全光纤光子集成器件及系统

本对全光纤光子集成器件与系统进行了较为全面地综述,结合我们的工作,对目前的研究热点：光纤光栅,光纤激光器,光纤放大器,光纤光栅分插器与传感器等诸多光子器件以及由这些器件组成的波分复用通信系统进行了介绍和评述,一些新成果和新进展表明,这些光子器件与系统在当今和未来的光通信中将发挥重要作用。     

Dual-wavelength distributed Bragg reflector semiconductor laser based on a composite resonant cavity

We report a monolithic integrated dual-wavelength laser diode based on a distributed Bragg reflector (DBR) composite resonant cavity. The device consists of three sections, a DBR grating section, a passive phase section, and an active gain section. The gain section facet is cleaved to work as a laser cavity mirror. The other laser mirror is the DBR grating, which also functions as a wavelength filter and can control the number of wavelengths involved in the laser action. The reflection bandwidth of the DBR grating is fabricated to have an appropriate value to make the device work at the dual-wavelength lasing state. We adopt the quantum well intermixing (QWI) technique to provide low-absorption loss grating and passive phase section in the fabrication process. By tuning the injection currents on the DBR and the gain sections, the device can generate 0.596 nm-spaced dual-wavelength lasing at room temperature.     

Tribological Behavior of Multiply-Alkylated Cyclopentanes (MACs)-Cu Nanoparticles Composite Thin Film

Multiply-alkylated cyclopentanes (MACs) composite thin films containing Cu nanoparticles are fabricated on the octadecyltrichlorosilane (OTS)-modified substrate by a spin-coating technique. The thickness, wetting behavior, and nanoscale morphologies of the films are characterized by means of ellipsometry, contact angle measurement, and atomic force microscope (AFM). The friction and wear behaviors of the thin films sliding against Si₃N₄ ball are examined on a UMT-2MT tribometer in a ball-on-disk contact mode. The worn surfaces of the OTS-MAC-Cu composite film and the counterpart Si₃N₄ balls are investigated with a scanning electron microscope. Water contact angle on OTS-MAC-Cu composite film is higher than that of OTS-MAC film. OTS-MAC-Cu composite film exhibits higher load-carrying capacity and better friction reduction and antiwear behavior as compared with OTS-MAC film. This may be attributed to the load-carrying and self-repairing property of the Cu nanoparticles in the composite film and the formation of a transfer layer composed of OTS, MAC, and Cu on the rubbing surface of the counterpart ball.     

平行板电流电感梯度的近似计算与仿真

大学物理的电磁学部分,对后续理论课程和工程应用都十分重要.在讲授时可以将基本物理理论与前沿科研应用相结合,培养学生的创新思维,同时使得物理知识贴近生活,具有鲜明的时代特征.提出了一种平行板电流电感梯度的近似计算方法,并利用有限元软件进行仿真,分析了该近似方法的适用条件.     

Comparative study of different Schlieren diffracting elements

This paper presents an analysis of diffraction effects taking place at different Schlieren diffracting elements. Two types of diffraction effects are prominent in the Schlieren schemes. One is diffraction of direct light (source image) at the Schlieren element, which limits the sensitivity and resolution of Schlieren systems. The second type is the diffraction of light deflected from the test object at the Schlieren-diffracting element. This second type of diffraction degrades the quality of Schlieren results. Experimental results showing the effect of diffraction of light deflected from the test object at a phase knife-edge, corner of a square phase aperture and an optical fiber tip as Schlieren diffracting elements have been presented and discussed.      

基于低相干光的阵列透镜束匀滑技术研究

基于激光加载的材料状态方程的实验研究对靶面光强分布的均匀性及稳定性提出了极高的要求,靶面光强的上述两大特性在很大程度上决定了实验结果的精度和可重复性.本文针对传统窄带高相干激光装置在激光加载材料状态方程实验中表现出的靶面光强均匀性和光强分布稳定性两方面可能存在的问题,提出了基于宽带低相干激光,利用消衍射阵列透镜联合诱导非相干技术的束匀滑方案,并重点分析了波前相位畸变对靶面不均匀性及稳定性的影响.模拟结果表明,该方法明显降低了靶面不均匀性,提高了对波前相位畸变的包容度,获得了均匀、稳定的光强分布.统计分析显示,焦斑强度分布极差和不均匀性与波前相位畸变均方根梯度相关性较强.因此,可以根据统计结果以及实验对焦斑强度分布的要求,给出波前相位畸变的容差范围,对状态方程实验中激光驱动器参数的设计与优化具有指导意义.     

进气畸变对压气机稳定性的影响

在低速大尺寸单级压气机实验器上,实验研究了动态进气畸变对压气机稳定边界的影响。并采取在静子叶片表面埋入微型压力传感器的方法,分析了压气机流场的动态压力特性。实验结果表明,动态总压畸变的旋转频率和旋转方向对压气机稳定性有很大的影响,当畸变相对转速n在0~+0．5之间时,压气机失速推迟;分析动态压力的频谱特性后知道,在压气机失速前一般存在与失速相关的压力扰动,动态总压畸变影响这种压力扰动,从而影响压气机的不稳定流动状态。     

利用可见近红外光谱多指标综合预测生鲜牛肉储存期

建立了牛肉基于TVB-N、菌落总数、pH值和肉色参数L*多个指标的储存期预测模型,利用可见近红外光谱(Vis/NIR)技术结合区间偏最小二乘(iPLS)和遗传算法(GA)建立了各个指标的PLS预测模型,实现了多指标综合无损快速预测4 ℃下牛肉的储存期。用iPLS和iPLS-GA提取有效波长变量建立PLS预测模型,以预测相关系数和预测标准差作为模型评价标准,结果表明用iPLS-GA选择变量建立的各个指标的PLS预测模型均优于全波段和iPLS组合的PLS模型。由多个指标的预测值和储存期的预测模型,对校正集和预测集样品储存期进行预测,其预测相关系数和标准差分别是0.903, 0.897和1.88, 2.24。说明利用光谱技术结合得出的储存期预测模型可以实现多指标综合预测牛肉储存期,为无损快速检测牛肉储存期或货架期提供了一种新方法。      

基于拉曼光谱法的降糖类药物的判别方法比较

采用了四种聚类方法对降糖类药物拉曼光谱进行了快速、无损判别。采集九种降糖类药品共48个样品的拉曼光谱,经截波、基线校正、平滑、矢量归一化等预处理后,分别采用K-均值、系统聚类法、自组织图(SOM)及PCA-SOM四种不同聚类方法做聚类判别。结果表明,自组织图与K-均值、系统聚类法相比,聚类结果较好,并且SOM结合PCA后的PCA-SOM结果最优。为降糖类药品的快速判别从聚类的角度提供了一种新的方法。     

Derivation of baroclinic Ertel–Rossby invariant-based thermally-coupled vorticity equation in moist flow

For the potential vorticity （PV） invariant, there is a PV-based complete-form vorticity equation, which we use heuris- tically in the present paper to answer the following question： for the Ertel-Rossby invariant （ERI）, is there a corresponding vorticity tendency equation？ Such an ERI-based thermally-coupled vorticity equation is derived and discussed in detail in this study. From the obtained new vorticity equation, the vertical vorticity change is constrained by the vertical velocity term, the term associated with the slope of the generalized momentum surface, the term related to the horizontal vorticity change, and the baroclinic or solenoid term. It explicitly includes both the dynamical and thermodynamic factors＇ influence on the vorticity change. For the ERI itself, besides the traditional PV term, the ERI also includes the moisture factor, which is excluded in dry ERI, and the term related to the gradients of pressure, kinetic energy, and potential energy that reflects the fast-manifold property. Therefore, it is more complete to describe the fast motions off the slow manifold for severe weather than the PV term. These advantages are naturally handed on and inherited by the ERI-based thermally-coupled vorticity equation. Then the ERI-based thermally-coupled vorticity equation is further transformed and compared with the traditional vorticity equation. The main difference between the two equations is the term which describes the contribution of the solenoid term to the vertical vorticity development. In a barotropic flow, the solenoid term disappears, then the ERI-based thermally-coupled vorticity equation can regress to the traditional vorticity equation.