Effect of pH on the electrochemical reduction of some heterocyclic quinones

The reduction of 1,10-phenanthroline-5,6-quinone(I), 5,8-quinolinequinone(II) and 6,7-dichloro-5,8-quinolinequinone(III) was investigated using cyclic voltammetry and coulometry at mercury electrodes and 50% dimethylsulfoxide+water solvent. Each compound is reduced to the corresponding hydroquinone in a diffusion-controlled, reversible two-electron process. The pH-dependence of the reversible potential indicated that the quinone forms were unprotonated, but the hydroquinones could be protonated at the heterocyclic nitrogen atom with pK_a = 5.3 for I and 3.5 for III. Careful analysis of the cyclic voltammetric peak shape revealed that the difference between the standard potentials for the introduction of successive electrons, E₂⁰ ? E₁⁰, was 70 ±20, >100 and 80 ± 20 mV for I–III. Investigation of the pH-dependence of E₁⁰ and E₂⁰ showed that the pK_a of the semiquinone of I was about 8.     

Determination of amides

A method has been developed for the quantitative determination of amides. The compound is saponified with a large excess of alkali and the resulting solution passed through a heated cationexchange resin in the hydrogen form. The resin neutralizes the excess sodium hydroxide and converts the carboxylic salt to the free acid which is then titrated directly in the effluent with standard alkaline solution. The time required for a determination is less than one hour.     

Absorbance Changes by Aromatic Amino Acid Side Chains in Early Rhodopsin Photointermediates

Abstract— Absorbance changes were monitored from 250 to 650 nm during the first microsecond after photolysis of detergent suspensions of bovine rhodopsin at 20°C. Global analysis of the resulting data produced difference spectra for bathorhodopsin, BSI and lumirhodopsin which give the change in absorbance of the aromatic amino acid side chains in these photointermediates relative to rhodopsin. These spectra show that the significant bleaching of absorbance near 280 nm, which has been seen previously for the lumirhodopsin, metarhodopsin I and metarhodopsin II intermediates, extends to times as early as bathorhodopsin. Because no corresponding absorbance increase is observed in the 250-275 nm region, the earliest bleaching of the 280 nm absorbance in rhodopsin is attributed to disruption of a hyperchromic interaction affecting Trp²⁶⁵. Partial decay of this 280 nm bleaching as bathorhodopsin converts to BSI takes place maximally near 290 nm, where Trp²⁶⁵ has been shown to absorb, and could be due to the ring of the retinylidene chromophore resuming a position at the BSI stage that reestablishes the hyperchromic interaction with Trp²⁶⁵. A subsequent change in the 250-300 nm region, which has no counterpart in the visible chromophore bands, indicates the possible presence of a protein-localized process as lumirhodopsin is formed.     

Diverse spreading behavior of binary polymer nanodroplets

Molecular dynamics simulations are used to study the spreading of binary polymer nanodroplets in a cylindrical geometry. The polymers, described by the bead-spring model, spread on a flat surface with a surface-coupled Langevin thermostat to mimic the effects of a corrugated surface. Each droplet consists of chains of length 10 or 100 monomers with approximately 350,000 monomers total. The qualitative features of the spreading dynamics are presented for differences in chain length, surface interaction strength, and composition. When the components of the droplet differ only in the surface interaction strength, the more strongly wetting component forms a monolayer film on the surface even when both materials are above or below the wetting transition. In the case where the only difference is the polymer chain length, the monolayer film beneath the droplet is composed of an equal amount of short chain and long chain monomers even when one component (the shorter chain length) is above the wetting transition and the other is not. The fraction of short and long chains in the precursor foot depends on whether both the short and the long chains are in the wetting regime. Diluting the concentration of the strongly wetting component in a mixture with a weakly wetting component decreases the rate of diffusion of the wetting material from the bulk to the surface and limits the spreading rate of the precursor foot, but the bulk spreading rate actually increases when both components are present. This may be due to the strongly wetting material pushing out the weakly wetting material as it moves toward the precursor foot.     

Assessment of supporting electrolyte contributions in electrochemically modulated liquid chromatography

This paper reports the results of an investigation on the role of the supporting electrolyte in separations using electrochemically modulated liquid chromatography (EMLC) with a porous graphitic carbon stationary phase. With respect to the identity of the supporting electrolyte, the elution strength of the electrolyte anion increased as F- < OH- < BF4- < ClO4- < PF6- for injections of negatively charged aromatic molecules, whereas a 10-fold increase in electrolyte concentration induced a 60% change in retention for the same solutes. Furthermore, both the concentration and composition of the supporting electrolyte affected retention in a manner that varied with the charge of the analyte and applied potential. This behavior is explained using Gouy-Chapman diffuse double layer theory, coupled with comparisons of this theory with closely related models for ion-pair chromatography. Insights into the retention mechanism reveal that an ion-exchange mechanism controls the retention of negatively charged solutes at applied potentials removed from the potential of zero charge (PZC). At potentials close to the PZC, the electrostatic model is less effective with the predominant retention mechanism likely involving hydrophobic interactions with the carbonaceous stationary phase. The combined effects of these findings are demonstrated by using a temporal gradient in supporting electrolyte concentration to optimize an EMLC separation.     

Isomer-specific spectroscopy and conformational isomerization energetics of o-, m-, and p-ethynylstyrenes

The infrared and ultraviolet spectroscopy of o-, m-, and p-ethynylstyrene isomers (oES, mES, and pES) were studied by a combination of methods, including resonance-enhanced two-photon ionization (R2PI), UV-UV hole-burning spectroscopy (UVHB), resonant ion-dip infrared spectroscopy (RIDIRS), and rotationally resolved fluorescence excitation spectroscopy. In addition, the newly developed method of stimulated emission pumping-population transfer spectroscopy (SEP-PTS) was used to determine the energy threshold to conformational isomerization in m-ethynylstyrene. The S(1) <-- S(0) origin transitions of oES and pES occur at 32 369 and 33 407 cm(-1), respectively. In mES, the cis and trans conformations are calculated to be close in energy. In the R2PI spectrum of mES, the two most prominent peaks (32672 and 32926 cm(-1)) were confirmed by UVHB spectroscopy to be S(1) <-- S(0) origins of these two conformers. The red-shifted conformer was identified as the cis structure by least-squares fitting of the rotationally resolved fluorescence excitation spectrum of the origin band. There are also two possible conformations in oES, but transitions due to only one were observed experimentally, as confirmed by UVHB spectroscopy. Density functional theory calculations (B3LYP/6-31+G) predict that the cis-ortho conformer, in which the substituents point toward each other, is about 8 kJ/mol higher in energy than the trans-ortho isomer, and should only be about 5% of the room temperature population of oES. Ground-state infrared spectra in the C-H stretch region (3000-3300 cm(-1)) of each isomer were obtained with RIDIRS. In all three structural isomers, the acetylenic C-H stretch fundamental was split by Fermi resonance. Infrared spectra were also recorded in the excited electronic state, using a UV-IR-UV version of RIDIR spectroscopy. In all three isomers the acetylenic C-H stretch fundamental was unshifted from the ground state, but no Fermi resonance was seen. The first observed and last unobserved transitions in the SEP-PT spectrum were used to place lower and upper bounds on the barrier to cis --> trans isomerization in m-ethynylstyrene of 990-1070 cm(-1). Arguments are given for the lack of a kinetic shift in the measurement. The analogous trans --> cis barrier is in the same range (989-1065 cm(-1)), indicating that the relative energies of the zero-point levels of the two isomers are (E(ZPL)(cis) - E(ZPL)(trans))= -75 to +81 cm(-1). Both the barrier heights and relative energies of the minima are close to those determined by DFT (Becke3LYP/6-31+G) calculations.     

The Lycopodium alkaloids

Lycopodium alkaloids are quinolizine, or pyridine and alpha-pyridone type alkaloids. Some Lycopodium alkaloids are potent inhibitors of acetylcholinesterase (AChE). Huperzine A (HupA) is reported to increase efficiency for learning and memory in animals, and it shows promise in the treatment of Alzheimer's disease (AD). 201 Lycopodium alkaloids from 54 species of Lycopodium (sensu lato) have been reported so far. This review is intended to to cover the chemical, pharmacological and clinical research on Lycopodium alkaloids reported in the literature from the spring of 1993 to August 2004. Structures of 81 new Lycopodium alkaloids are presented, classified and analyzed. The structural characters and biogenetic relationships of the four major Lycopodium alkaloid groups (lycopodine, lycodine, fawcettimine and miscellaneous) are discussed. Bioactivities of Lycopodium alkaloids, especially HupA, are summarized. In particular, the effect of HupA and other cholinesterase inhibitors (anti-AD drugs) on acetylcholine esterase (AChE) activity in the rat cortex and butylcholine esterase activity are compared. Structure-activity relationships and structure modifications of HupA and its analogs are described. Information on clinical trials with HupA and its derivative ZT-1 is presented. The state of HupA availability and recent advances in in vitro propagation of HupA producing plants are outlined. Finally, hypotheses about Lycopodium alkaloid biosynthetic pathways are discussed.     

Selective dye-labeling of newly synthesized proteins in bacterial cells

We describe fluorescence labeling of newly synthesized proteins in Escherichia coli cells by means of Cu(I)-catalyzed cycloaddition between alkynyl amino acid side chains and the fluorogenic dye 3-azido-7-hydroxycoumarin. The method involves co-translational labeling of proteins by the non-natural amino acids homopropargylglycine (Hpg) or ethynylphenylalanine (Eth) followed by treatment with the dye. As a demonstration, the model protein barstar was expressed and treated overnight with Cu(I) and 3-azido-7-hydroxycoumarin. Examination of treated cells by confocal microscopy revealed that strong fluorescence enhancement was observed only for alkynyl-barstar treated with Cu(I) and the reactive dye. The cellular fluorescence was punctate, and gel electrophoresis confirmed that labeled barstar was localized in inclusion bodies. Other proteins showed little fluorescence. Examination of treated cells by fluorimetry demonstrated that cultures supplemented with Eth or Hpg showed an 8- to 14-fold enhancement in fluorescence intensity after labeling. Addition of a protein synthesis inhibitor reduced the emission intensity to levels slightly above background, confirming selective labeling of newly synthesized proteins in the bacterial cell.     

Synthesis and properties of amphiphilic vinyl acetate triblock copolymers prepared by copper mediated living radical polymerisation

Polymerisation of vinyl acetate by conventional free radical polymerisation using a diazo initiator followed by copper mediated living radical polymerisation with a range of monomers was studied. This method led to the synthesis of triblock copolymers. We have thus successfully prepared several new ABA triblock copolymers where B is poly(vinyl acetate) and A is (dimethylamino)ethyl methacrylate (DMAEMA), (polyethylene glycol) methyl ether methacrylate (MeO(PEG)MA) or solketal methacrylate (SMA). The sequential conventional/living radical polymerisation approach provided an efficient route to synthesis of new block copolymers. The properties of these amphiphilic polymers have been subsequently investigated by ¹H NMR, fluorescence spectroscopy, tensiometry and dynamic light scattering to investigate their behaviour as potential surfactants.