Chemische Vitamin D<Subscript>3</Subscript>-Bestimmung in Lebertran

The different aspects of Vitamin D₃ determination and the data reported in the literature are discussed. The spectrophotometric determination of Vitamin D₃ in cod-liver oil is carried out after the alkaline saponification, extraction of unsaponified parts, precipitation of accompanying sterols and the column- and thin-layer chromatographic purification and separation of vitamin D₃ on 40 cm plates from other vitamins. The dyestuff α-naphtholbenzein is suited well as standard substance for the better location and identification of vitamin D₃ zone on the thin-layer plate. The results obtained from the chemical method were checked through the simultaneous biological determination.     

Configurational bias Monte Carlo simulation of phase segregation in block copolymer networks

Cross-linked block copolymers are used as adhesives in fiber-reinforced composite material manufactures for automotive applications. Good adhesion between the polymer matrix and fibers in the interphase region is required for the structural integrity of these materials. Experimental evidence indicates that superior adhesion is obtained when phase segregation occurs between the two matrix phase block copolymers. It is therefore desirable to predict the conditions under which phase segregation is expected to occur. Configurational bias Monte Carlo simulations of two-component, trifunctional block copolymer networks were carried out to investigate phase segregation in these materials. The effects of four principal parameters on phase segregation were examined: the weight fractions of the two components, the cross-link length, the connectivity of the network, and the ratio of the square-well interactions. The molecular simulation results confirmed trends observed in laboratory measurements.     

Sequentially photocleavable protecting groups in solid-phase synthesis

[reaction: see text] A sequential solid-phase peptide synthesis was developed using both photolabile linker and protecting groups. The chromatic sequential lability between a tert-butyl ketone-derived linker (sensitive to irradiation at 305 nm) and a nitroveratryloxycarbonyl (NVOC) group (sensitive at 360 nm) was exploited to prepare Leu-Enkephalin in a 55% overall yield. This new strategy allows the preparation of peptides in essentially neutral medium, by avoiding the use of common deprotection reagents such as trifluoroacetic acid or piperidine.     

Review coupling of capillary electrochromatography to mass spectrometry

This review discusses the development of capillary electrochromatography (CEC) coupled to mass spectrometric (MS) detection over the last few years. Major topics addressed are instrumental setups employed and applications of this technology published in the recent literature. The instrumental section includes a discussion of the most commonly used interfaces for the hyphenation of CEC and MS as well as ionization techniques. Applications reviewed in this paper come from a variety of different fields such as the analysis of biomolecules like proteins, peptides, amino acids or carbohydrates, chiral separations or the analysis of pharmaceutical an their metabolites in a series of matrices.     

Vibrational and high pressure conformational studies of 1,1,2-trichloroethane

The infrared spectra of 1,1,2-trichloroethane were recorded from 4000 to 50 cm^?1 in the vapour and liquid states. Additional spectra above 200 cm^?1 of the low temperature crystal and of two crystalline solids, prepared by compressing the sample in a diamond anvil cell, were obtained. Also, infrared spectra of the liquid and of the compound dissolved in CS₂ were recorded at increased pressures. Raman spectral data of the liquid (including polarization measurements) and of the low temperature crystal were obtained.The fundamental frequencies for each of the two conformers, C₁ and C_s, were assigned and the results checked by normal coordinate analysis. The same diagonal and off-diagonal force constants were employed for the two conformers and the force fields were derived by means of a least squares refinement, including data for chloroethane, 1,1-dichloroethane and various deuterated species. A standard deviation of 3 % was obtained in the final fit.From the changes in relative intensities for infrared bands belonging to the C₁ and C_s conformers with increasing pressure, the volume differences (ΔV¯between the conformers were determined in CS₂ solution and in the pure liquid.     

Essential spectrum and -solutions of one-dimensional Schrödinger operators

In 1949, Hartman and Wintner showed that if the eigenvalue equations of a one-dimensional Schrödinger operator possess square integrable solutions, then the essential spectrum is nowhere dense. Furthermore, they conjectured that this statement could be improved and that under this condition the essential spectrum might always be void. This is shown to be false. It is proved that, on the contrary, every closed, nowhere dense set does occur as the essential spectrum of Schrödinger operators which satisfy the condition of existence of -solutions. The proof of this theorem is based on inverse spectral theory.

     

Trennung von V,Cr und Mn aus Stahl und Aktivierungsanalyse der Legierungselemente mit 14 MeV-Neutronen

The elements are separated from iron by solvent-extraction. Cr, V and Mn are separated by ion-exchange chromatography with a strong acidic cation-exchanger. The elements are determined by 14 MeV-neutron activation analysis using γ-spectroscopy. The method is suitable for a concentration range of 0.05 to 5%.     

pH-Dependent force spectroscopy of tri(ethylene glycol)- and methyl-terminated self-assembled monolayers adsorbed on gold

Self-assembled monolayers (SAMs) of methoxy-tri(ethylene glycol)- (EG(3)-OMe) and methyl-terminated alkanethiols (C(16)) adsorbed on polycrystalline gold were investigated by chemical force spectroscopy. Measurements were performed in aqueous electrolyte solutions depending on ionic strength and pH value. Charged and hydrophobic tips were employed as probes to mimic local patches of proteins and to study the interaction at the organic/liquid interface in detail. Force-distance curves reveal information about the origin of the observed interaction and the underlying mechanisms. The measurements confirm an effective negative surface charge to be present at the oligo(ethylene glycol) (OEG) and the methyl interface and suggest that the charges are due to the adsorption of hydroxyl ions from aqueous solution. pH-dependent measurements further support the robustness of the established charge associated with the OEG films. Its sign does not change over the whole range of investigated values between pH approximately 3.5 and approximately 10. In contrast, the hydrophobic self-assembled hexadecanethiol films on gold show an isoelectric point (IEP) around pH 4. While the mechanism of charge establishment appears to be similar for both SA films, the strength of hydrogen bonding to interfacial water, which acts as a template for hydroxyl ion adsorption, is likely to be responsible for the observed difference.     

Can the highest occupied molecular orbital of the uranyl ion be essentially 5f?

Recent relativistic calculations on the uranyl ion suggest that the low wave numbers of the first electron transfer bands are due to a bonding 5f-like orbital containing the two loosest bound electrons. Comparison with UF₆ makes it more likely that if indeed σ_u (and not π_u) is the highest occupied MO, it is rather due to “pushing from below” by U 6p (like N 2s in N₂).     

Zur Struktur der Tetrahydro-4-phenylspiro([1]benzopyran-2,4′(1′H)-pyrimidin)-2′(3′H)-one bzw.-thione über Heterocyclen, 49. Mitt

The structures of tetrahydro-4-phenylspiro([1]benzopyran-2,4(1H)-pyrimidin)-2(3H)-ones and-thiones4 a, b resp., are proved by synthesis. 3-(2-methoxy-3,5-dimethylphenyl)-3-phenylpropionic acid11 b is prepared from 3,4-dihydro-6,8-dimethyl-4-phenylcoumarin10. The lithium salt of11 b reacts with isobutenyl-lithium to 1-(2-methoxy-3,5-dimethylphenyl)-5-methyl-1-phenyl-4-hexen-3-on12 a. 12 a is transferred with urea in acid medium and NH₄CNS resp. in a mixture of dihydro-6-[2-(2-methoxy-3,5-dimethylphenyl)-2-phenyläthyl]-4,4-dimethyl-2(1H)-pyrimidinone and-thione13 a, b and tetrahydro-6-[2-(2-methoxy-3,5-dimethylphenyl)-2-phenyläthyliden]-4,4-dimethyl-2(1H)-pyrimidinone and-thione14 a, b resp.14 b leads to13 a, b with H₂O₂. Heating of13 a, 14 a and14 b resp. with pyridin-HCl leads to the spiro compounds4 a, b.