Simple spectrophotometric determination of Fe in oxalate and HCl soil extracts

We describe a spectrophotometric method to determine the sum of Fe(II) plus Fe(III) in HCl and oxalate extracts. The principle of the method is to reduce Fe(III) by ascorbate in near-neutral solution and to sequester the Fe(II) formed as a tri-ferrozine complex, which is then determined photometrically at 562 nm. Because the complex is stable, the reaction is irreversible and complete. Fe(III) in HCl solution reacted very rapidly, whereas oxalate decelerated the overall reaction so that pseudo first-order kinetics with respect to Fe(III) was detected. However, when extractions were conducted at the recommended soil:solution ratio, the absorption reached 98% of its final value within a few minutes. To test the method, four soils differing considerably in texture and carbonate, organic matter, and Fe(III)(hydr)oxide contents were extracted with oxalate in the dark for amorphous (Fe(o)), and with boiling oxalate for total Fe(III)(hydr)oxide (Fe(bo)). This newly developed spectrophotometric method showed excellent correspondence with the conventional atomic absorption spectroscopy (AAS) method. The method presented here can therefore be used as an alternative method to determine the Fe content of oxalate and hydrochloric acid extracts if AAS is not available. Oxalate extracts low in Fe content, which cannot be diluted, are easier to determine by the photometric method than by AAS.     

Use of chelating resins and inductively coupled plasma mass spectrometry for simultaneous determination of trace and major elements in small volumes of saline water samples

For some saline environments (e.g. deeply percolating groundwater, interstitial water in marine sediments, water sample collected after several steps of fractionation) the volume of water sample available is limited. A technique is presented which enables simultaneous determination of major and trace elements after preconcentration of only 60 mL sample on chelating resins. Chelex-100 and Chelamine were used for the preconcentration of trace elements (Cd, Cu, Pb, Zn, Sc) and rare earth elements (La, Ce, Nd, Yb) from saline water before their measurement by inductively coupled plasma mass spectrometry. Retention of the major elements (Na, Ca, Mg) by the Chelamine resin was lower than by Chelex; this enabled their direct measurement in the solution after passage through the resin column. For trace metal recoveries both resins yield the same mass balance. Only Chelex resin enabled the quantitative recovery of rare earth elements. The major elements, trace metals and rare earth elements cannot be measured after passage through one resin only. The protocol proposes the initial use of Chelamine for measurement of trace and major elements and then passage the same sample through the Chelex resin for determination of the rare earth elements. The detection limit ranged from 1 to 12 pg mL(-1). At concentrations of 1 ng mL(-1) of trace metals and REE spiked in coastal water the precision for 10 replicates was in the range of 0.3-3.4% (RSD). The accuracy of the method was demonstrated by analyzing two standard reference waters, SLRS-3 and CASS-3.     

Two-stage Off-Gel isoelectric focusing: protein followed by peptide fractionation and application to proteome analysis of human plasma

This paper presents the recently introduced Off-Gel electrophoresis (OGE) technology as a versatile tool to reproducibly fractionate intact proteins and peptides into discrete liquid fractions. The coupling of two stages of OGE, i.e., the separation of intact proteins in a first-stage followed by fractionation of peptides derived from each protein fraction after proteolysis in a second stage, results in an array of 15 x 15 fractions that are directly amenable to additional peptide fractionation like reverse-phase liquid chromatography (RPC). The analysis of all second-stage peptide fractions from only the first-stage protein fraction representing pH 5.0 -5.15 by on-line reverse-phase LC-tandem mass spectrometry resulted in the identification of 53 proteins (337 peptides), of which 10 were on different immunoglobulin (Ig) chains, with an input of only 1.5 mg human blood plasma proteins. Increasing the protein load to approximately 12 mg increased the number of identified proteins in the same protein fraction to 73 proteins (449 peptides), of which 15 were Ig-related. Immunodepletion of six of the most abundant proteins (albumin, transferrin, haptoglobin, IgG, IgA, and alpha-1-antitrypsin) prior to first-stage OGE with an input of 1.5 mg of protein (equivalent to approximately 10 mg nondepleted plasma) resulted in the identification of 81 proteins (660 peptides), of which three were still Ig fragments. The pI-based separation of peptides appears to be nonuniform based on the theoretically determined pI values of identified peptides. This observation specifically accounts for the neutral zone (pI 5-8) and can be accounted for by the physicochemical properties of the peptides given by their amino acid composition. The power of OGE separation of proteins and peptides is discussed with a focus on the use of the knowledge about the pI of proteins and peptides that assist the validation of correct identifications together with the retention time of peptides on RPC.     

Chloro(η6‐p‐cymene)(phosphoramidite)ruthenium(II), a 16‐Electron Fragment Stabilized by an η2‐Aryl–Metal Interaction,and Its Use in Asymmetric Cyclopropanation

Chloride abstraction from the half‐sandwich complexes [RuCl₂(η⁶‐p‐cymene)(P*‐κP)] ( 2a : P* = (S_a,R,R)‐ 1a = (1S_a)‐[1,1′‐binaphthalene]‐2,2′‐diyl bis[(1R)‐1‐phenylethyl)]phosphoramidite; 2b : P* = (S_a,R,R)‐ 1b = (1S_a)‐[1,1′‐binaphthalene]‐2,2′‐diyl bis[(1R)‐(1‐(1‐naphthalen‐1‐yl)ethyl]phosphoramidite) with (Et₃O)[PF₆] or Tl[PF₆] gives the cationic, 18‐electron complexes dichloro(η⁶‐p‐cymene){(1S_a)‐[1,1′‐binaphthalene]‐2,2′‐diyl {(1R)‐1‐[(1,2‐η)‐phenyl]ethyl}[(1R)‐1‐phenylethyl]phosphoramidite‐κP}ruthenium(II) hexafluorophosphate ( 3a ) and [Ru(S)]‐dichloro(η⁶‐p‐cymene){(1S_a)‐[1,1′‐binaphthalene]‐2,2′‐diyl {(1R)‐1‐[(1,2‐η)‐naphthalen‐1‐yl]ethyl}[(1R)‐1‐(naphthalen‐1‐yl)ethyl]phosphoramidite‐κP)ruthenium(II) hexafluorophosphate ( 3b ), which feature the η²‐coordination of one aryl substituent of the phosphoramidite ligand, as indicated by ¹H‐, ¹³C‐, and ³¹P‐NMR spectroscopy and confirmed by an X‐ray study of 3b . Additionally, the dissociation of p‐cymene from 2a and 3a gives dichloro{(1S_a)‐[1,1′‐binaphthalene]‐2,2′‐diyl [(1R)‐(1‐(η⁶‐phenyl)ethyl][(1R)‐1‐phenylethyl]phosphoramidite‐κP)ruthenium(II) ( 4a ) and di‐μ‐chlorobis{(1S_a)‐[1,1′‐binaphthalene]‐2,2′‐diyl [(1R)‐1‐(η⁶‐phenyl)ethyl][(1R)‐1‐phenylethyl]phosphoramidite‐κP}diruthenium(II) bis(hexafluorophosphate) ( 5a ), respectively, in which one phenyl group of the N‐substituents is η⁶‐coordinated to the Ru‐center. Complexes 3a and 3b catalyze the asymmetric cyclopropanation of α‐methylstyrene with ethyl diazoacetate with up to 86 and 87% ee for the cis‐ and the trans‐isomers, respectively.     

Application of dn/dc data for the determination of partial specific volumes of dissolved macromolecules

The principles of a method are outlined whereby one can determine the partial specific volume of a solute, V?, by means of measurements of dn/dc using a suitable pair of equations and a simple graphical interpolation procedure. The method yields V? data which compare well with densitometrically obtained V? data if the polarizability of both solvent and solute molecules is unaffected by the solution process. It is tested successfully on solutions of polystyrene in various solvents. The method appears to be particularly attractive for measurements of the change of V? with temperature and also for conveniently following the time rate of changes in - such as during the coil → helix transition.     

Selex: An expert system for evaluating published data on selenium in foods

Providing consistent and objective evaluation of published data on nutrient composition is critical for planning future analytical studies and for effective use of data. Based on a commercial expert system shell, a computer system of approximately 200 rules has been created to evaluate and ratre quantitatively published data on selenium in foods. The evaluation scheme uses five general categories for its rule-making process: number of samples, analytical method, sample handling, sampling plan, and analytical quality control. For each selenium value to be evaluted, rating ar assigned in each category by the expert system based on input which is derived from the information reportedin a given paper. A quality index, which is derived from the ratings, is a measure of the reliability of a given selenium value over all categories for a given study. The concepts used in developing SELEX have the potential of establishing criteria for evaluation of proposed analytical methods prior to their publication.     

Photocatalyzed [2 + 2 + 2]-cycloaddition of nitriles with acetylene: an effective method for the synthesis of 2-pyridines under mild conditions

The photocatalyzed [2 + 2 + 2]-cycloaddition of nitriles with 2 equiv of acetylene to 2-pyridines can be carried out under mild conditions and represents a valuable extension to common synthetical methods. For the ideal wavelength range (350-500 nm), lamps as well as sunlight can be used. Working at room temperature and in organic solvents such as toluene or hexane as well as in water gives satisfying results in many cases. However, it is also possible to vary the solvent and the reaction temperature of the photocatalyzed synthesis and to choose, with respect to the specific substrate, specific requirements for this particular reaction and general requirements of the method. This simple and selective method derives its potential mainly from the large variety of applicable nitriles. Suitable substrates include (functionalized) aliphatic and aromatic nitriles as well as cyanamides derived from secondary amines.     

Spectrophotometric determination of nickel(ii) with molybdophosphoric acid

A sensitive spectrophotometric method for the determination of nickel, based on the reduction of a complex formed between molybdophosphoric acid and Ni(II) at pH 4.3 has been developed. Excess of molybdophosphoric acid is eliminated by complexation with sodium citrate. The method is rapid and the system obeys Beer's law up to 5 ppm of Ni(II). The molar absorptivity is 1.30 x 10(3) 1.mole(-1).mm(-1). The technique compares favourably with existing photometric methods for nickel in sensitivity and is reasonably selective.     

Synthesis of Zeolite L. Tuning Size and Morphology

Summary. A convenient synthesis of zeolite L is presented. The size of the crystals can be tuned between 30 and 6000nm, spanning a volume range of seven orders of magnitude. The zeolite L crystals, which typically feature a cylindrical morphology, are synthesized with various aspect ratios ranging from elongated to disc-shaped. The importance of obtaining zeolite crystals with well-defined size and morphology is discussed in view of potential applications of zeolite L containing organic dye molecules as guests.This revised version was published online in February 2005. In the previous version the issue was not marked as a special issue, and the issue title and the editor was missing