Optical properties of nanostructure boron doped NiO thin films

Boron doped NiO films were prepared by sol–gel method. The effects of B content on the morphological and optical properties of NiO films were studied with atomic force microscopy, and optical characterization method. The average transmittance at the visible region is reached to 75 % for lower doped films (0.1 and 0.2 % B), whereas, the recorded average value of transmittance was about 62 % for doped film with 1 % B throughout the region. The optical energy gap value for pure NiO film was found to be 3.73 eV. These values were affected by B doping with non-monotonic variation and reached to 3.64 eV for 0.1 % B doped NiO. Also, the refractive index dispersion and dielectric constants of the NiO films were studied throughout the investigated range of wavelengths. The obtained results indicate that the optical parameters of the NiO film are controlled with boron doping.     

Curves in the Minkowski plane and their contact with pseudo-circles

We study the caustic, evolute, Minkowski symmetry set and parallels of a smooth and regular curve in the Minkowski plane.     

Bimolecular electron transfers that deviate from the Sandros-Boltzmann dependence on free energy: steric effect

As we reported recently, endergonic to mildly exergonic electron transfer between neutral aromatics (benzenes and biphenyls) and their radical cations in acetonitrile follows a Sandros-Boltzmann (SB) dependency on the reaction free energy (ΔG); i.e., the rate constant is proportional to 1/[1 + exp(ΔG/RT)]. We now report deviations from this dependency when one reactant is sterically crowded: 1,4-di-tert-butylbenzene (C1), 1,3,5-tri-tert-butylbenzene (C2), or hexaethylbenzene (C3). Obvious deviation from SB behavior is observed with C1. Stronger deviation is observed with the more crowded C2 and C3, where steric hindrance increases the interplanar separation at contact by ~1 ?, significantly decreasing the π orbital overlap. Consequently, electron transfer (k(et)) within the contact pair becomes slower than diffusional separation (k(-d)), causing deviation from the SB dependency, especially near ΔG = 0. Fitting the data to a standard electron-transfer theory gives small matrix elements (~5-7 meV) and reasonable reorganization energies. A small systematic difference between reactions of C3 with benzenes vs biphenyls is rationalized in terms of small differences in the electron-transfer parameters that are consistent with previous data. The influence of solvent viscosity on the competition between k(et) and k(-d) was investigated by comparing reactions in acetonitrile and propylene carbonate.     

Development and evaluation of a monolithic floating drug delivery system for acyclovir

Acyclovir (ACV), a model drug for this study, is one of the most effective drugs against viruses of the herpes group. Absorption of orally administered ACV is variable and incomplete, with a bioavailability of ca. 15-30%. The drug is absorbed in the duodenum after oral administration and hence, preparation of a floating drug delivery system (FDDS) for ACV may increase oral absorption of the drug. ACV matrix tablets (200?mg) containing an effervescent base (sodium bicarbonate and citric acid) and a binary combination of hydroxypropyl methylcellulose (HPMC) K4M with carbopol or sodium carboxymethyl cellulose (Na CMC) or polyvinylpyrrolidone (PVP) and/or sodium alginate were prepared by the direct compression method. The tablets were evaluated for physicochemical properties and in vitro floating ability (floating lag-time and duration), bioadhesiveness and drug release. The drug release studies were carried out in 0.1?N HCl (pH 1.2) at 37±0.5°C. At appropriate time intervals, samples were withdrawn and assayed spectrophotometrically at λ(max)=259?nm. The floating test showed tablets containing 15% effervescent base had a floating lag time of 10-30?s and a duration of floating time of 24?h. The formulations containing HPMC-PVP, HPMC-Na CMC, HPMC-carbopol, and HPMC-sodium alginate released about 60-90% of their drug content during a 12-h period. Increasing carbopol caused slower drug release. We concluded that the proposed tablets with 15% effervescent base, 20-30% HPMC, 30% Na CMC (and/or 20% PVP or 20% sodium alginate) showed good floating and drug release properties in vitro, and should be considered as FDDS for ACV.     

Coupled-mode analysis for linear fiber Bragg grating made of metamaterial

We derive the coupled-mode equations for a metamaterial fiber Bragg gratings (FBGs). The coupled-mode theory describing wave propagation in periodic structures such as FBG is generalized for studying the transmission and reflection of electromagnetic waves through a FBG containing metamaterial layers. This approach shows that the band gap becomes broader in comparison with a conventional FBG. It is observed that the central frequency of the band gap has a shift in regard of changing metamaterial thickness. We verify this investigation through attaining the transmission and reflection spectra of a conventional FBG while we are setting related parameters. Furthermore, this proposed structure can be applied as a tunable filter.     

An output-feedback adaptive actuator failure compensation controller for systems with unknown state delays

This paper presents an output-feedback adaptive controller for a class of linear systems with unknown time-varying state delay and in the presence of actuator failures. We consider a common type of actuator failure in which some unknown system inputs may be stuck at some unknown fixed values and at unknown time instants. The adaptive controller is designed based on SPR–Lyapunov approach for relative degree one and two cases. Closed-loop system stability and asymptotic output tracking are proved using suitable Lyapunov–Krasovskii functional for each case. Simulation results are provided to demonstrate the effectiveness of the proposed results.     

Comparison of the activation time effects and the internal energy distributions for the CID,PQD and HCD excitation modes

Reproducibility among different types of excitation modes is a major bottleneck in the field of tandem mass spectrometry library development in metabolomics. In this study, we specifically evaluated the influence of collision voltage and activation time parameters on tandem mass spectrometry spectra for various excitation modes [collision‐induced dissociation (CID), pulsed Q dissociation (PQD) and higher‐energy collision dissociation (HCD)] of Orbitrap‐based instruments. For this purpose, internal energy deposition was probed using an approach based on Rice–Rampserger–Kassel–Marcus modeling with three thermometer compounds of different degree of freedom (69, 228 and 420) and a thermal model. This model treats consecutively the activation and decomposition steps, and the survival precursor ion populations are characterized by truncated Maxwell–Boltzmann internal energy distributions. This study demonstrates that the activation time has a significant impact on MS/MS spectra using the CID and PQD modes. The proposed model seems suitable to describe the multiple collision regime in the PQD and HCD modes. Linear relationships between mean internal energy and collision voltage are shown for the latter modes and the three thermometer molecules. These results suggest that a calibration based on the collision voltage should provide reproducible for PQD, HCD to be compared with CID in tandem in space instruments. However, an important signal loss is observed in PQD excitation mode whatever the mass of the studied compounds, which may affect not only parent ions but also fragment ions depending on the fragmentation parameters. A calibration approach for the CID mode based on the variation of activation time parameter is more appropriate than one based on collision voltage. In fact, the activation time parameter in CID induces a modification of the collisional regime and thus helps control the orientation of the fragmentation pathways (competitive or consecutive dissociations). Copyright © 2014 John Wiley & Sons, Ltd.     

Maxima and minima of the displacement components for the Lamb modes

This paper revisits the vanishing of the transverse component of the particle displacement vector in free surfaces of an isotropic homogeneous plate, for both symmetric and antisymmetric Lamb waves. Drawing on well-known analytical expressions from Viktorov's book [(1967) Rayleigh and Lamb Waves: Physical Theory Applications, Chap. II, pp. 67-121], two distinct frequency-thickness product expressions, in cases where this vanishing occurs, are derived: one for the symmetric modes and another for the antisymmetric modes. At these frequency-thickness products, phase and group velocities have appreciable values which are discussed herein. It appears that these velocities depend on the transverse bulk wave velocity only. This is the specific condition of the Lame? modes. Moreover, theoretical and experimental investigations of displacements in the surface of a plate in air have been carried out. The theoretical part shows that the normal and transverse displacements have, respectively, a local maximum and a local minimum in the vicinity of these frequency-thickness products. The experimental part corroborates the presence of the local maximum of the S(0) Lamb mode for various materials.     

Green ultrasound-assisted extraction of carotenoids based on the bio-refinery concept using sunflower oil as an alternative solvent

A green, inexpensive and easy-to-use method for carotenoids extraction from fresh carrots assisted by ultrasound was designed in this work. Sunflower oil was applied as a substitute to organic solvents in this green ultrasound-assisted extraction (UAE): a process which is in line with green extraction and bio-refinery concepts. The processing procedure of this original UAE was first compared with conventional solvent extraction (CSE) using hexane as solvent. Moreover, the UAE optimal conditions for the subsequent comparison were optimized using response surface methodology (RSM) and ultra performance liquid chromatography – diode array detector – mass spectroscopy (UPLC–DAD–MS). The results showed that the UAE using sunflower as solvent has obtained its highest β-carotene yield (334.75 mg/l) in 20 min only, while CSE using hexane as solvent obtained a similar yield (321.35 mg/l) in 60 min. The green UAE performed under optimal extraction conditions (carrot to oil ratio of 2:10, ultrasonic intensity of 22.5 W cm^?2, temperature of 40 °C and sonication time of 20 min) gave the best yield of β-carotene.