Search for coherent charged pion production in neutrino-carbon interactions

We report the result from a search for charged-current coherent pion production induced by muon neutrinos with a mean energy of 1.3 GeV. The data are collected with a fully active scintillator detector in the K2K long-baseline neutrino oscillation experiment. No evidence for coherent pion production is observed, and an upper limit of is set on the cross section ratio of coherent pion production to the total charged-current interaction at 90% confidence level. This is the first experimental limit for coherent charged pion production in the energy region of a few GeV.     

Accurate determination of the LEP beam energy by resonant depolarization

To improve the measurements of the Z boson mass and resonance width, the 1993 Large Electron Positron Collider (LEP) run was devoted to a three point beam energy scan, with one point close to the peak of the Z resonance and two points roughly 880 MeV below and above the peak. Operational energy calibration by resonant depolarization was successfully commissioned for all three beam energies. 24 energy calibrations were performed at the end of physics fills. The accuracy of each calibration is better than 1 MeV. About one third of the total integrated luminosity was recorded in calibrated fills below and above the resonance and a regular tracking of the beam energies throughout the scan was possible. The evolution of the beam energies in the course of the year showed a large variation of up to 20 MeV. Results from the energy calibrations will be presented and possible explanations for the changes of the beam energy during the year will be described.     

Comparative spectral attenuation measurements on optical fibres: final report by members of COST 208

Comparative spectral attenuation measurements on a graded-index fibre have been perfomed by nine participants, covering the range 700–1800 nm. Details of measurement equipment and techniques are being reported. Since the attenuation of a graded-index fibre depends on the energy distribution launched into the fibre, only careful control of this parameter leads to comparable results. A method was developed to check the energy distribution in the fibre over a broad spectral range. By this method agreement of attenuation values to within ± 5% from 800 to 1500 nm has been achieved. This is about half of the deviation found in other comparison measurements which are usually restricted to one or two wavelengths.     

Experimental demonstration of suppression of low-frequency fluctuations and stabilization of an external-cavity laser diode

We demonstrate experimentally all-optical stabilization of a single-mode laser diode subject to external optical feedback operating in the low-frequency fluctuations (LFF) regime, by the technique of applying a second delayed optical feedback. We interpret our results as suppression of LFF through destruction of the antimodes responsible for the LFF crises and stabilization of the laser through creation of new maximum gain modes, in agreement with recent theoretical predictions.     

Metal Ions Binding to Natural Organic Matter Extracted from Wheat Bran: Application of the Surface Complexation Model

Ions binding to solid organic matter was investigated in this study. A simple surface complexation model, the diffuse double-layer model, was used to describe Pb(II), Cd(II), Zn(II), and Ni(II) binding to a lignocellulosic substrate extracted from wheat bran. The lignocellulosic substrate was represented by two acid sites: a low-pH ("carboxylic") site and a high-pH ("phenolic") site, the phenolic-type sites contributing significantly to the binding behavior, even at relatively low pH. By using the previously determined concentrations of sites and acidity constants, the surface complexation model was applied to Pb, Cd, Zn, and Ni binding as a function of pH in a 0.1 M NaNO(3) medium. The model fits were good over a wide range of pH (2相似文献   

Towards the european strategy for particle physics: The briefing book

This document was prepared as part of the briefing material for the Workshop of the CERN Council Strategy Group, held in DESY Zeuthen from 2nd to 6th May 2006. It gives an overview of the physics issues and of the technological challenges that will shape the future of the field, and incorporates material presented and discussed during the Symposium on the European Strategy for Particle Physics, held in Orsay from 30th January to 2nd February 2006, reflecting the various opinions of the European community as recorded in written submissions to the Strategy Group and in the discussions at the Symposium.     

Multiscale surface self-assembly of an amyloid-like peptide

We present the 2D self-assembly properties of an amyloid-like peptide (LSFDNSGAITIG-NH2) (i.e., LSFD) over a whole range of spatial scales. This peptide is known to adopt an amyloid-like behavior in water where it aggregates into fibrils. Monolayers of this 12 amino acid peptide were built by direct spreading and compression of an organic unstructured LSFD solution at the air/water interface. Investigation by infrared spectroscopy of the peptide secondary structure reveals beta-sheet formation at the water surface. As evidenced by Brewster angle microscopy, compression of the peptidic film results in the formation of large condensed domains. We used atomic force microscopy to show that these domains are made of rather monodisperse, elongated domains of monomolecular thickness, which are about 1 microm long and hundred of nanometers wide. These nanodomains can be compacted up to the formation of a homogeneous monolayer on the micrometer scale. These bidimensional structures appear as a surface-induced counterpart of the bulk amyloid fibrils that do not form at the air/water interface. These self-assembled peptide nanostructures are also very promising for building organized nanomaterials.     

Cobalt(I)-mediated preparation of polyborylated cyclohexadienes: scope, limitations, and mechanistic insight

A series of 1,3- and 1,4-diboryl-1,3-cyclohexadienes have been prepared by intermolecular CoCp-mediated [2+2+2] cocyclizations of alkynylboronic pinacolate esters with alkenes, followed by oxidative demetallation with iron(III) chloride. The effect of substitution at the borylated alkyne on chemo- and regioselectivities has been studied, suggesting steric control. The proper choice of substituents allowed the preparation of 1,3-diborylated cyclohexadienes in a highly selective manner. Alternatively, 1,4-diborylated cyclohexadienes could be prepared from diborylated diynes. The scope of this reaction has been examined and found to include electron-poor, electron-rich, linear, and cyclic alkenes. The diborylated cyclohexadienes were submitted to single or double Suzuki-Miyaura cross-coupling reactions with haloarenes to afford polyarylated systems. The mechanism of the title reaction, including the regioselectivity of the cycloaddition steps, has been analyzed by means of DFT computations.     

A novel transmetallation of arylzinc species into arylboronates from aryl halides in a barbier procedure

A variety of functionalized arylboronates are obtained in moderate to excellent yield by a one-step chemical procedure from the corresponding halides and a haloboronic ester via an intermediate arylzinc species.