四（对羟基苯基）卟啉—硅胶固定相的合成及在核苷酸分析中的应用

以大孔微硅胶作基体，经γ－氨丙基三乙氧基硅烷活化与间隔臂氯代环内烷反应后，再与预先合成的四（对羟基苯基）卟啉配体键合，构成电荷转移型亲和色谱固定相。以ＰＨ＝７．０的磷酸盐缓冲溶液作流动相，成功实现对一些核苷酸的高效液相亲和色谱分离。     

氰根桥连的异金属配位聚合物{[Ni(pn)2][Fe(CN)4(bipy)]}2·3H2O(pn=1,3-丙二胺,bipy=2,2′-联吡啶)的合成与结构

以[Fe(CN)₄(bipy)]^2-为建筑块和[Ni(pn)₂]²⁺在水溶液中反应,合成了{[Ni(pn)₂][Fe(CN)₄(bipy)]}₂·3H₂O(pn=1,3-丙二胺)。通过X-射线单晶衍射确定了其晶体结构。该配合物属单斜晶系,P2₁/n空间群,晶胞参数为:a     

热定型聚酯纤维内应力与晶格变形的关系

<正> 结晶学家认为低分子物结晶虽可能存在一定缺陷和变形,但一般都具有一定的晶胞参数。这一概念对于高分子物结晶已不再正确。Bosley认为成形、热处理、冷却速率和杂质的存在皆可引起晶格变形;Fakirov故意在PET中加入少量杂质,却未引起变形。至今,PET已累积了7组晶胞参数,8个计算所得的晶区密度显示了较大幅度的波动(见     

A spectroscopic study on the 12-heteropolyacids of molybdenum and tungsten (H3PMo12−nWnO40) combined with cetylpyridinium bromide in the epoxidation of cyclopentene

The epoxidation of cyclopentene with hydrogen peroxide catalyzed by 12-heteropolyacids of molybdenum and tungsten (H₃PMo_12−nW_nO₄₀, n = 1–11), 12-tungstophosphoric acid and 12-molybdophosphoric acid combined with cetylpyridinium bromide as a phase transfer reagent was carried out in acetonitrile. Among 13 heteropolyacids investigated, catalyst of H₃PMo₆W₆O₄₀ showed the highest activity, giving a conversion of 60% and a selectivity of 95% in the epoxidation of cyclopentene. The fresh catalysts and the catalysts under reaction condition were characterized by UV–vis, FT-IR and ³¹P NMR spectroscopy, which has revealed that all of the molybdotungstophosphoric acids were degraded in the presence of hydrogen peroxide to form a considerable amount of phosphorus-containing species. The active species resulted from H₃PMo₆W₆O₄₀ are new kinds of phosphorus-containing species, which is different from {PO₄[WO(O₂)₂]₄}³⁻.     

Zirconium and hafnium complexes containing bidentate diarylamido-phosphine ligands

The first examples of mononuclear, structurally characterized triarylphosphine complexes of zirconium and hafnium are reported. The metathetical reactions of MCl4(THF)2 (M = Zr, Hf) with [iPrNP]Li(THF)2 ([iPrNP]- = N-(2-(diphenylphosphino)phenyl)-2,6-diisopropylanilide) or [MeNP]Li(THF)2 ([MeNP]- = N-(2-(diphenylphosphino)phenyl)-2,6-dimethylanilide) in toluene at -35 degrees C produced the corresponding [iPrNP]MCl3(THF) and [MeNP]2MCl2, respectively, in high yield. In contrast, attempts to prepare [MeNP]MCl3(THF) and [iPrNP]2MCl2 led to the concomitant formation of mono- and bis-ligated complexes, from which purification proved rather ineffective. The solution and solid-state structures of [iPrNP]MCl3(THF) and [MeNP]2MCl2 were studied by multinuclear NMR spectroscopy and X-ray crystallography. The geometry of these six-coordinate complexes is best described as a distorted octahedron in which the chloride ligands in [iPrNP]MCl3(THF) adopt a virtually meridional coordination mode whereas those in [MeNP]2MCl2 are trans to each other.     

甲醇与乙醇一步合成异丁醛用CuO-ZnO/Al2O3催化剂

在ＣｕＯ－ＺｎＯ／Ａｌ２Ｏ３催化剂上，甲醇与乙醇在常压和２１０￣３６０℃温度下一步反应合成异丁醛。利用正交设计方法，研究了ＣｕＯ－ＺｎＯ／Ａｌ２Ｏ３体系催化剂组成和制备条件等因素对催化剂催化性能的影响。结果表明，催化剂中ＣｕＯ含量对催化剂的催化活性影响最大，而ＺｎＯ含量则主要影响催化剂对异丁醛的选择性。催化剂制备条件，如沉淀温度、陈化时间等，也不同程度也影响催化剂的催化性能。ＸＲＤ和ＢＥＴ表征结果     

Cu，Pd－ZSM－5上NO分解和CO氧化的催化作用

双交换Ｃｕ，ｐｄ－ＺＳＭ－５催化剂（Ｃｕ交换度为１０５％，Ｐｄ交换度分别为３．４％和３３％）对ＣＯ氧化反应有活性增强作用，对ＮＯ分解反应不存在增强效应．双交换催化剂在于交换程序不同，而表面物种不同，活性组分的分布状态不同，因而有不同的活性．先交换Ｃｕ，４００℃焙烧后再交换ｐｄ的Ｃｕ－Ｐｄ－ＺＳＭ－５催化剂，对上述两类反应的活性存双组分催化剂中均为最高．Ｈ_２－ＴＰＲ谱表明，共交换的Ｃｕ－Ｐｄ－ＺＳＭ－５中尚有部分ＣｕＣｌ＋占据了部分交换位置，而使ＣＯ氧化活性稍有下降．Ｎ_２－ＤＴＡ和Ｈ_２－ＴＰＲ谱结果表明，Ｐｄ交换到Ｃｕ－ＺＳＭ－５中后，抑制了吸附水和水合铜化合物的形成，由此提高了在２００—３００℃时氧的吸附量．后者的大小和ＣＯ氧化活性有顺变关系．Ｎ_２－ＤＴＡ谱中３４０—４４５℃的放热峰可能分别表征了和ＮＯ分解活性有关的铜氧桥或把氧桥的形成，该放热峰的峰温愈低，峰面积愈大，则ＮＯ分解活性愈高．     

芳亚甲基丙二腈、芳亚甲基氰乙酰胺的固相合成

芳醛和丙二腈、氰乙酰胺在NH4Ac催化下经固相反应高产率的得到芳亚甲基丙 二腈和芳亚甲基氰乙酰胺。     

超细Ni-Cu-Co-La的制备及其催化乙腈加氢性能

以水合肼和硼氢化钾为共还原剂制备了四元合金催化剂Ni-Cu-Co-La,并将其应用于乙腈催化加氢反应.采用X射线衍射、X射线光电子能谱、透射电镜和H2程序升温脱附对催化剂进行了表征,考察了催化剂组分对乙腈选择性加氢制乙胺催化性能的影响.结果表明,Cu,Co和La的加入均不同程度地提高了催化剂的活性和选择性,在反应压力1.8 MPa,反应温度120℃,反应时间1 h的条件下,乙腈转化率和乙胺选择性分别为100%和98.24%,优于使用Raney Ni、非晶态Ni-B和Co-B合金催化剂时的结果.