快速多极边界元法用于扩散光学断层成像研究

在求解扩散光学断层成像中的正向问题时, 目前普遍采用有限元法, 但是随着实际模型规模的增大, 有限元法的计算量问题日益显著, 而边界元法则由于可以降低计算维度使计算量减少而备受关注. 本文以均匀的高散射介质为模型, 研究了将快速多极边界元法用于扩散光学断层成像的正向问题. 快速多极边界元法利用核函数的多极展开, 将常规边界元法中系数矩阵和迭代矢量的乘积项等价为相应四叉树结构的一次递归, 再结合广义最小残量法进行迭代求解. 将计算结果和蒙特卡罗法的模拟结果进行了比较, 表明利用快速多极边界元法的模拟结果和蒙特卡罗法的结果有很好的一致性. 研究结果验证了快速多极边界元法可以用于扩散光学断层成像, 为其大规模和实时成像带来可观的前景. 关键词： 扩散光学断层成像 边界元法 快速多极边界元法     

圆锥面PVDF聚焦换能器的非线性声场理论及实验研究

圆锥面聚焦换能器可在超声成像中获得较好径向分辨率的同时提高探测深度.利用高斯声源函数叠加法来近似表示圆锥面聚焦声源的分布函数，结合近轴近似的KZK方程，得到了圆锥面聚焦换能器在损耗媒质中产生的基波、二次谐波声场的解析解.在实验上制作了PVDF圆锥面聚焦换能器，测量了圆锥面聚焦换能器的基波及二次谐波声场，实验结果和理论计算相符.     

Null testing toroidal surface and biconic surface with cylinder compensator

Toroidal surface and biconic surface are employed increasingly, however their profile cannot be null tested easily for they are non-rotationally symmetrical. Null testing method with cylinder compensator is proposed to solve this problem. The theory of this method is revealed. The errors of this method are present. Three typical testing optical systems with cylinder compensator are demonstrated at last. The design results and total error indicate that this method is feasible.     

Influence of focusing depth on the microfabrication of waveguides inside silica glass by femtosecond laser direct writing

We studied the influence of focusing depth on the index change threshold and damage threshold of silica glass irradiated by a focused 120 fs laser beam. Both thresholds increased with the focusing depth. The aspect ratio of the waveguide cross section can be selected by changing the focusing depth. A 5 mm long waveguide was written at the depth of 2100 μm, which was single mode at 632.8 nm and exhibited propagation loss of 0.56 dB/cm. The refractive index change was calculated to be ∼2.47×10^-3. The influence of the focusing depth should be considered in multi-layer devices as shown in the fabrication of a 3×3 waveguide array. PACS 42.62.-b; 42.82.Et; 81.05.Kf     

Multiwavelength Raman fiber lasers with equalized peak power using a sampled chirped fiber Bragg grating

Two novel multiwavelength Raman fiber lasers using a ring cavity and a linear cavity are proposed and demonstrated experimentally. Both laser configurations include a sampled chirped fiber Bragg grating used in the reflection mode. By adjusting the polarization controller (PC) in the cavities, up to ten stable lasing wavelengths with 0.8 nm spacing and equalized peak power are achieved at room temperature. It is observed that the output spectrum depends upon which port of the grating is connected to the cavity. These two fiber ring lasers offer advantages such as, stable room temperature operation, simple structure, low loss, multiwavelength lasing lines with moderate output power. PACS 42.55.Wd; 42.55.Ye; 42.81.-i     

Nanoparticle composites: FePt with wide-band-gap semiconductor

We present a simple way to synthesize FePt and ZnO (wide-band-gap semiconductor) nanoparticle composites. The FePt nanoparticles were fabricated using the method reported by Sun et al. By controlling the heating rate, 3 nm FePt nanoparticles were synthesized. Well-dispersed FePt and ZnO nanoparticle composites were prepared by further adding zinc acetate and oleyl amine into the 3 nm FePt nanoparticle dispersion. By controlling the molar ratio of the FePt and zinc acetate, FePt and ZnO nanoparticle composites with different FePt particle fractions were obtained. The intensity of photo luminescence spectra of the nanoparticle composites increases very much with decreasing FePt particle fraction, whereas the peak position shifts a little. After annealing at 550 °C for half an hour, the nanoparticle composites become magnetically hard or semi-hard with coercivity much dependent on the FePt particle volume fraction. The coercivity of the composites increases with annealing temperature. The composites hold the promise of applications in new generation recording and/or optical devices.     

Polarization-dependent carrier dynamics in a passive InAs/InP quantum dot waveguide

We investigate carrier dynamics in a passive InAs/InP quantum dot (QD) waveguide using 255 fs optical pulses at a central wavelength of 1568 nm. We observe strong anisotropy of absorption saturation for different polarizations. Pump-probe measurements indicate the presence of carrier relaxation dynamics on a timescale in the order of tens of picoseconds due to cascaded relaxation of carriers generated by two-photon absorption (TPA) from the bulk region to the QDs via the wetting layer. These relaxation timescales are much longer than in QD amplifiers. Our observations are supported by a rate-equation model which includes TPA, showing good agreement with the pump-probe measurements.     

Structures and stability of Al<Subscript><Emphasis Type="Bold">7</Emphasis></Subscript>C and Al<Subscript><Emphasis Type="Bold">7</Emphasis></Subscript>N clusters

We report results of the atomic and electronic structures of Al₇C cluster using ab initio molecular dynamics with ultrasoft pseudopotentials and generalized gradient approximation. The lowest energy structure is found to be the one in which carbon atom occupies an interstitial position in Al₇ cluster. The electronic structure shows that the recent observation [Chem. Phys. Lett. 316, 31 (2000)] of magic behavior of Al₇C^- cluster is due to a large highest occupied and lowest unoccupied molecular orbital (HOMO-LUMO) gap which makes Al₇C^- chemically inert. These results have further led us to the finding of a new neutral magic cluster Al₇N which has the same number of valence electrons as in Al₇C^- and a large HOMO-LUMO gap of 1.99 eV. Further, calculations have been carried out on (Al₇N)₂ to study interaction between magic clusters. Received 28 July 2001     

介质的非均匀性对高次谐波影响的研究

讨论了气体介质的非均匀性对飞秒激光高次谐波产生过程的可能影响.计算结果表明,采用喷阀技术所提供的气体介质的密度梯度和气体原子运动速度的影响很小,不会产生实验上可观测的效果.这一结果支持了喷气靶在高次谐波产生中的广泛应用 关键词： 高次谐波 气体介质 各向异性 飞秒激光     

连续CO2激光对红外窗口材料损伤研究

研究了连续ＣＯ２激光对几种红外窗口材料的表面损伤特性，研究表明，损伤机制在于杂质缺陷吸收造成的热冲击应力破坏。深入研究了杂质缺陷密度、焦斑与材料损伤阈值的关系，并建立了一个损伤模型。同时分析了热冲击应力破坏方式。