The Michael addition of indoles to alpha,beta-unsaturated ketones catalyzed by CeCl3.7H2O-NaI combination supported on silica gel

Alkylation of indoles by means of the Michael addition has been the subject of a number of investigation. It is well established that regioselectivity in the additions of indoles to electron-deficient alkenes is strongly controlled by the reaction medium. In a continuation of the work on developing greener and cleaner technologies, the cerium(III) chloride heptahydrate and sodium iodide combination supported on silica gel catalyzes the alkylation of various indoles with alpha,beta-unsaturated ketones giving 3-(3-oxoalkyl)indole derivatives in good yields. The substitution on the indole nucleus occurred exclusively at the 3-position, and N-alkylation products have not been observed.     

Liquid chromatography/tandem mass spectrometry for the identification and determination of trichothecenes in maize

A reliable, sensitive and selective liquid chromatography/tandem mass spectrometry (LC/MS/MS) method has been developed to determine four trichothecene mycotoxins (nivalenol, deoxynivalenol, fusarenon X and 3-acetyldeoxynivalenol) in maize. Sample preparation was performed by extracting the analytes with a mixture of acetonitrile and water, followed by a solid-phase extraction with Carbograph-4 cartridges as the purification step. For the LC/MS/MS analysis two interfacing systems, Turbo IonSpray (TISP) and atmospheric pressure chemical ionization (APCI), were compared in both negative and positive ion modes. LC and MS parameters were optimized to achieve better results and sensitivity. The effect of mobile phase modifiers such as ammonium acetate and formic acid on the ionization yield was also evaluated. The best results were obtained using the electrospray ionization (ESI) interface in negative ion mode and the multiple reaction monitoring mode (MRM) for the quantitation. The detection limits ranged between 10 ng/g for fusarenon X and 1.5 ng/g for deoxynivalenol. A linear working range was achieved with a standard deviation between 3 and 10% and recovery rates from the maize samples above 81%. The procedure was applied to the analysis of a set of maize samples collected from farms located in different areas of northern and central Italy. The investigated samples turned out to be contaminated primarily with deoxynivalenol and, to a minor extent, with its derivatives.     

Evaluation of the interaction parameter for poly(ε‐caprolactone)/poly(styrene‐co‐acrylonitrile) blends

In this article, the miscibility of poly(ε‐caprolactone) (PCL) with poly(styrene‐co‐acrylonitrile) (SAN) containing 25 wt % of acrylonitrile is studied from both a qualitative and a quantitative point of view. The evidences coming from thermal analysis (differential scanning calorimetry) demonstrate that PCL and SAN are miscible in the whole range of composition. The Flory interaction parameter χ_1,2 was calculated by the Patterson approximation and the melting point depression of the crystalline phase in the blends; in both cases, negative values of χ_1,2 were found, confirming that the system is miscible. The interaction parameter evaluated within the framework of the mean field theory demonstrates that the miscibility of PCL/SAN blends is due to the repulsive interaction between the styrene and acrylonitrile segments in SAN. © 2010 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys, 2010     

Synthesis of polymers containing regularly distributed tetrathia‐[7]‐elicene units along the backbone

A tetrathia‐[7]‐helicene bearing in the 2 and 13 positions cyanovinyl groups was used as comonomer in the Michael‐type polyaddition reaction with N,N′‐bis(β‐mercaptoethyl)piperazine. This led to a new polymer bearing tetrathia‐[7]‐helicene units regularly distributed along the polymer backbone, which may be regarded as the first example of a new family of potentially useful nonlinear optical materials. All products were structurally characterized by ¹H and ¹³C NMR spectroscopy. Differential scanning calorimetry characterizations revealed the presence, in both monomeric and polymeric helicenes, of glass‐transition like temperatures, associated to some conformational variation of the helicene units. The optical properties, the film formation and the morphology of the polymer‐containing tetratia‐[7]‐helicenes were also investigated. © 2010 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2010     

HPLC-ESI-MS and MS/MS structural characterization of multifucosylated N-glycoforms of the basic proline-rich protein IB-8a CON1+ in human saliva

This study describes the characterization of the glycan moieties and the peptide backbone of six glycoforms of IB-8a CON1(+), a basic proline-rich protein present in human saliva. MS analyses on the intact glycoproteins before and after N-deglycosylation with PNGase F and high-resolution MS/MS sequencing by LTQ Orbitrap XL of peptides and glycopeptides from tryptic digests allowed the structural characterization of the glycan moieties and the polypeptide backbone, as well as to establish the glycosylation site at the asparagine residue at 98th position. Five of the glycoforms carry a biantennary N-linked glycan fucosylated in the innermost N-acetylglucosamine of the core and showing from zero to four additional fucoses in the antennal region. The sixth glycoform carries a monoantennary monofucosylated oligosaccharide. The glycoform cluster was detected on 28 of 71 adult saliva specimens. Level of fucosylation showed interindividual variability with the major relative abundance for the trifucosylated glycoform. Nonglycosylated IB-8a CON1(+) and the variant IB-8a CON1(-), lacking of the glycosylation site, have been also detected in human saliva.     

Characterization of dendrimer properties by capillary electrophoresis and their use as pseudostationary phases

The general properties of dendrimers and in particular their electrolytic characteristics that are relevant in electrokinetic separations, are described. In order to confirm theoretical considerations on commercial dendrimer charge and hydrodynamic radius, several capillary zone electrophoresis (CZE) experiments were performed. Electrophoretic mobilities measured at different pH values indicated a sensible increase of dendrimer hydrodynamic radius at pH values lower than 2.5. This was probably due to the Coulombic repulsion of charged amine groups of the inner dendrimer shells. The principal reasons that should address the use of dendrimers as pseudostationary phases in micellar electrokinetic chromatography (MEKC) are discussed. Moreover, a survey of different separations performed utilizing dendrimers in MEKC as well as of several future plausible uses of various classes of dendrimers is presented.     

Unprecedented eta(1)-P(basal) coordination of P(4)X(3) molecules (X = S, Se). An experimental and theoretical study of the apical vs basal complexation dichotomy

Reaction of [(triphos)Re(CO)(2)(OTf)] (1) [triphos = MeC(CH(2)PPh(2))(3); OTf = OSO(2)CF(3)] with P(4)S(3) and P(4)Se(3) yields pairs of coordination isomers, namely, [(triphos)Re(CO)(2)[eta(1)-P(apical)-P(4)X(3)]](+) (X = S, 2; Se, 5) and [(triphos)Re(CO)(2)[eta(1)-P(basal)-P(4)X(3)]](+) (X = S, 3; Se, 6). The latter represent the first examples of the eta(1)-P(basal) coordination achieved by the P(4)X(3) molecular cage. Further reaction of 2/3 and 5/6 mixtures with 1 affords the dinuclear species [[(triphos)Re(CO)(2)](2)[mu,eta(1:1)-P(apical,)P(basal)-P(4)X(3)]](2+) (X = S, 4; Se, 7) in which the unprecedented M-eta(1)-P(basal)/eta(1)-P(apical)-M' bridging coordination of the P(4)X(3) molecule is accomplished. A theoretical analysis of the bonding properties of the two coordination isomers is also presented. The directionality of apical vs basal phosphorus lone pairs is also discussed in terms of MO arguments.     

L‐lysine and EDTA polymer mimics as resins for the quantitative and reversible removal of heavy metal ion water pollutants

Traditional precipitation methods for inorganic micropollutant removal from waters are increasingly being replaced by sorption methods based on both natural and synthetic materials. In this context, two novel effective heavy metal ions absorbers are presented. These resins, LYMA and LMT85, were crosslinked poly(amidoamine)s carrying amine and carboxyl groups in their repeating units. In particular, the LYMA‐repeating unit contains one carboxyl and two amine groups and is a mimic of L ‐lysine, whereas LMT85 contains two amine and five carboxyl groups and is a mimic of EDTA. Both resins were prepared at moderate cost by simple eco‐friendly procedures. The heavy metal ion set adopted as benchmark was Cu²⁺, Cd²⁺, Pb²⁺, Zn²⁺, Ni²⁺, and Co²⁺. LYMA proved selective for Cu²⁺ and Ni²⁺, the other ions tested being negligibly absorbed, whereas LMT85 proved capable of rapidly and quantitatively absorbing all the ions tested either singly or in mixed solution. The absorption process was reversible, and the resins were easily regenerated by acidification. The absorption of several metal ions imparted intense coloring to the resins, a feature possibly exploitable for analytical purposes. © 2012 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2012     

Catalytic activity of a ceria-lanthana system for 4-methylpentan-2-ol dehydration

A ceria-lanthana catalytic system prepared by the sol-gel technique proved to be active in 4-methylpentan-2-ol conversion, mainly leading to 4-methylpent-1-ene, a monomer for manufacturing polymers of high technological properties. The product distribution strongly depends on the acid-base features of the catalyst. The catalytic behavior of the samples was examined in the light of their acid-base properties. This revised version was published online in June 2006 with corrections to the Cover Date.     

Oriented thin films from soluble polythiophenes

The degree of orientation of thin films of eight different polymeric structures, belonging to the class of soluble polyalkylthiophenes (PATs) has been studied. Thin films of the polymers, obtained by spin coating onto glass substrates, were oriented by means of the rubbing technique. The degree of orientation is related to the regioregularity of the system: highly regioregular polymers can be oriented, while regiorandom materials are not oriented. The degree of orientation can be improved by thermal annealing of the oriented films. As a result of annealing, which was performed at different temperatures according to the thermal behavior of the polymers, it was possible to increase the polarization ratio for poly(3-decylthiophene) up to 12–13 as detected from the UV-vis spectra in polarized light. Moreover in the investigated PATs, both the key role of molecular weight and its distribution for achieving a high orientation degree has been assessed. Copyright © 2003 John Wiley & Sons, Ltd.