Decompositions of continuity and complete continuity

We introduce the notions of δ-t-sets, δ_β-t-sets, δ-B-continuity and δ_β -B-continuity and obtain decompositions of continuity and complete continuity.     

Critical dynamics of the Potts model in several dimensionalities

We study critical dynamics of general q-state Potts models on d-dimensional hypercubic lattices. The master equation is formulated according to a theory recently presented by the author. A simple bond moving technique, followed by decimation, is used to obtain the dynamical exponents. Although this approximation yields poor results for the static exponents, the dynamic behaviour is closer to Monte Carlo simulations. We compare our results with those obtained with a different formulation of dynamics. A final discussion is included.     

Effect of crack tip sharpness on the strength of vulcanized rubbers

The effect of crack tip sharpness on crack propagation in vulcanized rubbers has been studied. For very sharp cracks, tearing is found to occur on a small scale at very low energies not far above the threshold required for the onset of mechanical crack growth. The “small-scale” tearing energies show relatively little variation for rubbers that differ widely in tear strength as normally measured. Thus the latter property appears to be strongly influenced by variations in the ability of rubbers to promote tip blunting. The small-scale tear behavior is of relevance to other fracture phenomena, including cutting by sharp objects and tensile failure. Natural variations in tip sharpness occur during cyclic or time-dependent mechanical crack growth and influence the form of the crack growth characteristics.     

Characteristics of thermoradiative destruction of BaS2O6·2H2O

Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 55, No. 4, pp. 613–618, October, 1991.     

Correctness of the formulation of symmetric problems of the mechanics of shallow shells with cuts

The behavior of the edges of cuts in shallow shells with the symmetric combined action of tension and flexure is investigated. For shells of different curvature with one and two parallel or collinear cuts, the load region in which there is no contact of the cut edges in the course of shell deformation is determined.Translated from Teoreticheskaya i Prikladnaya Mekhanika, No. 19, pp. 98–100, 1988.     

Excess noise peaks in porous silicon-based diode structures

Results of an experimental observation of the voltage oscillations associated with a discrete tunneling of holes in porous silicon at room temperature are presented. The noise characteristics of diode structures with a porous silicon interlayer formed on heavily boron-doped silicon single crystals are studied. Peaks of excessive noise are observed at frequencies of ～1 MHz, at which single-electron oscillations should be expected. The peak noise power is found to increase with current according to the ～2.5 power law and, at a current density of 0.15 A/cm², to exceed the noise power of the receiver by three to four orders of magnitude. The complex shape of the noise spectrum and its extension to the higher frequency region with increasing current are explained by the three-dimensionality of the system of nanometer-sized silicon grains embedded in insulating silicon dioxide of porous silicon.