Inter-method comparison for the determination of antimony and arsenic in peat samples

Four analytical approaches, based on different physical principles, for the determination of antimony (Sb) and arsenic (As) in ancient peat samples were critically evaluated: (a) open vessel digestion/hydride generation-atomic absorption spectrometry (HG-AAS), (b) closed-pressurized digestion in a microwave oven followed by sector field-inductively coupled plasma-mass spectrometry (SF-ICP-MS), (c) digestion in a microwave autoclave and subsequent quadrupole-inductively coupled plasma-mass spectrometry (Q-ICP-MS) measurements and (d) instrumental neutron activation analysis (INAA). The quality control scheme applied, always included the use of adequate plant reference materials to ensure the accuracy and precision of the analytical procedures. Additionally, two internal peat reference materials were analyzed using all four analytical approaches, generally showing good agreement for both elements. Method detection limits for As and Sb provided by all procedures were approximately 5 and 2 ng g⁻¹ which is sufficiently low for the reliable quantification of both elements in ancient, pre-anthropogenic peat samples. A comparison of As and Sb concentrations in a set of peat samples determined by INAA, HG-AAS and SF-ICP-MS revealed that INAA underestimated the values in a systematic manner, whereas HG-AAS and SF-ICP-MS data agreed very well. Best precision of the results was obtained by analytical procedures involving HG-AAS or Q-ICP-MS and varied from 3.6 to 4.3% and 7.1 to 7.5% for As (at about 0.5 μg g⁻¹) and Sb (at about 0.1 μg g⁻¹), respectively. The highest sample throughput (40 samples per run accomplished in 2 h) combined with low risk of sample contamination could be realized in the high-pressure microwave autoclave. The amount of sample required by all approaches was 200 mg, except for INAA which needed at least 25 times more sample mass to achieve comparable detection limits. For the quantification of As and Sb, inductively coupled plasma-mass spectrometry (ICP-MS) was preferred over INAA and HG-AAS, mainly because (a) less sample is needed and (b) As and Sb can be determined simultaneously. In addition, ICP-MS offers the possibility to measure concurrently a wide range of other elements which also are of environmental interest.     

Synthesis and characterization of graphene‐containing thermoresponsive nanocomposite hydrogels of poly(N‐vinylcaprolactam) prepared by frontal polymerization

Thermoresponsive poly(N‐vinylcaprolactam) nanocomposite hydrogels containing graphene were successfully prepared by frontal polymerization. High concentration of graphene (5.0 mg/mL) was obtained by direct graphite sonication in the self‐same liquid monomer, thus avoiding any chemical manipulation and obtaining “real” graphene as nanofiller instead of one of its more or less oxidized derivative, which is what generally reported in published reports. Furthermore, the corresponding nanocomposites were obtained without using any solvent to be eventually removed. The materials were fully characterized by RAMAN, SEM, and TEM, and their swelling behavior and rheological properties were investigated. © 2012 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2012     

Ethylene/hindered phenol substituted norbornene copolymers: Synthesis and NMR structural determination

A new family of ethylene‐based copolymers with controlled amounts of a norbornene comonomer (N_ArOH) bearing a stabilizing antioxidant functionality (2,6‐di‐tert‐butyl phenol) was prepared. Due to unavoidable exo/endo equilibrium operative in N_ArOH comonomer, a complete and detailed NMR assignment of the structure of the prepared ethylene/N_ArOH copolymers was carried out for the determination of the exo/endo ratio inside the polymer. These novel functionalized comonomers can be considered suitable starting material for preparing ethylene‐based copolymers, with tunable comonomer content, as non‐releasing macromolecular antioxidant additives for specific application in safe food and/or drug packaging © 2012 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2012     

Study of spatial inhomogeneity in inverted all‐polymer solar cells: Effect of solvent and annealing

The efficiency optimization of bulk heterojunction solar cells requires the control of the local active materials arrangement in order to obtain the best compromise between efficient charge generation and charge collection. Here, we investigate the large scale (10–100 μm) inhomogeneity of the photoluminescence (PL) and the external quantum efficiency (EQE) in inverted all‐polymer solar cells (APSC) with regioregular poly(3‐hexylthiophene) (P3HT):poly(9,9‐dioctylfluorene‐co‐benzothiadiazole) (F8BT) active blends. The morphology and the local active polymer mixing are changed by depositing the active layer from four different solvents and by thermal annealing. The simultaneous PL and EQE mapping allowed us to inspect the effects of local irregularities of active layer thickness, polymer mixing, polymer aggregation on the charge generation and collection efficiencies. In particular, we show that the increase of the solvent boiling point affects the EQE non‐uniformity due to thickness fluctuations, the density non‐uniformity of rrP3HT aggregate phase, and the blend components clustering. The thermal annealing leads to a general improvement of EQE and to an F8BT clustering in all the samples with locally decrease of the EQE. We estimate that the film uniformity optimization can lead to a total EQE improvement between 2.7 and 6.3 times. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 804–813     

Two-dimensional lipid mixing entropy regulates the formation of multicomponent lipoplexes

The mechanism of formation of multicomponent lipoplexes was investigated by means of synchrotron Small-Angle X-ray Diffraction (SAXD). Mixed lipid dispersions were prepared by mixing different populations of binary cationic liposomes. When adding DNA to mixed lipid dispersions, multicomponent lipoplexes spontaneously formed exhibiting structural properties, i.e., membrane thickness, surface charge density, and one-dimensional DNA packing density, intermediate between those of binary lipoplexes. These results suggested that DNA lets liposomes come into contact and fuse and that a complete lipid mixing at the molecular level occurs. The equilibrium structure of multicomponent lipoplexes was found to be unique and did not depend on the number and kind of populations composing lipid dispersion but only on the lipid species involved and on their relative molar ratio. According to recent theoretical models we identified two-dimensional lipid mixing entropy as the key factor regulating the existence of only multicomponent lipoplexes with ideally mixed lipid species.     

Treatment of Malignant Melanoma by High-Peak-Power 1064 nm Irradiation Followed by Photodynamic Therapy

Irradiation of B16 pigmented melanoma subcutaneously transplanted in C57 mice with a single 650 mj pulse (10 ns) of 1064 nm light from a Q-switched Nd: YAG laser caused instantaneous bleaching of the pigmented tissue. Visual and histological examination of the resulting gray-colored tumor revealed the breakdown of melanosomes with no detectable alteration of the normal and tumor-overlying skin. Histological examination of the irradiated tumor showed some degree of vascular damage; the depth of the photodamage was not affected by the successive delivery of three consecutive light pulses. The bleached tumor grew at a modestly slower rate but the high-peak-power (HPP) laser treatment did not affect the tumor concentration of a photodynamic sensitizer Si(IV)-naphthalocyanine (isoBO-SiNc) intravenously injected 24 h before Nd : YAG irradiation. Treatment of the B16 pigmented melanoma by photodynamic therapy (PDT: 1 mg/kg isoBO-SiNc, 300 mW/cm², 520 J/cm²) from a 774 nm diode laser immediately after the 1064 nm irradiation resulted in a 16 day delay of tumor regrowth, which was markedly longer than the delay (ca 6 days) obtained after PDT under identical conditions without the preirradia-tion. Thus, pretreatment of pigmented tumors with HPP 1064 nm light appears to enhance their susceptibility to conventional PDT. The tumor response was further enhanced by repeating the combined HPP/PDT treatment at an interval of 10 days (regrowth delay: 27 days), as well as by applying hyperthermia immediately after HPP/PDT (regrowth delay: ca 34 days).     

A consensus procedure improving solvent accessibility prediction

Prediction methods of structural features in 1D represent a useful tool for the understanding of folding, classification, and function of proteins, and, in particular, for 3D structure prediction. Among the structural aspects characterizing a protein, solvent accessibility has received great attention in recent years. The available methods proposed for predicting accessibility have never considered the combination of the results deriving from different methods to construct a consensus prediction able to provide more reliable results. A consensus approach that increases prediction accuracy using three high-performance methods is described. The results of our method for three different protein data sets show that up to 3.0% improvement in prediction accuracy of solvent accessibility may be obtained by a consensus approach. The improvement also extends to the correlation coefficient. Application of our consensus approach to the accessibility prediction using only three prediction methods gives results better than single methods combined for consensus formation. Currently, the scarce availability of predictors with similar parameters defining solvent accessibility hinders the testing of other methods in our consensus procedure.     

Metal-support interaction and redox behavior of Pt(1 wt %)/Ce0.6Zr0.4O2

The catalyst Pt(1 wt %)/Ce(0.6)Zr(0.4)O(2) is studied by CO-temperature programmed reduction (CO-TPR), isothermal oxygen storage complete capacity (OSCC), X-ray absorption spectroscopy (XAS) at the Pt L(III) edge, and in situ X-ray diffraction (in situ XRD), with the aim of elucidating the role of supported metal in CO oxidation by ceria-based three-way catalysts (TWC). The redox behavior of Pt(1 wt %)/Ce(0.6)Zr(0.4)O(2) is compared to that of bare ceria-zirconia. OSCC of redox-aged Pt/ceria-zirconia is twice that of bare ceria-zirconia, and the maximum of CO consumption occurs at a temperature about 300 K lower than redox-aged ceria-zirconia. XAS analysis allows one to evidence the formation of a platinum-cerium alloy in redox-aged samples and the stability of the metal particles toward oxidation and sintering during high-temperature treatments. Under CO flux at 773 K, bare ceria-zirconia shows a continuous drift of diffraction peaks toward smaller Bragg angles, due to a progressive increase of Ce(III) content. Under the same treatment, the structural rearrangement of Pt-supported ceria-zirconia starts after an induction time and takes place with an abrupt change of the lattice constant. The experimental evidence points to the role of supported Pt in modifying the redox properties of ceria-zirconia with respect to the bare support. It is proposed that the much faster bulk reduction observed by in situ XRD for redox-aged Pt/ceria-zirconia can be attributed to an easier release of reacted CO(2), producing a more effective turnover of reactants at the catalyst surface.     

The inelastic hard dimer gas: a nonspherical model for granular matter

We study a two-dimensional gas of inelastic smooth hard dimers. Since the collisions between dimers are dissipative, being characterized by a coefficient of restitution alpha<1, and no external driving force is present, the energy of the system decreases in time and no stationary state is achieved. However, the resulting nonequilibrium state of the system displays several interesting properties in close analogy with systems of inelastic hard spheres, whose relaxational dynamics has been thoroughly explored. We generalize to inelastic systems a recently method introduced [G. Ciccotti and G. Kalibaeva, J. Stat. Phys. 115, 701 (2004)] to study the dynamics of rigid elastic bodies made up of different spheres held together by rigid bonds. Each dimer consists of two hard disks of diameter d, whose centers are separated by a fixed distance a. By describing the rigid bonds by means of holonomic constraints and deriving the appropriate collision rules between dimers, we reduce the dynamics to a set of equations which can be solved by means of event-driven simulation. After deriving the algorithm we study the decay of the total kinetic energy, and of the ratio between the rotational and the translational kinetic energy of inelastic dimers. We show numerically that the celebrated Haff's homogeneous cooling law t(-2), describing how the kinetic energy of an inelastic hard-sphere system with a constant coefficient of restitution decreases in time, holds even in the case of these nonspherical particles. We fully characterize this homogeneous decay process in terms of appropriate decay constants and confirm numerically the scaling behavior of the velocity distributions.     

Are defect models consistent with the entropy and specific heat of glass formers?

We show that pointlike defect model of glasses cannot explain the thermodynamic properties of glass formers, as for example, the excess specific heat close to the glass transition, contrary to the claim of Garrahan and Chandler [Proc. Natl. Acad. Sci. U.S.A. 100, 9710 (2003)]. More general models and approaches in terms of extended defects are also discussed.