Macroporous poly(methyl methacrylate) produced by phase separation during polymerisation in solution

Polymethyl methacrylate (PMMA) sponges were obtained by polymerization in a solution with monomer/ethanol ratios up to 20:80. The material obtained after the elimination of the solvent present a homogeneous distribution of dispersed pores up to a monomer/ethanol ratio lower than 40:60. For higher ethanol contents in the reacting mixture, the morphology of the sponge corresponds to a network of PMMA microparticles, leaving large empty spaces leading to highly porous structure. The monomer/ethanol ratio during polymerization has a large influence on the porosity, thermal, and mechanical properties of the material and, for large solvent contents, on the size of the polymer microparticles.     

反对数微分简易示波伏安法的研究

在获得微分简易地波伏安图的实验线路中,增加了反对数装置,提出了反对数微分简易示波伏安法。该方法被应用于铝合金中微量铜和分子筛中微量钴的测定,获得了满意结果。     

电泳中介微分析法测定超氧化物歧化酶

基于超氧化物歧化酶(SOD)对邻苯三酚自氧化的抑制作用和电泳中介微分析(EMMA)技术建立了一种测定SOD的新方法。采用“三明治”式不同pH缓冲液部分填充法,有利于邻苯三酚的自氧化反应,便于观察SOD的抑制作用,有利于反应产物与反应物的分离。对溶液填充模式、反应条件等实验参数进行了优化。在最优条件下,邻苯三酚自氧化反应的抑制率I与SOD浓度C在1.00×102~6.00×102μg/L范围内呈良好的线性关系,回归方程为:I(%)=0.0895C(μg/L) 17.633(r=0.9973)。     

甲醇催化分解动力学之研究

甲醇的裂解产物为H_2与CO,故甲醇被视为一种方便、安全的贮氢材料,可作为汽油的代用燃料;其裂解气作为保护气氛可广泛应用于热处理工业。甲醇裂解有两种方法,高温热裂解(约930℃)与低温催化裂解(约300℃)由于低温催化裂解有诸多优点,在工业上的应用正在发展。     

壁喷电池在流动注射阳极溶出伏安法中的应用

在流动注射阳极溶出伏安法中应用壁喷电池,探讨了非稳定态电积过程的溶出峰电流理论方程,预言了峰电流正比于R~(3/4)(R为工作电极半径),并对有关参数进行了实验验证。对5×10~(-7)mol/L Cd(Ⅱ)连续测定40次,表明相对标准偏差为0.94％。     

锌试剂分光光度法测定壳聚糖含量

利用锌试剂与壳聚糖在一定酸度条件下的特异性显色反应，即其复合物在465nm处吸光度与壳聚糖含量在0～O．04g／L范围内呈现良好的线性关系(R=0．996)，基于此建立了一种简便快速的分光光度法。平均回收率为99．68％。     

钴（Ⅱ）与2,2’-联吡啶-1,1’-二氧化物的多核配合物的合成和性质

以无水CoCl2和2,2’-联吡啶-1,1’-二氧化物为原料,在DMF溶剂中合成了一种多核配合物.经元素分析、紫外光谱、红外光谱和摩尔电导等方法测得它的组成为[Co3(bipyO2)4Cl4]Cl2,并对该配合物的气敏特性进行了研究. 结果表明, 该配合物对氨气有良好的敏感性和选择性.由它制作的传感器可望用于涉氨化工生产中氨浓度的自动测量和控制.     

Rh complexes of 1-(2,4,6-triisopropylphenyl-)3-methyl-1H-phosphole: preparation and use as catalysts in the hydroformylation of styrene

In the series of 1-(2,4,6-trialkylphenyl-)3-methyl-1H-phospholes (1a–c) that are to a certain extent of aromaticity, only the isopropyl substituted one (1a) entered into reaction with dimeric (pentamethylcyclopentadienyl)rhodium dichloride to afford Rh(III) complex (2a) in a reversible manner. After a careful workup, (2a) could be prepared and characterized whose stereostructure was elucidated by B3LYP/3–21G*, B3LYP/6–31G* and LANL2DZ calculations. Complex (2a) as a preformed catalyst, as well as the Rh(acac)(CO)₂ + 2(1a) in situ catalytic system were useful in the hydroformylation of styrene and gave the branched aldehyde in regioselectivities of 65–96%.     

全氟辛基磺酸酸度函数H0的测定

It is reported in this paper that the acidity function H_0 of perfluorooctanesulfonic acid (POSA) is -12.11±0.03, which was measured first time by ~1H NMR method, in term of the α-H chemical shifts of the acid-ether systems, using 98% to 100% H_2SO_4 as reference standards. This method provides a new procedure for measuring the H_0 value of solid perfluoroalkanesulfonie acid C_nH_(2n+1)SO_3H(n>7).     

有机硅耐磨透明涂层的固化分析

ＦＴＩＲ、ＴＧ、ＴＢＡ等对有机硅耐磨涂料（有机硅溶胶）的热固化过程研究表明有机硅胶体中缔合羟基间的脱水缩合速率很高；羟基脱水程度与固化温度有关，温度越高，达平衡时羟基的浓度越低，在１０５～１３０℃间羟基的浓度变化最大，加入适当的固化剂，对羟基的脱水交联有促进作用，在较高的固化温度下，反应体系中出现了环氧环异构化产生的酮羰基的吸收峰