is reversible or temporary. ¹³C NMR analysis showed that the polymer has a random distribution of the configurational sequences and head‐to‐tail regiosequence. It is assumed that the polymerization proceeds via a cationic coordination mechanism. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 1142–1150, 2002     

Sorption of Th(IV) ions onto TiO2: Effects of contact time, ionic strength, thorium concentration and phosphate

Summary The sorption of Th(IV) onto TiO₂ was studied by the batch technique as a function of pH and ionic strength at moderate concentration (10^-4-10^-5 mol/l) and in the presence and absence of phosphate. It was found that the sorption rate of Th(IV) was relatively slow, the sorption percent was abruptly increased from pH 2 to 4, and the sorption was decreased with increasing ionic strength as a whole. In the concentration range of Th(IV) from trace concentration to 1.4 ^. 10^-4 mol/l and in the absence of phosphate, the sorption isotherms were roughly fitted the Freundlich equation at different ionic strengths and approximately constant pH. These sorption characteristics of Th(IV) onto TiO₂ were compared with those of uranyl on the same sorbent. In addition, the positive effect of phosphate on the sorption of Th(IV) onto TiO₂ was demonstrated obviously and can be attributed to strong surface binding of phosphate, and the subsequent formation of ternary surface complexes of Th(IV). The difference between the sorption characteristics of Th(IV) ions and uranyl ions onto TiO₂ is discussed.