300kVA高温超导变压器电流引线漏热损耗的测量

电流引线是高温超导变压器的主要外部漏热来源,它的漏热量直接影响了超导变压器的经济性能,因此,引线的设计与漏热测量一直备受关注。文中构建了一个实验方案,运用量热法测量低压引线的漏热,并将试验结果与仿真预期值进行了对比和分析,从而验证了仿真设计的正确性。     

Sm3+掺杂稀土硼酸盐玻璃的光谱参数计算和荧光光谱分析

制备了具有高效可见荧光发射的Sm3 掺杂稀土硼酸盐(LBLB)玻璃,对玻璃的吸收和荧光光谱展开了测试与分析.根据Judd-Ofelt理论对吸收光谱进行了拟合,求得Sm3 离子的晶场调节参数Ωt=(2,4,6)分别为6.81×10-20,4.43×10-20和2.58×10-20 cm2,并进一步计算出各能级跃迁的谱线强度、自发辐射跃迁概率、辐射寿命和荧光分支比等光谱参数.紫外光激发下,Sm3 掺杂LBLB玻璃发出明亮的橙红色光.激发光谱表明,氩离子激光器是Sm3 掺杂LBLB玻璃有效的激发光源.     

无催化纳米氧化锌的制备及其光学性质研究

本文采用无催化剂直接蒸发高纯Zn粉,在800℃氧气氛条件下,在Si(111)衬底上生长得到以四角状为主的纳米ZnO(T-ZnO)。T-ZnO纳米线每个角约互成110°,长度约为1.5μm,直径100nm左右;Raman分析表明E2(H)普遍存在于各形态的ZnO;光致发光光谱表明,T-ZnO纳米线的光致发光除了与材料性质有关,还与杂质缺陷有关,蓝绿光带是ZnO的缺陷产生的。     

掺钕聚甲基丙烯酸甲酯的光学特性

研究了制备的掺钕螯合物Nd(DBM)3Phen材料的吸收光谱、激发光谱、荧光光谱,应用Judd-Ofelt理论计算了该材料的强度参量．分析了钕离子激发态4F3／2的辐射寿命(631 μs)和4F3／2→4IJ′跃迁的受激发射截面和荧光分支比．     

红外用CVD ZnS多晶材料的研制

论述了制备红外用CVD ZnS多晶材料的化学气相沉积工艺和热等静压处理工艺。针对CVD ZnS多晶材料具备优良的光学和力学性能,采用化学气相沉积工艺和热等静压处理技术成功研制出大尺寸多晶材料,其最大尺寸达到250mm×15mm。测试了CVD ZnS样品的各项光学、力学性能指标。样品的全波段透过率均接近ZnS材料的本征水平,折射指数均匀性优于2×10^-5,在1.06μm的吸收系数为2×10^-3cm^-1,抗弯强度达到104MPa。     

All-dielectric bowtie waveguide with deep subwavelength mode confinement

Plasmonic waveguides and conventional dielectric waveguides have favorable characteristics in photonic integrated circuits. Typically, plasmonic waveguides can provide subwavelength mode confinement, as shown by their small mode area, whereas conventional dielectric waveguides guide light with low loss, as shown by their long propagation length. However, the simultaneous achievement of subwavelength mode confinement and low-loss propagation remains limited. In this paper, we propose a novel design of an alldielectric bowtie waveguide, which simultaneously exhibits both subwavelength mode confinement and theoretically lossless propagation. Contrary to traditional dielectric waveguides, where the guidance of light is based on total internal reflection, the principle of the all-dielectric bowtie waveguide is based on the combined use of the conservation of the normal component of the electric displacement and the tangential component of the electric field, such that it can achieve a mode area comparable to its plasmonic counterparts. The mode distribution in the all-dielectric bowtie waveguide can be precisely controlled by manipulating the geometric design. Our work shows that it is possible to achieve extreme light confinement by using dielectric instead of lossy metals.     

ZnS thin film deposited with chemical bath deposition process directed by different stirring speeds

In this combined film thickness, scanning electron microscopy (SEM), X-ray diffraction and optical properties study, we explore the effects of different stirring speeds on the growth and optical properties of ZnS film deposited by CBD method. From the disclosed changes of thickness of ZnS film, we conclude that film thickness is independent of the stirring speeds in the heterogeneous process (deposition time less than 40 min), but increases with the stirring speeds and/or deposition time increasing in the homogeneous process. Grazing incident X-ray diffraction (GIXRD) and the study of optical properties disclosed that the ZnS films grown with different stirring speeds show partially crystallized film and exhibit good transmittance (70-88% in the visible region), but the stirring speeds cannot give much effects on the structure and optical properties in the homogeneous process.     

基于数字图像相关的透明材料厚度测量

提出了一种测定透明材料厚度的新方法。该方法是基于透明材料对光的折射特点,利用光斑点面内位移与材料厚度的变化关系,将厚度的测量转化为对面内位移的测量。将此方法与数字图像相关法相结合,实现了单摄像机对厚度的测定。对轴向拉伸状态下的有机玻璃板的厚度变化进行了测定,将实验结果与理论值进行了对比,两者符合较好,证明了该实验方法的有效性和可行性。     

Even and Odd Charge Coherent States: Higher-Order Nonclassical Properties and Generation Scheme

We examine the higher-order nonclassical properties of the even and odd charge coherent states as well as proposing a scheme to generate these states whose modes can freely travel in open space. We show that the even and odd charge coherent states exhibit both higher-order antibunching and higher-order squeezing. While the two-mode higher-order antibunching occurs in any order and essentially depends on the charge number, the two-mode higher-order squeezing appears only in the even orders. We also prove that these states are genuinely entangled, and they can be generated by means of cross-Kerr media, beam splitters, phase shifts and threshold detectors. We find that the fidelity and the corresponding success probability to generate these states are dependent on the correlative parameters.