Changes in calmodulin main-chain dynamics upon ligand binding revealed by cross-correlated NMR relaxation measurements

The fast dynamics of protein backbones are often investigated by nuclear magnetic relaxation experiments that report on the degree of spatial restriction of the amide bond vector. By comparing calmodulin in the peptide-bound and peptide-free states with these classical methods, we observe little difference in the dynamics of the polypeptide main chain (average order parameter decrease of 0.01 unit upon binding). However, when using NMR methods that monitor the mobility of the CO-Calpha bond vector, we reveal a significant reduction of dynamics of the protein main chain (average order parameter decrease of 0.048 units). Previous investigations have suggested that the side-chain dynamics is reduced by an average of 0.07 order parameter units upon ligand binding (Lee, A. L.; Kinnear, S. A.; Wand, A. J. Nat. Struct. Biol. 2000, 7, 72-77). The current findings suggest that the change of the CO-Calpha bond vector dynamics is intermediate between the changes in NH and side-chain dynamics and report a previously undetected loss of main-chain entropy. Weak site-to-site correlations between the different motional indicators are also observed.     

Decrease in activity caused by hydrogen in Ziegler-Natta ethene polymerisation

In this study we prepared seven different Ziegler-Natta catalysts and polymerised them at different hydrogen concentrations in order to investigate their kinetic behaviour during polymerisation. The objective was to see whether the results corresponded to what could be expected on the basis of Kissin's β-agostic deactivation theory. According to this theory, hydrogen causes the formation of dormant sites due to the formation of β-agostic coordination from the ethyl groups formed after hydrogen termination. According to this theory, the more hydrogen that is used, the more β-agostic coupling and the smaller percentage of Ti in a polymerising state. This β-agostic coupling would thus explain the lower activity level seen in polymerisation where more hydrogen has been used.The results of this study showed that none of the catalysts showed the kind of behaviour that would correspond to what could be predicted on the basis of Kissin's theory. Deactivation could be detected only when a lower amount of hydrogen was used. When higher amounts of hydrogen were used in polymerisation there was a clear delay in activation time of the catalysts. This particularly seemed to be the case for catalysts where Ti was present as Ti(IV). This delay in the activation of the catalyst caused a decrease in activity in addition to the normal decrease in activity due to hydrogen replacing C₂^′′ in the polymerisation process.The only catalyst showing no delay in activation was a silica-based PE ZN catalyst where the Ti was already in trivalent form. In this case no decrease in activity was observed in addition to the normal decrease in activity caused by hydrogen replacing C₂^′′ in the polymerisation process.     

The Electronic Structure of Azuleno[1,2,3-cd]phenalene and Azuleno[5,6,7-cd]phenalene,a Comparison

The photoelectron (PE.) spectra of azuleno[l, 2, 3-cd]phenalene ( 1 ) and azuleno- [5,6,7-cd]phenalene( 2 ) have been recorded. The first five bands of both compounds could be assigned to transitions corresponding to removal of electrons from 4a₂, 6b₁, 5b₁, 3a₂ and 4b_l orbitals. This assignment is based mainly on a comparison between the observed ionization potentials and orbital energies calculated in a HMO and a PPP model. The UV./VIS. polarized absorption spectrum of 1 in the region 10000–45000 cm^?1 has been measured by means of the stretched film technique. The measurements were performed in polyethylene sheets at 77°K. Several bands could be assigned to π* ← π transitions calculated by a PPP-CI method. A comparison between the electronic structures of 1 and 2 is made by means of a simple HMO diagram.     

Determination of manganese and zinc in powdered chocolate samples by slurry sampling using sequential multi-element flame atomic absorption spectrometry

In the present work, a slurry sampling flame atomic absorption spectrometric method to determine directly manganese and zinc in powdered chocolate samples is proposed. The optimization step was performed using univariate methodology involving the following factors: nature and concentration of the acid solution, sonication time, and particle size. The established conditions led to the use of a sample mass of 150 mg, 2.0 mol L^− 1 nitric acid solution, sonication time of 15 min, and a slurry volume of 50 mL. This method allows the determination of manganese and zinc with detection limit of 52 and 61 ng g^− 1, respectively, and a precision expressed as relative standard deviation (RSD) of 2.6% and 3.2% (both, n = 10) for contents of manganese and zinc of 52.4 and 100.0 μg g^− 1, respectively. The proposed method was applied for determination of manganese and zinc in five powdered chocolate samples. In these, the manganese content varied from 42.8 to 52.7 and from 88.6 to 102.4 μg g^− 1 of zinc. The analytical results were compared with the results obtained by analysis of these samples after digestion using open vessel and acid bomb digestion procedures and determination using FS-FAAS. The statistical comparison by t-test (95% confidence level) showed no significant difference between these results.     

Empfindliche Methode zur Bestimmung geringer Schwefelgehalte in Wolframoxiden und Wolframpulvern

Zusammenfassung Der Schwefel in Wolframoxiden und Wolframpulvern wird im Wasserstoffstrom bei 800°C in H₂S übergeführt, der in Cadmium-Zinkacetat-Lösung absorbiert und anschließend jodometrisch titriert wird. Die Anwesenheit von WO₃ ermöglicht eine quantitative Umwandlung von Sulfatschwefel in H₂S. Die Standardabweichung beträgt für ein Wolframoxid mit 310 ppm S±13 ppmS und für ein Wolfram-Metallpulver mit 45 ppm S±1 ppm S.

---

Sulfur is converted into hydrogen sulphide by hydrogenation at 800°C. This H₂S is absorbed in a cadmium-zinc acetate solution and titrated iodometrically. The presence of WO₃ makes possible a quantitative conversion of sulphate sulphur into H₂S. The standard deviation is ±13 ppm S for WO₃ containing 310 ppm S, and ±1 ppm S for metallic tungsten powder containing 45 ppm S.

---

---

Herrn Prof. Dr.E. Hayek zum 60. Geburtstag gewidmet.     

Synthesis of (-)-ilimaquinone via a radical decarboxylation and quinone addition reaction

[reaction: see text] A stereoselective synthesis of (-)-ilimaquinone (4) is presented. The synthetic strategy is based on a novel radical decarboxylation and quinone addition methodology that produces quinone 7 from reaction of thiohydroxamic acid derivative 8 with benzoquinone (9). Final functionalization of 7 to ilimaquinone (4) is achieved by exploring the electronic effects of the residual thiopyridyl group.     

Report on three aliphatic dimethylarsinoyl compounds as common minor constituents in marine samples. An investigation using high-performance liquid chromatography/inductively coupled plasma mass spectrometry and electrospray ionisation tandem mass spectrometry

Three water-soluble aliphatic arsenicals, dimethylarsinoyl acetate (DMAA), dimethylarsinoyl ethanol (DMAE), and dimethylarsinoyl propionate (DMAP), were identified in marine biological samples. Sample extracts in methanol/water (1 + 1) were analysed by cation-exchange high-performance liquid chromatography/inductively coupled plasma mass spectrometry (HPLC/ICPMS). Eluate fractions from the HPLC/ICPMS analyses containing the compounds in question were collected and subjected to analysis by electrospray ionisation tandem mass spectrometry (ESI-MS/MS), which provided supportive evidence for the structures of the three compounds. The concentrations of the three arsenicals were determined in 37 marine organisms comprising algae, crustaceans, bivalves, fish and mammals by HPLC/ICPMS. The three arsenicals DMAA, DMAE and DMAP, which occurred at microg kg(-1) concentrations, were detected in 25, 23 and 17 of the 37 samples analysed, respectively. The limits of detection were 2-3 microg kg(-1) dry mass. The data illustrate that the three compounds are common minor constituents in marine samples. This is the first report on DMAE and DMAP as naturally occurring species in marine samples. The presence of DMAA and DMAE supports a proposed biosynthesis of arsenobetaine (AB) from dimethylarsinoylribosides. Alternative proposals, which explain the presence of the compounds in marine samples, are addressed briefly in the paper.     

Unexpected conversion of a polycyclic thiophene to a macrocyclic anhydride

Oxygenation of 2,5,9,12-tetra(tert-butyl)diacenaphtho[1,2-b:1′,2′-d]-thiophene (1, C₄₀H₄₄S) by peracids gave the cyclic sulfonic ester 4 (2,7,10,13-tetra(tert-butyl)diacenaphtho[1,2-c:1′,2′-e]oxathiin 5,5-dioxide, C₄₀H₄₄O₃S) which, when heated in nitrobenzene, is converted into a complex, macrocyclic anhydride 3 (C₈₀H₈₈O₃), which is derived from two molecules of 4. Further investigation found a likely intermediate in this reaction, 4,4′,7,7′-tetra(tert-butyl)-1,1′-biacenaphthylenylidene-2,2′-dione (5, C₄₀H₄₄O₂), apparently formed from 4 by additional oxidation. Anhydride 3 plausibly arises by Diels-Alder reaction of 4 and 5 followed by several ring fragmentations. The structures of 3, 4, and 5 were unambiguously established by X-ray crystallography.