Crystallization of polyamide confined in sub‐micrometer droplets dispersed in a molten polyethylene matrix

The crystallization of submicrometer PA6 droplets dispersed in an ethylene‐1‐octene copolymer matrix, using PE‐g‐MA as a compatibilizer agent, is investigated. This system shows a nonconventional mechanical behavior at high temperatures. Up to ～100 °C above the final melting temperature of the ethylene‐1‐octene copolymer matrix, the system shows good thermal and mechanical properties including dimensional stability. Because of the dispersed phase morphology of the system, so‐called fractionated/homogeneous crystallization takes place leading to an extra supercooling of PA6: ～50 °C compared to the bulk PA6 crystallization temperature. Thus—though this is most probably just of interest for small‐scale research—the system can be processed at lowered temperatures while still providing exceptional high‐temperature properties. While the matrix is in the melt state when crystallization of the dispersed PA6 phase occurs, the possibility of matrix induced crystallization is absent, contrary to almost all of the ‘dispersed droplets in a matrix’ systems reported so far. The kinetics of this phenomenon is investigated in detail by DSC: the existence of fractionated/homogeneous crystallization is shown to be related to the lack of active nuclei in the dispersed droplets by means of self‐seeding experiments. The occurrence of extensive cold crystallization of PA6 in the confined environment is studied as is the crystallization kinetics, including the characterization of its time dependences showing its sporadic nature. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 815–825, 2006     

Ammonium perfluorooctanoate as a volatile surfactant for the analysis of N-methylcarbamates by MEKC-ESI-MS

Ammonium perfluorooctanoate (APFOA) was investigated as an MS-friendly surfactant for the analysis of a mixture of ten N-methylcarbamates with MEKC-ESI-MS. Because of the relatively low boiling point of perfluorooctanoic acid ( approximately 190 degrees C), APFOA can be introduced into a mass spectrometer without the adverse effects of less volatile surfactants such as SDS. With a BGE consisting of 50 mM APFOA/isopropanol (IPA) 98:2 and with 30 kV applied, a very fast separation ( approximately 6 min) was possible with only one pair of analytes comigrating. Using an experimental design with four factors (voltage, nebulizer pressure, concentration of APFOA, and concentration of IPA) we were able to resolve all analytes in just over 11 min. Sheath liquid composition and flow rate, drying gas temperature and flow rate, and fragmentor voltage were then optimized for maximum signal intensity and S/N. It was found that the faster method gave better S/N because of narrower peak widths, and detection limits in SIM mode were between 0.01 (aldicarb) and 0.08 mg/L (methomyl). Calibration curves were prepared with standards of 0.50, 1.00, and 2.00 mg/L for the analysis of samples obtained after SPE of tap water spiked with the ten N-methylcarbamates at a level of 10 microg/L. All analytes showed very good recoveries (>86%), except for the most polar analyte aldicarb sulfone (recovery of 73%), testifying for the potential use of APFOA for this kind of analyses.     

Peptidomics: the integrated approach of MS, hyphenated techniques and bioinformatics for neuropeptide analysis

MS is currently one of the most important analytical techniques in biological and medical research. ESI and MALDI launched the field of MS into biology. The performance of mass spectrometers increased tremendously over the past decades. Other technological advances increased the analytical power of biological MS even more. First, the advent of the genome projects allowed an automated analysis of mass spectrometric data. Second, improved separation techniques, like nanoscale HPLC, are essential for MS analysis of biomolecules. The recent progress in bioinformatics is the third factor that accelerated the biochemical analysis of macromolecules. The first part of this review will introduce the basics of these techniques. The field that integrates all these techniques to identify endogenous peptides is called peptidomics and will be discussed in the last section. This integrated approach aims at identifying all the present peptides in a cell, organ or organism (the peptidome). Today, peptidomics is used by several fields of research. Special emphasis will be given to the identification of neuropeptides, a class of short proteins that fulfil several important intercellular signalling functions in every animal. MS imaging techniques and biomarker discovery will also be discussed briefly.     

Photooxidation of n-octanal in air: experimental and theoretical study

Dilute mixtures of n-octanal in synthetic air (up to 100 ppm) were photolyzed with fluorescent UV lamps (275-380 nm) at 298 K. The main photooxidation products were 1-hexene, CO, vinyl alcohol, and acetaldehyde. The photolysis rates and the absolute quantum yields were found to be slightly dependent on the total pressure. At 100 Torr, Φ(100) = 0.41 ± 0.06, whereas at 700 Torr the total quantum yield was Φ(700) = 0.32 ± 0.02. Two decomposition channels were identified: the radical channel C(7)H(15)CHO → C(7)H(15) + HCO and the molecular channel C(7)H(15)CHO → C(6)H(12) + CH(2)═CHOH, having absolute quantum yields of 0.022 and 0.108 at 700 Torr. The product CH(2)═CHOH tautomerizes to acetaldehyde. Carbon balance data lower than unities suggest the existence of unidentified decomposition channel(s) which substantially contributes to the photolysis. On the basis of experimental and theoretical evidence, n-octanal photolysis predominantly proceeds to form Norrish type II products as the major ones.     

Intercomparison on measurements of PCBs in pork fat during the Belgian PCB-crisis

During the Belgian PCB crisis (1999/2000) the quality of the data from the PCB monitoring were studied with a proficiency testing experiment. Pork fat that was spiked at the Institute for Reference Materials and Measurements (EC-JRC-IRMM) was sent out as unknown to all laboratories that participated in the monitoring. In parallel, the material was certified on the basis of the results of several leading PCB laboratories throughout Europe that did not participate in the monitoring. During the first round 15 to 25% deviation was experienced, while in the end of this multistep intercalibration procedure the average deviation for the respective PCBs was 10.9% (PCB 28), 13.1% (PCB 52), 10.1% (PCB 101), 10.7% (PCB 118), 10.7% (PCB 138), 9.1% (PCB 153), 8.1% (PCB 180) and 8.2% for the sum of the 7 PCBs. The concentrations measured for the higher volatile PCB 28 had a tendency to show lower levels, while for PCB 180 this was less pronounced. On the other hand, PCB 153 showed results rather to the higher side. During this exercise the material was also tested for stability by one of the certifying laboratories.     

Preparation of Well‐Defined Antibody–Drug Conjugates through Glycan Remodeling and Strain‐Promoted Azide–Alkyne Cycloadditions

Antibody–drug conjugates hold considerable promise as anticancer agents, however, producing them remains a challenge and there is a need for mild, broadly applicable, site‐specific conjugation methods that yield homogenous products. It was envisaged that enzymatic remodeling of the oligosaccharides of an antibody would enable the introduction of reactive groups that can be exploited for the site‐specific attachment of cytotoxic drugs. This is based on the observation that glycosyltransferases often tolerate chemical modifications in their sugar nucleotide substrates, thus allowing the installation of reactive functionalities. An azide was incorporated because this functional group is virtually absent in biological systems and can be reacted by strain‐promoted alkyne–azide cycloaddition. This method, which does not require genetic engineering, was used to produce an anti‐CD22 antibody modified with doxorubicin to selectively target and kill lymphoma cells.     

Brassicaceae seed oil identified as illuminant in Nilotic shells from a first millennium AD Coptic church in Bawit,Egypt

Burned greasy deposits were found inside shells of the large Nile bivalve Chambardia rubens, excavated in an eight- to tenth- century AD church of the Coptic monastery of Bawit, Egypt, and supposedly used as oil lamps. The residues were subjected to a combination of chromatographic residue analysis techniques. The rather high concentrations of unsaturated fatty acids, as analysed by gas chromatography (GC) in the methylated extract, suggest the presence of a vegetal oil. Analysis of the stable carbon isotopes (δ ¹³C values) of the methyl esters also favoured plants over animals as the lipid source. In the search for biomarkers by GC coupled to mass spectrometry on a silylated extract, a range of diacids together with high concentrations of 13,14-dihydroxydocosanoate and 11,12-dihydroxyeicosanoate were found. These compounds are oxidation products of erucic acid and gondoic acid, which are abundantly present in seeds of Brassicaceae plants. Liquid chromatography coupled to mass spectrometry analysis showed low concentrations of unaltered triglycerides, but revealed sizeable amounts of triglycerides with at least one dihydroxylated acyl chain. The unusual preservation of dihydroxylated triglycerides and α,ω-dicarboxylic acids can be related to the dry preservation conditions. Analysis of the stereoisomers of the dihydroxylated fatty acids allows one to determine whether oxidation took place during burning of the fuel or afterwards. The results prove that the oil of rapeseed (Brassica napus L.) or radish (Raphanus sativus L.) was used as illuminant in early Islamic Egypt, and that not only ceramic lamps but also mollusk shells were used as fuel containers.     

Increasing the Size of an Aromatic Helical Foldamer Cavity by Strand Intercalation

The postsynthetic modulation of capsules based on helical aromatic oligoamide foldamers would be a powerful approach for controlling their receptor properties without altering the initial monomer sequences. With the goal of developing a method to increase the size of a cavity within a helix, a single‐helical foldamer capsule was synthesized with a wide‐diameter central segment that was designed to intercalate with a second shorter helical strand. Despite the formation of stable double‐helical homodimers (K_dim>10⁷ M ^?1) by the shorter strand, when it was mixed with the single‐helical capsule sequence, a cross‐hybridized double helix was formed with K_a>10⁵ M ^?1. This strategy makes it possible to direct the formation of double‐helical heterodimers. On the basis of solution‐ and solid‐state structural data, this intercalation resulted in an increase in the central‐cavity size to give a new interior volume of approximately 150 ų.     

Mass spectrometric characterization of 4-oxopentanoic acid and gas-phase ion fragmentation mechanisms studied using a triple quadrupole and time-of-flight analyzer hybrid system and density functional theory

4-Oxopentanoic acid was characterized experimentally by electrospray ionization using a triple quadrupole and time-of-flight analyzer hybrid system. This compound was chosen as a model substance for small organic compounds bearing an acetyl and a carboxyl group. Collision-induced dissociation experiments at different activation energies were performed to elucidate possible fragmentation pathways. These pathways were also studied on the theoretical level using density functional theory (DFT) B3LYP/6-311++G(3df,3pd)//B3LYP/6-31+G(d)+ZPVE calculations. CO2 ejection from the [M-H](-) anion of 4-oxopentanoic acid was observed and the fragmentation pathway studied by DFT reveals a new concerted mechanism for CO2 elimination accompanied by an intramolecular proton transfer within a pentagonal transition state structure. Successive elimination of water and CO from the [M-H](-) anion of 4-oxopentanoic acid was also observed. A rearrangement in the primary deprotonated ketene anion produced after water elimination was found on the theoretical level and leads to CO elimination from the primary product anion [M-H-H2O](-). Energy diagrams along the reaction coordinates of the fragmentation pathways are presented and discussed in detail. Mulliken charge distributions of some important structures are presented.