Ga1-xInxAs/InAsyP1-y/InP异质结的MOCVD生长及表征

Ga1-xInxAs(x>0.53)材料是未来长距离低损耗光纤通信的理想光源材料和探测器材料之一.我们采用水平常压MOCVD系统,在InP衬底上成功地生长了Ga1-xInxAs(x>0.53)/InAsyP1-y/Inp异质结材料.其中InAs1-yPy为组份阶梯变化的多层结构.由样品的(400)面X光衍射结果测定了各层组份.由二次离子质谱(SIMS)得到了样品剖面组份变化结果,证明InAs1-yPy层组份为阶梯状变化的.通过对光致发光结果和X光衍射结果比较,可以看到,InAsyP1-y层通过位错和弹性畸变二种方式来释放或积累Ga1-xInxAs与InP间的失配应力,从而减少了Ga1-xInxAs中的失配位错.有效地改善了Ga1-xInxAs的质量.已获得了x高达0.94表面光亮的Ga1-xInxAs/InAs1-yPy/InP异质结材料.     

串联系统可靠性虚拟系统法置信下限的小样本性质

本文讨论了具有r个成败型元件串联系统可靠性的置信下限问题。研究了虚拟系统法置信下限的小样本性质,证明了,在通常情况下虚拟系统法置信下限要大于常见的L-M法置信下限.更一般地,本文证明了在成败型试验中,当成功数与试验数之比保持不变时,试验次数的增加将直接缩小成功率置信区间的长度。     

Measurements of climatic parameters and ground-level ozone at Terra Nova Bay in Antarctica

Summary The results of local meteorology, solar radiation and ground-level ozone measurements taken in Antarctica during the second Italian expedition (December 86–February 87) at Terra Nova Bay are presented. During the summer months the site of the Italian base camp is characterized by a thin strip of deglaciated ground, along which the temperature measurements close to the ground and up to 6 m high show a strongly superdiabatic profile. This irregular trend of the temperature in the surface layer is mainly due to the notable incoming amounts of radiation and to the extreme transparency of the atmosphere. This is also shown by the low values of the ratio between total radiation and diffuse radiation. The ground is thus subjected to intense heating, especially in the warmer hours of the day, while the surface layer of the atmosphere will be characterized by strong upward heat fluxes and by turbulent convective movements. Vertical-temperature-profile measurements show an almost forced persistence in the superdiabatic trend, which tends towards isothermic values only as a resultof rapid variations in the direction and intensity of the wind, connected to the downward flux of cold air masses, shown also by the simultaneous increases in ground-level ozone concentrations which would support the presence of dry-deposition processes in the lower layer. However, the complex local orography and the horizontal discontinuity (sea, deglaciated coast, snow-covered surfaces) do not permit a correct application of profile flux relations, normally used in studies on groundlevel dry-deposition. Paper presented at the IV Congresso del Gruppo Nazionale per la Fisica dell'Atmosfera e dell'Oceano, June 22–24, 1987, Rome.     

在BBO中产生217.3-2 21.4nm高功率和频输出

用Q-YAG激光的三次谐波(355nm)与调谐的Rh·6G染料激光在β-BaB2O4(BBO)晶体中和频,获得217.3～221.4nm连续调谐输出,和频输出的最大能量为250μJ,转换效率为11%.我们还讨论了获取最大和频输出能量的一些实验条件.     

The Drazin inverses of products and differences of orthogonal projections

In this note, the Drazin inverses of products and differences of orthogonal projections on a Hilbert space are established.     

Investigation on crosslinking behaviors of NBR/PVC filled with anhydrous copper sulfate particles by dynamic mechanical analysis

Crosslinking behaviors of acrylonitrile butadiene rubber (NBR)/poly (vinyl chloride) (PVC) alloy, filled with anhydrous copper sulfate (CuSO₄) particles, were investigated for the first time by dynamic mechanical analysis (DMA) under hetero and isothermal modes, respectively. In the heterothermal testing, (NBR/PVC)/CuSO₄ compound showed two marked increases in the storage modulus (E′), corresponding to coordination crosslinking of NBR-CuSO₄ and self-crosslinking of NBR and PVC respectively. During the isothermal testing, a dramatic increase in E′ was found at the initial stage while that of original NBR/PVC alloy was not detected. The marked increase in E′ of (NBR/PVC)/CuSO₄ compound was mainly due to the crosslinking induced by coordination between  CN and Cu²⁺. The increasing extent of E′ increased with the rise of CuSO₄ content, suggesting the formation of a greater number of crosslinks. Moreover, the activation energy (E_a) of crosslinking process was about 139 kJ/mol. In this work, fourier transform infrared spectrum (FT-IR) and equilibrium swelling method were also performed for the characterization of the compound. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 41–51, 2007     

Acute Triangulations of Flat Mobius Strips

In this paper we investigate the acute triangulations of flat Mobius strips. We find out that we can always triangulate a flat Mobius strip with at most nine acute triangles, and sometimes (but not always) that many triangles are really needed.     

带有奇异项的临界增长p-Laplace方程的非平凡解

本文研究了一种带有奇异项的临界增长p-Laplace方程在N维空间中的有界集上非平凡解的问题,利用山路引理和集中紧性原理,得出方程在非线性项满足一定条件下有非平凡解的结果.     

Dynamic Nonlinear Modelization of Operational Supply Chain Systems

Supply Chain Management (SCM) is an important activity in all producing facilities and in many organizations to enable vendors, manufacturers and suppliers to interact gainfully and plan optimally their flow of goods and services. To realize this, a dynamic modelling approach for characterizing supply chain activities is opportune, so as to plan efficiently the set of activities over a distributed network in a formal and scientific way. The dynamical system will result so complex that it is not generally possible to specify the functional forms and the parameters of interest, relating outputs to inputs, states and stochastic terms by experiential specification methods. Thus the algorithm that will presented is Data Driven, determining simultaneously the functional forms, the parameters and the optimal control policy from the data available for the supply chain. The aim of this paper is to present this methodology, by considering dynamical aspects of the system, the presence of nonlinear relationships and unbiased estimation procedures to quantify these relations, leading to a nonlinear and stochastic dynamical system representation of the SCM problem. Moreover, the convergence of the algorithm will be proved and the satisfaction of the required statistical conditions demonstrated. Thus SCM problems may be formulated as formal scientific procedures, with well defined algorithms and a precise calculation sequence to determine the best alternative to enact. A “Certainty equivalent principle” will be indicated to ensure that the effects of the inevitable uncertainties will not lead to indeterminate results, allowing the formulation of demonstrably asymptotically optimal management plans.