The pH inside a swollen polyelectrolyte gel: poly(N-vinylimidazole)

The pH inside a dissolved polyelectrolyte coil or a swollen ionic polymer network is not accessible to direct measurement. It is here calculated through a simple model, based on Donnan equilibrium, counterion condensation (for charge density exceeding the critical value), and balance of mobile ions, without any assumption on the pKa of the ionizable groups. The data needed for the calculation with this model are polymer concentration, pH value in the initial solution, and pH value in the bath at equilibrium. All three can be determined experimentally by a batch method where the polymer is immersed in a different pot for each starting pH. The model is applied to a sample system, namely, chemically cross-linked poly(N-vinylimidazole) immersed in acidic baths of different pH values. The imidazole units are basic and become protonated by the acid, thus changing the pH of the initial bath. The model shows how the pH developed inside the swollen gel is several units higher than the pH of the bath at equilibrium, both with or without the correction for counterion condensation. Consequently, when the pKa of the polyelectrolyte is determined in the usual way (with the pH measured in the external bath), it gives an apparent value that is several units below the pKa determined from the actual pH inside the swollen gel at equilibrium. The inclusion of the counterion condensation decreases very slightly the polymer basicity. Surface effects and intramolecular association between protonated and unprotonated imidazole rings are discussed to explain the pKa behavior in the limit of low degree of ionization.     

Triple channel sensing of Pb(II) ions by a simple multiresponsive ferrocene receptor having a 1-deazapurine backbone

A new redox, chromogenic, and fluorescent chemosensor molecule based on a deazapurine ring selectively senses aqueous Pb2+ in acetonitrile over other metal ions examined: redox shift (DeltaE1/2 = 0.15 V of the Fe(II)/Fe(III) redox couple), the colorless to orange color change, and an emission change of 620-fold, with an unprecedented detection limit of 2.7 microg L-1. The signal transduction occurs via a reversible CHEF with this inherent quenching metal ion.     

Prospects for the Personalized Multimodal Therapy Approach to Pain Management via Action on NO and NOS

Chronic pain syndromes are an important medical problem generated by various molecular, genetic, and pathophysiologic mechanisms. Back pain, neuropathic pain, and posttraumatic pain are the most important pathological processes associated with chronic pain in adults. Standard approaches to the treatment of them do not solve the problem of pain chronicity. This is the reason for the search for new personalized strategies for the prevention and treatment of chronic pain. The nitric oxide (NO) system can play one of the key roles in the development of peripheral pain and its chronicity. The purpose of the study is to review publications devoted to changes in the NO system in patients with peripheral chronical pain syndromes. We have carried out a search for the articles published in e-Library, PubMed, Oxford Press, Clinical Case, Springer, Elsevier, and Google Scholar databases. The search was carried out using keywords and their combinations. The role of NO and NO synthases (NOS) isoforms in peripheral pain development and chronicity was demonstrated primarily from animal models to humans. The most studied is the neuronal NOS (nNOS). The role of inducible NOS (iNOS) and endothelial NOS (eNOS) is still under investigation. Associative genetic studies have shown that single nucleotide variants (SNVs) of NOS1, NOS2, and NOS3 genes encoding nNOS, iNOS, and eNOS may be associated with acute and chronic peripheral pain. Prospects for the use of NOS inhibitors to modulate the effect of drugs used to treat peripheral pain syndrome are discussed. Associative genetic studies of SNVs NOS1, NOS2, and NOS3 genes are important for understanding genetic predictors of peripheral pain chronicity and development of new personalized pharmacotherapy strategies.     

Influence of the electrical interface properties on the rheological behavior of sonicated soy lecithin dispersions

A significant effect, on the rheological behavior, due to the electrical properties of vesicles formed from concentrated soy lecithin dispersions have been studied in this work. The rheopectic behavior of concentrated soy lecithin dispersions (120, 150, 180, 210 and 240 g L-1) prepared by swelling-light sonication-freezing-unfreezing procedure is studied and it is specially emphasized on the transition under steady shear from lamellar phase of planar sheets to closed structures as multilamellar vesicles. Samples have been exposed to a different number of sonication cycles (from 0 to 100) and the changes in the hysteresis loop area, the apparent viscosity and the electrophoretic mobility have been studied. When the number of sonication cycles increases, the size and number of bilayers of these multilamellar vesicles decrease and therefore the total number of the vesicles and the volume fraction occupied by them show an increase.     

Ammonia IRMS-TPD measurements and DFT calculation on acidic hydroxyl groups in CHA-type zeolites

Br?nsted acidity of H-chabazite (CHA) zeolites (Si : Al(2) = 4.2) was investigated by means of ammonia infrared-mass spectrometry/temperature-programmed desorption (IRMS-TPD) methods and density functional calculations. Four IR bands were observed at 3644, 3616, 3575 and 3538 cm(-1), and they were ascribable to the acidic OH groups on four nonequivalent oxygen sites in the CHA structure. The absorption band at 3538 cm(-1) was attributed to the O(4)H in the 6-membered ring (MR), and ammonia adsorption energy (DeltaU) of this OH group was the lowest among the 4 kinds of OH groups. The other 3 bands were assigned to the acidic OH groups in 8MR. It was observed that the DeltaU in 8 and 6MR were 131 (+/-3) and 101 kJ mol(-1), respectively. On the other hand, the density functional theory (DFT) calculations within periodic boundary conditions yielded the adsorption energies on these OH groups in 8 and 6MR to be ca. 130 and 110 kJ mol(-1), respectively, in good agreement with the experimentally-observed values.     

Interaction of hydrogen chloride with ice surfaces: the effects of grain size, surface roughness, and surface disorder

Characterization of the interaction of hydrogen chloride (HCl) with polar stratospheric cloud (PSC) ice particles is essential to understanding the processes responsible for ozone depletion. The interaction of HCl with ice was studied using a coated-wall flow tube with chemical ionization mass spectrometry (CIMS) between 5x10(-8) and 10(-4) Torr HCl and between 186 and 223 K, including conditions recently shown to induce quasi-liquid layer (QLL) formation on single crystalline ice samples. Measurements were performed on smooth and rough (vapor-deposited) polycrystalline ice films. A numerical model of the coated-wall flow reactor was used to interpret these results and results of studies on zone-refined ice cylinders with grain sizes on the order of several millimeters (reported elsewhere). We found that HCl adsorption on polycrystalline ice films typically used in laboratory studies under conditions not known to induce surface disordering consists of two modes: one relatively strong mode leading to irreversible adsorption, and one relatively weak binding mode leading to reversible adsorption. We have indirect experimental evidence that these two modes of adsorption correspond to adsorption to sites at crystal faces and those at grain boundaries, but there is not enough information to enable us to conclusively assign each adsorption mode to a type of site. Unlike what was observed in the zone-refined ice study, there was no strong qualitative contrast found between the HCl uptake curves under QLL versus non-QLL conditions for adsorption on smooth and vapor-deposited ices. We also found indirect evidence that HCl hexahydrate formation on ice between 3x10(-7) and 2x10(-6) Torr HCl and between 186 and 190 K is a process involving hydrate nucleation and propagation on the crystal surface, rather than one originating in grain boundaries, as has been suggested for ice formed at lower temperatures. These results underscore the dependence of the HCl-ice interaction on the characteristics of the ice substrate.     

Synthesis, structure and reactivity of cuboidal-type cluster aqua complexes with W3PdS4 4+ core

The reaction of PdCl(2) with [W3S4(H2O)9]4+ in the presence of hypophosphorous acid in 2 M HCl gives cuboidal cluster [W3(PdCl)S4(H2O)9]3+ (1) which undergoes condensation and crystallises from Hpts solutions as edge-linked double cubane cluster [{W3PdS4(H2O)9}2](pts)(8).19H2O (pts = p-toluenesulfonate) (1'). The substitution of Cl- in (1) by different ligands was explored. The Pd atom in the cluster shows an exceptionally high reactivity in the isomerisation of the hydrophosphoryl H2P(O)(OH), HP(O)(OH)2, HPPh(O)(OH) and HPPh2(O) molecules into the corresponding hydroxo tautomers HP(OH)2, P(OH)3, PhP(OH)2 and Ph2P(OH) stabilised by coordination at Pd. The reactions were followed by UV-Vis spectrophotometry and 31P NMR. Formation constants of the 1 : 1 coordination of [M3(PdCl)S4(H2O)9]3+ (M = Mo, W) with HP(OH)2 and As(OH)3 were obtained. The structures of cucurbit[6]uril (C36H36N24O12, CUC[6]) adducts [W3(PdP(OH)3)S4(H2O)8Cl]-(C36H36N24O12)Cl3.12.5H2O (2), and [W3Pd(PhP(OH)2)S4(H2O)7Cl2]2(C36H36N24O12)Cl4.9H2O (3) were determined by single-crystal X-ray diffraction.     

Separation of suspended particles by arrays of obstacles in microfluidic devices

The stochastic transport of suspended particles through a periodic pattern of obstacles in microfluidic devices is investigated by means of the Fokker-Planck equation and numerical simulations. Asymmetric arrays of obstacles have been shown to induce the continuous separation of DNA molecules, with particles of different size migrating in different directions within the microdevice (vector separation). We show that the separation of tracer particles only occurs in the presence of a permeating driving force with a nonzero normal component at the surface of the solid obstacles, and arises from differences in the local Peclet number of the particles. On the other hand, finite-size particles also exhibit nonzero, but small, migration angles in the case of nonpermeating fields. Monte Carlo simulations for different driving fields agree with the solutions to the Fokker-Planck equation.     

Ferrocene-based small molecules for dual-channel sensing of heavy- and transition-metal cations

The synthesis, electrochemical, optical, and cation-sensing properties of ferrocene-pentakis(phenylthio)benzene dyads, linked through a putative cation-binding 2-azadiene bridge, are presented. Dyad 5 behaves as a highly selective dual-redox and chromogenic chemosensor molecule for Pb(2+) cations; the oxidation redox peak is anodically shifted (DeltaE(1/2) = 125 mV), and the low energy band of the absorption spectrum is red-shifted (Delta lambda = 119 nm) upon complexation with this metal cation. Linear sweep voltammetry and spectroelectrochemical studies revealed that Cu(2+) and Hg(2+) metal cations induced oxidation of the ferrocene unit. The isomeric dyad 7, in which the nitrogen atom and the ferrocene unit are in closer proximity, has shown its ability for sensing both Pb(2+) and Hg(2+) ions; the oxidation redox peak is anodically higher shifted (DeltaE(1/2) = 340 mV), and the low energy band of the absorption spectrum is lower red-shifted (Delta lambda = 61 nm) that those found for dyad 5. The changes in the absorption spectra are accompanied by dramatic color changes which allow the potential for "naked eye" detection. A further exciting property of dyad 7 is that it behaves as an electrochemically induced switchable chemosensor for Pb(2+) and Hg(2+) because of the low metal-ion affinity of the oxidized 7(*+) species for these metal cations. The experimental data and conclusions about the ion-sensing properties are supported by DFT calculations.     

External polyacrylate-coating as alternative material for preparation of photopolymerized sol-gel monolithic column

Photopolymerized sol-gel monolithic columns for use in capillary electrochromatography were prepared in 125 microm i.d. polyacrylate-coated fused-silica capillaries. The polyacrylate-coating, unlike the polyimide one, is transparent to the radiation used (approximately 370 nm), and thus, no coating removal is necessary. This is a very important particularity since intrinsic capillary column characteristics, such as flexibility and mechanical resistance, are unchanged. A mixture containing metacryloxypropyltrimethoxysilane (MPTMS) as the polymeric precursor, hydrochloric acid as the catalyst, toluene as the porogen and bis(2,4,6-trimethylbenzoyl)-phenylphosphine oxide (Irgacure 819) as the photoinitiator was irradiated at 370 nm for 20 min inside the capillaries to prepare the columns through sol-gel approach. The versatility and viability of the use of polyacrilate as a new capillary external coating were shown through preparation of two columns under different conditions, which were tested in electrochromatography for separation of standard mixture containing thiourea (marker compound), propylbenzene, phenanthrene and pyrene.