Development of an LC‐MS/MS method for determining the pharmacokinetics of clonidine following oral administration of Zhenju antihypertensive compound

Zhenju antihypertensive compound (ZJAHC) is a combined Chinese–Western medicine formula including clonidine (CLO), hydrochlorothiazide (HCT), rutin, Chrysanthemum indicum extract and pearl powder. Compared with CLO preparations, ZJAHC shows improved activities and decreased adverse effects. It is believed that the side effects of CLO are caused by its high peak plasma concentration. Hence, study of the influence of ZJAHC on the pharmacokinetic behaviors of clonidine seems essential. In present study, the plasma concentrations of CLO were determined with a liquid chromatography–tandem mass spectrometry (LC‐MS/MS) method. The MS/MS transitions monitored for clonidine and internal standard were 230.2 → 213.1 and 152.2 → 110.2, respectively. The analyte was quantified in a single run within 3 min. The pharmacokinetic study showed that the area under the plasma concentration–time curve of CLO in ZJAHC (60 µg/kg CLO) was similar to that of CLO‐HCT‐high (120 µg/kg CLO) but the peak concentration was much lower than that in CLO‐HCT‐high. ZJAHC could enhance the bioavailability without greatly increasing peak concentration of clonidine. This comprehensive effect of enhancing the bioavailability and avoiding the high peak plasma concentration for CLO might mainly result from the co‐contribution of Western medicine and traditional Chinese medicine (TCM), while the effect of TCM was stronger than that of Western medicine. Copyright © 2014 John Wiley & Sons, Ltd.     

Solving nonnegative sparsity-constrained optimization via DC quadratic-piecewise-linear approximations

Journal of Global Optimization - In this paper, we propose a novel algorithm that is based on quadratic-piecewise-linear approximations of DC functions to solve nonnegative sparsity-constrained...     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

超临界流体色谱流程设计及其应用

本文设计了多功能超临界流体色谱流程,流程中包括毛细管/微填充柱SFC,GC,计算机控制温度、压力、密度及信号采集、处理,配置有超临界流体萃取池,解决了超临界流体色谱分流口易堵问题。利用该流程,将石腊、DC-200气相色谱固定相、黄油、蜂蜡、救心油、红花油等样品进行超临界流体色谱分离。     

Multiflorin,A New Secoiridold Lactone from Jasminum Multiflorum

A new secoiridoid, multiflorin (1) has been isolated from the EtOAc-soluble fraction of Jasminum multiflorum (Oleaceace). The structure of I was determined by application of spectral methods.     

油水两液相一维非等温渗流的传递分析

在求解油水两液相非等温渗流的温度场、压力场基础上,以驱动功、驱动功率、驱动阻力、驱动速率为特征参数,对该过程进行(火用)传递分析。数值模拟的结果表明:含水通过降低油的相对渗透率、从而增大驱动阻力、减小驱动功率, 最终导致原油产量降低。     

A profit-maximizing supply chain network design model with demand choice flexibility

We present a profit-maximizing supply chain design model in which a company has flexibility in determining which customers to serve. The company may lose a customer to competition if the price it charges is too high. We show the problem formulation and solution algorithm, and discuss computational results.     

EXISTENCE OF PERIODIC SOLUTIONS OF SYSTEM OF DIFFERENCE EQUATIONS

This paper studies the nonautonomous nonlinear system of difference equationsΔx(n)=A(n)x(n)+f(n,x(n)),n∈Z,(*) where x(n)∈R~N,A(n)=(a_(ij)(n))N×N is an N×N matrix,with a-(ij)∈C(R,R) for i,j= 1,2,3,...,N,and f=(f_1,f_2,...,f_N)~T∈C(R×R~N,R~N),satisfying A(t+ω)=A(t),f(t+ω,z)=f(t,z) for any t∈R,(t,z)∈R×R~N andωis a positive integer.Sufficient conditions for the existence ofω-periodic solutions to equations (*) are obtained.     

Stationary turbulent closure via the Hopf functional equation

Exact closed-form solutions are exhibited for the Hopf equation for stationary incompressible 3D Navier-Stokes flow, for the cases of homogeneous forced flow (including a solution with depleted nonlinearity) and inhomogeneous flow with arbitrary boundary conditions. This provides an exact method for computing two- and higher-point moments, given the mean flow.     

Formation of hydrogenated amorphous carbon films from polymer pyrolysis

Free-standing and supported hydrogenated amorphous carbon films (a:C–H) were prepared upon pyrolysis of the polymer formed by ethanolamine (EA) and citric acid (CA), under an ambient atmosphere at 300 °C. EA facilitates the formation of the macroscopic films, while CA is essential for obtaining the a:C–H microstructure, which comprises a mixture of sp² and sp³ carbon. Received: 29 May 2001 / Accepted: 17 August 2001 / Published online: 20 December 2001