Bulky Cations and Four different Polyiodide Anions in [Lu(Db18c6)(H2O)3(thf)6]4(I3)2(I5)6(I8)(I12)

Black single crystals of [Lu(Db18c6)(H₂O)₃(thf)₆]₄(I₃)₂(I₅)₆(I₈)(I₁₂) were obtained from lutetium, I₂ and Db18c6 (dibenzo‐18‐crown‐6) in THF solution. In the bulky cation, Lu³⁺ is surrounded by nine oxygen atoms, six of Db18c6 and three of water molecules to which two THF molecules are attached each. Meanwhile, four polyiodide anions, (I₃)^–, (I₅)^–, (I₈)^2– and (I₁₂)^2–, in a 2:6:1:1 ratio form a three‐dimensional network and leave space for the bulky cations.     

Comprehensive blood plasma lipidomics by liquid chromatography/quadrupole time-of-flight mass spectrometry

A lipidomics strategy, combining high resolution reversed-phase liquid chromatography (RPLC) with high resolution quadrupole time-of-flight mass spectrometry (QqTOF), is described. The method has carefully been assessed in both a qualitative and a quantitative fashion utilizing human blood plasma. The inherent low technical variability associated with the lipidomics method allows to measure 65% of the features with an intensity RSD value below 10%. Blood plasma lipid spike-in experiments demonstrate that relative concentration differences smaller than 25% can readily be revealed by means of a t-test. Utilizing an advanced identification strategy, it is shown that the detected features mainly originate from (lyso-)phospholipids, sphingolipids, mono-, di- and triacylglycerols and cholesterol esters. The high resolution offered by the up-front RPLC step further allows to discriminate various isomeric species associated with the different lipid classes. The added value of utilizing a Jetstream electrospray ionization (ESI) source over a regular ESI source in lipidomics is for the first time demonstrated. In addition, the application of ultra high performance LC (UHPLC) up to 1200 bar to extend the peak capacity or increase productivity is discussed.     

Solid‐State NMR Characterization of Wilkinson’s Catalyst Immobilized in Mesoporous SBA‐3 Silica

The Wilkinson’s catalyst [RhCl(PPh₃)₃] has been immobilized inside the pores of amine functionalized mesoporous silica material SBA‐3 and The structure of the modified silica surface and the immobilized rhodium complex was determined by a combination of different solid‐state NMR methods. The successful modification of the silica surface was confirmed by ²⁹Si CP‐MAS NMR experiments. The presence of the T_n peaks confirms the successful functionalization of the support and shows the way of binding the organic groups to the surface of the mesopores. ³¹P‐³¹P J‐resolved 2D MAS NMR experiments were conducted in order to characterize the binding of the immobilized catalyst to the amine groups of the linkers attached to the silica surface. The pure catalyst exhibits a considerable ³¹P‐³¹P J‐coupling, well resolvable in 2D MAS NMR experiments. This J‐coupling was utilized to determine the binding mode of the catalyst to the linkers on the silica surface and the number of triphenylphosphine ligands that are replaced by coordination bonds to the amine groups. From the absence of any resolvable ³¹P‐³¹P J‐coupling in off‐magic‐angle‐spinning experiments, as well as slow‐spinning MAS experiments, it is concluded, that two triphenylphosphine ligands are replaced and that the catalyst is bonded to the silica surface through two linker molecules.     

Evaluation of a new polymeric stationary phase with reversed-phase properties for high temperature liquid chromatography

The performance of a polymeric stationary phase with reversed-phase properties (ET-RP1) was evaluated for LC separations at elevated temperature. The most significant observation was that the reduced plate height (h) decreased from 3.4 at 25 °C (optimal flow 0.5 mL/min) to 2.4 at 150 °C (optimal flow 2.5 mL/min) which is comparable to the efficiency obtained with silica-based reversed-phase columns of 4.6 mm ID operated at 0.8 mL/min. The phase showed no deterioration after long use at 150 °C within the pH range 1–9. Catalytic activity originating from the stationary phase material, e.g. as experienced on zirconium columns operated at elevated temperature, was absent. The performance of ET-RP1 is illustrated with the analysis of some pharmaceutical samples by LC and LC–MS. Operation at elevated temperature also allows to reduce the amount of organic modifier or to replace acetonitrile and methanol by the biodegradable ethanol.     

Minimizing the number of machines for minimum length schedules

In this paper, we present a new objective function for scheduling on parallel machines: minimizing the number of machines for schedules of minimum length. We study its complexity and we prove the NP-completeness of this problem, even if there is no precedences or for unitary execution times. We propose several polynomial algorithms for various particular cases.     

Mural inspection by vibration measurements with TV-holography

A commonly encountered problem in the conservation of historical murals is the identification of sections in the plaster that have detached from the wall and thus threaten to fall off. Commonly, walls are inspected by the acoustic response to a gentle finger-tapping (percussion method). Since this is a costly and cumbersome technique, means for a more automatic inspection are searched for. A TV-holography system of increased sensitivity in combination with acoustic excitation of the object is shown to be a new and powerful tool for monitoring of loose areas. It has the advantage of non-contact and remote operation which, for example, is extremely useful in large buildings. Principles of the method, experimental results obtained at an artificial wall in the laboratory, and a thorough comparison of results from historical sites gained by the traditional percussion method and the new technique are presented. The latter shows very good agreement in the assessment of wall quality and thus is evidence of the suitability of the optical equipment for tasks in conservation.