Melt rheology of polylactide/montmorillonite nanocomposites

In this article, the linear and nonlinear shear rheological behaviors of polylactide (PLA)/clay (organophilic‐montmorillonite) nanocomposites (PLACNs) were investigated by an Advanced Rheology Expanded System rheometer. The nanocomposites were prepared by master batch method using a twin‐screw extruder with poly(ε‐caprolactone) (PCL) as a compatibilizer. The presence of org‐MMT leads to obvious pseudo‐solid‐like behaviors of nanocomposite melts. The behaviors caused by the formation of a “percolating network” derived from the reciprocity among the strong related sheet particles. Therefore, the storage moduli, loss moduli, and dynamic viscosities of PLACNs show a monotonic increase with MMT content. Nonterminal behaviors exists in PLACNs nanocomposites. Besides the PLACNs melts show a greater shear thinning tendency than pure PLA melt because of the preferential orientation of the MMT layers. Therefore, PLACNs have higher moduli but better processibility compared with pure PLA. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 3189–3196, 2007     

Bis[μ‐1‐(1,10‐phenanthrolin‐2‐yl)‐2‐pyridone]bis{aqua[1‐(1,10‐phenanthrolin‐2‐yl)‐2‐pyridone]cadmium(II)} tetrakis(perchlorate)

In the title centrosymmetric binuclear complex, [Cd₂(C₁₇H₁₁N₃O)₄(H₂O)₂](ClO₄)₄, the Cd^II ion assumes a distorted octahedral geometry. There are π–π stacking interactions between the pyridine and 1,10‐phenanthroline ring systems of adjacent ligands at the same Cd^II centre. Intermolecular hydrogen bonds between the coordinated aqua ligand and the O atom of a keto group connect adjacent complex cations into extended chains. Hydrogen bonds also exist between the complex cations and the perchlorate anions. Compared with the fluorescence spectrum of the organic ligand, the complex displays strong fluorescent emission and an ipsochromic shift of the emission peaks, which may be attributed to the structural character.     

微型网状结构支架的力学性能研究

冠状动脉支架为圆柱形微型网状结构，直径1mm，厚度0．1mm，长度10～16mm。在经皮冠状动脉介入PCI治疗中由球囊充气撑开到直径为2．5～3．5mm的支架，在血管内承受血管壁回弹压力。为了保持血液流通支架必须保持其几何圆形。这是一个结构弹塑性稳定性问题。但是目前国际上对于支架的力学性能质量指标主要以强度性能评定而不涉及支架屈曲性能是不妥的。本文对于支架的强度和屈曲性能进行了全面的理论分析和实验研究，自行研制了智能式电子检测仪成功地对微型网状结构支架的强度和屈曲性能实现了实测实验研究。由于微型支架的离散型网状结构的特点，在实验中出现一些特殊的屈曲现象。本文研究结果对于支架的形状与性能设计的改进和力学性能质量标准规范的制订具有重要意义。     

Selected-area growth of carbon nanotubes by the combination of focused ion beam and chemical vapor deposition techniques.

In this article, we report a technique for growing carbon nanotubes in a more controllable fashion, which enables us to synthesize nanotubes directly in various forms of designed patterns. This nanofabrication process is based on a combination of focused ion beam (FIB) and chemical vapor deposition (CVD) techniques. In this process, arrays of conductive patterns were first deposited on silicon substrates by directing a gaseous compound (C(9)H(16)Pt) via the capillary needle-sized nozzles within a FIB system. The substrates were then coated with catalyst and further modified by the FIB to localize the position of the catalyst. Finally, the growth of carbon nanotubes on the designed substrates was carried out by CVD of hydrocarbon gases. This fabrication technique has the advantage of positioning carbon nanotubes in selected locations. This may open up opportunities for the direct synthesis of carbon nanotubes onto almost any substrate material, thus allowing fabrication of carbon nanotube-based devices.     

35Cr25Ni12奥氏体耐热钢中碳化物的电子显微分析

应用扫描电镜（SEM）和透射电镜（TEM）研究了长期使用前后的35Cr25Ni12奥氏体耐热钢中的碳化物演变行为；该钢固溶时效后的组织由初晶奥氏体及M23C6共晶碳化物组成，奥氏体基体中析出了二次M23C6，二次碳化物总是与基体保持立方－立方取向关系；长期使用（3、5年）后，奥氏体中析出的二次碳化物量明显增加，部分M23C6已转变为M6C，M6C与奥氏体基体以及二次碳化物M23C6保持[001]M6C//[221]A//[221]M23C6孪晶取向关系。     

Enhancement of Overall Photovoltaic Efficiency by Changing the Position of the Attaching Group -RSO3- on the Hemicyanine Dye Molecules

A new photoresponsive D-π-A dye, mPS, has been designed and synthesized.Compared to the parent dye PS, IPCE values in the region from 400 nm to 560 nm was greatly improved upon changing the attaching group from the p- position to the o- position of the π-conjugation bridge. A solar cell based on mPS generated a remarkably high overall yield η of 5.4% under irradiation of 80.0 mW cm^-2 white light from a Xe lamp, Compared with PS, the overall yield η increased by 64%.     

Isolation and Structure Elucidation of Nortriterpenoids from Schisandra rubriflora

Seven new highly oxygenated nortriterpenoids, rubriflorins D–J ( 1 – 7 ), were isolated from the leaves and stems of Schisandra rubriflora, and their structures were elucidated on the basis of extensive analysis of spectroscopic data. These new compounds feature the opening of ring A compared with related known nortriterpenoids isolated from the genus Schisandra and showed weak activity against HIV‐1.     

Synthesis and nuclear magnetic resonance analysis of starch‐g‐poly(1,4‐dioxan‐2‐one) copolymers

A new biodegradable starch graft copolymer, starch‐g‐poly(1,4‐dioxan‐2‐one), was synthesized through the ring‐opening graft polymerization of 1,4‐dioxan‐2‐one onto a starch backbone. The grafting reactions were conducted with various 1,4‐dioxan‐2‐one/starch feed ratios to obtain starch‐g‐poly(1,4‐dioxan‐2‐one) copolymers with various poly(1,4‐dioxan‐2‐one) graft structures. The microstructure of starch‐g‐poly(1,4‐dioxan‐2‐one) was characterized in detail with one‐ and two‐dimensional NMR spectroscopy. The effect of the feed composition on the resulting microstructure of starch‐g‐poly(1,4‐dioxan‐2‐one) was investigated. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 3417–3422, 2004