Superhydrophobic Flexible Supercapacitors Formed by Integrating Hydrogel with Functional Carbon Nanomaterials

Main observation and conclusion With the rapid development of the wearable electronics,the flexible supercapacitor with high energy density has attracted more a...     

高温吸热管内超临界CO2传热特性的数值模拟

研究超临界CO2在高温吸热管内的传热特性是将其应用于聚光太阳能热发电技术中的基础.本文对此进行了数值模拟研究,分析了流体温度、流动方向、系统压力、质量流率和热流密度对对流传热系数和Nu数的影响.结果表明:高温区(800—1050 K)的对流传热系数和Nu数受流动方向和系统压力的影响均很小,但都随着质量流率的增大以及热流...     

微腔内气体抽离的多尺度模拟与分析

基于适用于整个克努森数范围的流动理论,建立了去除惯性约束聚变实验中靶丸内空气的理论模型,并设计实验验证了此模型的可靠性。物理实验要求靶丸内空气浓度低于10×10⁻⁶,数值模拟了去除靶丸内空气的过程,重点分析了靶丸内空气浓度、压力与除气时间的关系。计算并比较了单管路一次抽气法、单管路循环抽气法与双管路流洗法三种去除靶丸内空气方法的时间成本。数值计算结果表明：单管路一次抽气法中,靶丸上的微通道的存在对去除靶丸内空气所需时间的影响不可忽略,在考虑靶丸上微通道与充气管的情况下,需要1961.77 h才能使靶丸内的空气浓度达到标准。单管路循环抽气法中,抽气次数与单次抽气程度会影响去除靶丸内空气所需总时间,在单次抽气程度值取最优的情况下,采用充三次,抽四次的方案可使达标总时间减少至1 h左右,此方案下单次充气和抽气时间分别为6 min和10 min。而采用双管路流洗法则仅需11 min便可使靶丸内空气浓度达标。     

A proposal for preparation of cluster states with linear optics

Measurement-based quantum computation in an optical setup shows great promise towards the implementation oflarge-scale quantum computation. The difficulty of measurement-based quantum computation lies in the preparation ofcluster state. In this paper, we propose the method of generating the large-scale cluster state, which is a platform formeasurement-based quantum computation. In order to achieve more complex quantum circuits, the preparation protocolof N-photon cluster state will be proposed as a generalization of the preparation of four- and five-photon cluster states.Furthermore, our proposal is experimentally feasible.     

钼、硼浸种对大豆幼苗生理特性的影响

以浙春3号大豆为研究材料，设置了不同的钼、硼浸种对大豆种子的萌发和幼苗生理特性的影响，结果表明：低浓度钼或硼有利于大豆种子的萌发，钼、硼浸种时间以12h最佳，钼浸种或不过量硼浸种将增大豆幼苗的呼吸速率，提高过氧化物酶（POD）、过氧化氢酶（CAT）和超氧化岐化酶（SOD）等抗逆性酶的活性，降低质膜透性（MP）及丙二醛（MDA）和脯氨酸（Pro)的含量，中等浓度的钼、硼浸种效果最显著，而高浓度浸种将产生相反的效果。     

Power dissipation characteristics of great power and super high speed semiconductor switch

The power dissipation characteristics of pulsed power switch reversely switched dynistors （RSDs） are investigated in this paper. According to the expressions of voltage on RSD, derived from the plasma bipolar drift model and the RLC circuit equations of RSD main loop, the simulation waveforms of current and voltage on RSD are acquired through iterative calculation by using the fourth order Runge-Kutta method, then the curve of transient power on RSD versus time is obtained. The result shows that the total dissipation on RSD is trivial compared with the pulse discharge energy and the commutation dissipation can be nearly ignored compared with the quasi-static dissipation. These characteristics can make the repetitive frequency of RSD increase largely. The experimental results prove the validity of simulation calculations. The influence factors on power dissipation are discussed. The power dissipation increases with the increase of the peak current and the n-base width and with the decrease of n-base doping concentration. In order to keep a low power dissipation, it is suggested that the n-base width should be smaller than 320μm when doping concentration is 1.0×10^14cm^-3 while the doping concentration should be higher than 5.8×10^13cm^-3 when n-base width is 270μm.     

Hierarchical nanostructured composite cathode with carbon nanotubes as conductive scaffold for lithium-sulfur batteries

Carbon nanotubes (CNTs) are excellent scaffolds for advanced electrode materials, resulting from their intrinsic sp2 carbon hybridization, interconnected electron pathway, large aspect ratio, hierarchical porous structures, and low cost at a large-scale production. How to make full utilization of the mass produced CNTs as building blocks for nanocomposite electrodes is not well understood yet. Herein, a composite cathode containing commercial agglomerated multi-walled CNTs and S for Li-S battery was fabricated by a facile melt-diffusion strategy. The hierarchical CNT@S coaxial nanocables exhibited a discharging capacity of 1020 and 740 mAh g-1 at 0.5 and 2.0 C, respectively. A rapid capacity decay of 0.7% per cycle at the initial 10 cycles and a slow decay rate of 0.14% per cycle for the later 140 cycles were detected. Such hierarchical agglomerated CNT@S cathodes show advantages in easy fabrication, environmentally benign, low cost, excellent scalability, and good Li ion storage performance, which are extraordinary composites for high performance Li-S battery.     

Imide‐functionalized naphthodithiophene based donor‐acceptor conjugated polymers for solar cells

Donor‐acceptor conjugated polymers containing a new imide‐functionalized naphthodithiophene (INDT) as the acceptor unit and a 2,2'‐bithiophene with varied substituents as the donor unit have been synthesized. The bandgaps of these polymers depend strongly on the dihedral angle of the 2,2'‐bithiophene unit. The 3,3'‐dialkoxy substitution (polymers PDOR / PBOR ) leads to near planar bithiophene conformation due to the well‐known S–O short contact, while the 3,3'‐dialkyl substitution (polymer PDR ) results in significant twisting due to the steric effect. Consequently PDOR / PBOR shows the lowest bandgap of 1.82/1.85 eV while PDR has a bandgap of 2.38 eV. Bulk‐heterojunction solar cells of the polymer/fullerene blends have been fabricated. Preliminary results show that PBOR gives the best device performance with power conversion efficiencies as high as 2.45% in air without any thermal annealing treatment, indicating the promising potential of INDT‐containing conjugated polymers for efficient solar cells. © 2013 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2013 , 51, 3818–3828     

多铁材料BaCoF$lt;sub$gt;4$lt;/sub$gt;电子结构的第一性原理研究

采用基于密度泛函理论的广义梯度近似方法和赝势平面波法,对多铁材料BaCoF₄的铁电反铁磁相和可能的顺电相的电子结构进行了第一性原理研究.研究表明,反铁磁态很可能有利于低温下的铁电稳定性,F的强负电性使得体系内原子间主要是离子键相互作用.Co离子与在bc面上的F（2）,F（3）离子间完全是离子键作用,而与F（4）间有较弱的共价作用,与F（1）间作用介于两者之间.铁电畸变主要来源于Ba离子与F（1）, F（2）, F（3）离子沿着c轴方向的相对位移,F（4）对铁电性的贡献最少.铁电相中F（2）, F（3）离子的能量低于中心对称相,最大位移贡献者F（1）的化学键性由弱共价作用到离子键的变化也是最大的,这均有利于体系的稳定. 关键词： 第一性原理 铁电性 铁电畸变 反铁磁性     

高电荷态离子207Pbq+(24≤q≤36)与Si(110)固体表面作用的电子发射研究

报道了利用兰州重离子加速器国家实验室ECR源引出的高电荷态离子²⁰⁷Pb^q+(24≤q≤36)入射到Si(110)表面产生的电子发射的实验测量结果.结果表明,高电荷态离子与固体表面相互作用产生的电子发射产额Y与入射离子的电荷态q、入射角度ψ和入射能量E都有很强的关联.首次发现,电子发射产额Y与入射角度ψ间有接近1/tanψ的关系.理论分析认为,这些过程与基于经典过垒模型的势能电子发射过程密切相关. 关键词： 高电荷态离子 经典过垒模型 电子发射产额