Flow induced noise calculations for non-axially distributed hydrophones in towed arrays

Two improvements are put forward on the analyses of flow induced noise in towed arrays. First, the differences between Corcos/Carpenter pressure fluctuation models have been discussed at length, as well as flow induced noise calculated with these two models. Second, flow induced noise received by the finite hydrophones distributed non-axially is discussed and the relevant power spectrum is deduced. The results show that there are some disparities between the wavenumber spectrums and the responses of flow induced noise of these two models. Flow induced noise is closely related with the tow speed, the tube radius and the off-axis distance. The numerical analyses with Carpenter model indicate that the power spectrum of flow induced noise will increase 24 dB approximately with the tow speed doubled, decrease with the radius of the tube, and increase with the off-axis distance. The tube radius and the off-axis distance have greater influence on the high-frequency components than on the low-frequency components.     

微波辅助萃取加拿大一枝黄花的花中总黄酮的工艺研究

对加拿大一枝黄花的花进行微波处理,考察微波辅助萃取对加拿大一枝黄花的花中总黄酮提取率的影响.以卢丁为标准品,用硝酸铝做显色剂,采用分光光度法在530nm波长处测定了加拿大一枝黄花的花中总黄酮的含量,探讨了料液比、乙醇浓度、微波功率、微波处理时间等因素对加拿大一枝黄花的花中总黄酮提取率的影响.结果表明,在料液比1:10、乙醇浓度70%、微波功率700W、微波处理时间15min最优条件下,加拿大一枝黄花的花中总黄酮的提取率为17.86%.     

算法融合的差分吸收光谱法烟气SO2浓度在线监测研究

过去几十年中差分吸收光谱技术(differential optical absorption spectroscopy,DOAS)在大气污染物监测方面取得了成功应用.文章提出了根据差分吸光度最大值(OD'm)设定阈值的思想,将传统DOAS算法与基于卡尔曼滤波的DOAS算法相结合,利用两种算法在相同信噪比下具有不同反演精度的特点,在保证测量精度的前提下提高了DOAS系统的检测极限,较好地解决了短光程下低浓度气体的测量精度问题.在常温常压和流动状态下,对烟气中的SO2浓度测量进行了理论和实验研究.研究结果表明,改进的DOAS算法在OD'm＜0.048 1时,SO2浓度测量精度较高,测量下限可低于28.6 mg·m-3,零点漂移低于2.9 mg·m-3传统DOAS算法在0.048 1＜OD'm＜0.927 2时,SO2浓度测量精度较高;两种算法对OD'm＞0.927 2时的SO2浓度测量都存在较大的误差,必须进行线性度校正.     

三维时域有限差分法计算金纳米粒子尺寸与SERS活性的关联

通过合成一系列不同粒径(16～160 nm)的金纳米粒子.观察到120～135 nm的金纳米粒子在632.8nm波长激发下具有最高的SERS活性,这与前人报道的电磁场理论及实验的结果不同.利用三维时域有限差分法对金纳米粒子的SERS活性与其尺寸以及入射光波长的关系进行模拟计算.在632.8 nm激发线下,金纳米粒子二聚体体系在粒径为110 nm左右具有最佳增强效应,其光电场耦合最强的热点处的增强因子高达109考虑到体系的平均SERS增强因子通常会比最大值低约2个数量级,计算得到的107的增强因子与实验测量值相符.同时对目前实验上尚难以合成的大尺寸的金纳米粒子进行模拟,结果表明受多极矩和大尺寸效应的影响在粒径220 nm时又出现SERS增强另一峰值.在325 nm的紫外激发线下,计算得到的增强因子仅为102.     

Indentation fracture and indentation delamination in ZnO film/Si substrate systems

ZnO films with thicknesses ranging from 0.202 to 1.535?µm were deposited by using the magnetron sputtering technique on Si (100) substrates 525?µm thick. Then, Vickers indentation tests were carried out on the ZnO/Si systems at room temperature, in which the applied load varied from 10?mN to 2.0?N. The experimental results show that only indentation-induced radial cracking occurred in the systems with film thicknesses equal to and thinner than 0.554?µm, from which the residual stress in the films was extracted to be 387?MPa in compression. For the systems with film thicknesses equal to and thicker than 0.832?µm, only indentation-induced delamination occurred when indentation loads were low. Under high indentation loads, radial cracking concurrently occurred with delamination. The radial cracks were invisible at the film surfaces because the crack length was smaller than the delamination size. The critical film thickness for indentation-induced delamination was found to be around 0.7?µm for the ZnO/Si systems. Combining the composite hardness models with the indentation-induced delamination model, we developed a method to determine the interfacial fracture energy between a film and its substrate. The novel method is particularly useful for indentation equipment without any displacement measurement devices. Using the new method, we extracted the interfacial fracture energy to be about 12.2?J?m^?2 and from 9.2 to 11.7?J?m^?2 for the cases without and with buckling respectively of delaminated films. Consequently, the pure mode I interfacial fracture energy was calculated to be 10.4?J?m^?2 for the ZnO/Si systems.     

原位微区X射线荧光分析在矿物学研究中的应用

从新疆采集了13件岩矿石样品,用于研究蚀变过程中矿物的元素含量变化特征。成都理工大学研制的IED-6000型原位微区X射线荧光分析仪被应用于获得蚀变过程中矿物的化学和物理数据。这种无损的微区X射线荧光分析仪主要是以低功耗X光管和电致冷Si-PIN半导体探测器为基础,采用毛细管X射线透镜实现微区测量的功能,并且能够集成到任何显微镜上进行测量,焦斑长轴直径约110 μm。通过微区X射线荧光测量,将黝铜矿更正为黄铁矿,提高了矿物鉴定的效率及准确性;在蚀变剖面研究中,矿化岩石样品的长石颗粒都富含Cu和Zn元素,可以作为找矿直接指示元素。Cr,Mn和Co等元素含量与矿化程度呈负相关。     

碳酸二苯酯与1,4-丁二醇酯交换反应馏分的气相色谱分析

采用毛细管气相色谱法对碳酸二苯酯(DPC)与1,4-丁二醇(BD)酯交换反应生成的馏分进行了分析。Equity~(TM)-1非极性柱为分析柱,FID为检测器。结果表明,本法具有良好的线性关系;DPC、BD和苯酚的检出限分别为4.08×10~(-4)、4.30×10~(-3)、2.31×10~(-4)g/L;回收率范围在95.0%—103.3%之间;相对标准偏差均小于5.0%。     

氢稀释对纳米晶硅薄膜晶化特性的影响及薄膜生长机理

以SiH₄与H₂作为前驱气体,采用射频等离子增强化学气相沉积技术制备了纳米晶硅薄膜.利用Raman散射和红外吸收光谱等技术,对不同氢稀释比条件下薄膜的微观结构和键合特性进行了研究.结果表明,随着氢稀释比增加,薄膜的晶化率明显提高,而氢稀释比过高时,薄膜晶化率呈现减少趋势.红外吸收光谱分析表明,纳米晶硅薄膜中氢的键合模式与薄膜的晶化特性密切相关.随着氢稀释比增加,薄膜中整体氢含量和SiH₂键合密度明显减少,而在高氢稀释比条件下,氢稀释比增加导致薄膜中SiH₂键合密度和整体氢含量增加.     

高温超导电缆直流测试电源平台的搭建

根据高温超导电缆测试用直流电源平台的要求,建立了硬件平台。该平台为模块化结构,具有输出精度高,便于扩展等特点;为方便操作,建立了基于LabVIEW的软件平台,对直流电源平台进行远程控制,并给出了远程控制的程序流程图,实现了电流的匀速上升和下降以及上升过程中的中断操作;利用该电源平台进行了超导电缆的临界电流测试实验,验证了直流电源平台符合高温超导电缆的测试要求。