吡嗪衍生物在石墨表面上的自组装单层膜结构

利用扫描隧道显微镜研究了荧光液晶分子2, 5-二-[2-(3, 4-二-十二烷氧基-苯基)-乙烯基]-3, 6-二甲基吡嗪(BPDP12)在石墨表面上自组装单层膜的结构. 实验结果表明, 该化合物在石墨表面形成两种自组装结构：一种是稳定的, 分子的共轭中心相互平行, 烷基链相互交错的密排结构；另一种是不稳定的, 分子的共轭中心彼此为烷基链所分隔的非密排结构. 分子之间较强的π-π作用和分子烷基链之间的范德华作用力对分子组装的取向形成竞争, 是产生两种不同组装结构的根本原因.     

Molecular caps for full quantum mechanical computation of peptide-water interaction energy

We present a systematic study of numerical accuracy of various forms of molecular caps that are employed in a recently developed molecular fractionation scheme for full quantum mechanical computation of protein-molecule interaction energy. A previously studied pentapeptide (Gly-Ser-Ala-Asp-Val) or P5 interacting with a water molecule is used as a benchmark system for numerical testing. One-dimensional potential energy curves are generated for a number of peptide-water interaction pathways. Our study shows that various forms of caps all give consistently accurate energies compared to the corresponding full system calculation with only small deviations. We also tested the accuracy of cutting peptide backbone at different positions and comparisons of results are presented.     

Vapor‐Phase Reaction of Citronellal over Mesoporous Molecular Sieves MCM‐41 and Zeolites

The vapor‐phase reaction of citronellal (CTN) at 220 °C and atmospheric pressure has been studied using mesoporous molecular sieves and zeolites in a fixed‐bed reactor. The primary products included isopulegol (IPG), menthone, and pulegol with subsequent reactions to form cyclic hydrocarbons. The CTN conversion and the product selectivity depend on the acidity and the textural property of catalysts. Lewis and/or Brönsted acid sites are essential for catalyzing this reaction. An increase of SiO₂/Al₂O₃ mol ratio diminishes the acid amount of all catalysts and enhances both the surface area and the structural order of MCM‐41. The catalytic activity follows the order of MCM‐41 > HZSM‐5 > Hβ > USY, in accordance with the relative total acid amount except that of MCM‐41. Despite its low acidity, Si‐MCM‐41 exhibits the best catalytic performance due to its uniform mesopores, large surface area and good stability; the CTN conversion and the IPG yield attain 91.9% and 58.6%, respectively, after at least 25 h time‐on‐stream.     

Further studies on synthesis of the 12,13-seco norditerpenoid alkaloids

After a series of optimization for the reaction conditions (reagents, reaction temperature, etc.), treatment of the sulfonates 4, 8, 13 and 15 with 8% NaOH (room temperature, 24 h) via a semipinacol rearrangement afforded the corresponding C-nor compounds 5, 9, 12 and 16, as the major of a pair of epimer at C-16, to an excellent extent, in 95%, 92%, 100% and 90% yield, respectively. The 12,13-seco compounds 21 and 22 (23) were obtained in 20% and 60% yield, respectively, by treating 5 with Br(2)-glacial HOAc (room temperature, 24 h). Treatment of the C-nor compounds 5 or 6, 16 or 17, and 28 from 10 with SOCl(2)-anhydrous benzene (room temperature, overnight) afforded the 12,13-seco compounds 24, 26 and 30 in 70% or 100%, 40% and 66% yield, respectively. When treatment of the C-nor compound 29 from 9 under same conditions gave the 12,13-seco products 30, 31 and 32 in 33%, 26% and 20% yield. When treating 21 or 24, and 26 with 5% KOH in EtOH afforded the 12,13-seco compounds 25 and 27 quantitatively, respectively. The compound 31 converted to 30 quantitatively by treatment with Na(2)CO(3) in MeOH. All of the new compounds were isolated and fully characterized.     

Effects of annealing treatment on the properties of MEH-PPV/titania hybrids prepared via in situ sol-gel reaction

A uniform poly[2-methoxy-5-(2′-ethylhexyloxy)-p-phenylenevinylene] (MEH-PPV)/titania hybrid film was successfully prepared by an in situ sol-gel reaction of titanium isopropoxide (TIP) in the presence of MEH-PPV/2-chlorophenol solution. The annealing treatment increased the conversion of TIP to titania as determined from evidence of the formation of Ti-O-Ti bonds in the Fourier transform infrared (FTIR) spectrum. Scanning electronic microscope (SEM) photographs showed that the morphology and distribution of titania in the hybrid film were strongly related to the amount of water in the in situ sol-gel reaction. The thermal stability of MEH-PPV/titania hybrids was enhanced by the annealing treatment. Small angle X-ray scattering (SAXS) and X-ray diffraction (XRD) analyses indicated that annealing treatment promoted the ordered aggregation of the MEH-PPV chains and crystallization of titania to a certain extent. The blue shift in Ultraviolet-visible (UV-vis) absorption of pure MEH-PPV after annealing was ascribed to the small extent of decomposition and coil conformation which occurred at high temperature. A more-obvious blue shift for the hybrids was observed, which resulted from irregular aggregation and coil conformation of the MEH-PPV chains induced by heterogeneous point, TIP (titania). The red shift in the photoluminescent (PL) emission for pure MEH-PPV resulted from a certain extent of ordered aggregation after annealing. However, only a slight red shift in the PL emission peak for the hybrids was found due to the hindrance of ordered aggregation of MEH-PPV chains in the presence of TIP (titania).     

Comparative study on the synthesis, photoluminescence and application in InGaN-based light-emitting diodes of TAG:Ce phosphors

Cerium-doped terbium aluminum garnet phosphors, Tb₃Al₅O₁₂:Ce³⁺ (TAG:Ce³⁺), were prepared with different methods: co-precipitation (CP), half dry-half wet (HDHW), sol-combustion (SC) and Pechini method plus conventional solid state reaction (SS) method. Comparative study on the phase-formation, particle size, morphologies and luminescent characteristics of the phosphors synthesized with different methods was carried out by means of XRD, FE-SEM and photoluminescence (PL) analysis and SC method was confirmed by the comparison of the results to be an easy and an effective process for preparing efficient and nano-sized Tb₃Al₅O₁₂:Ce³⁺ phosphors. Various factors influencing particle size, morphology and PL of the phosphors, such as precursor preparation, reaction temperature and heating time, were also investigated. Light-emitting diodes (LEDs) were fabricated with each phosphor and a ∼460 nm emitting InGaN chip. The LEDs from SS, HDHW and CP exhibit strong white emission while those from SC and Pechini emit yellow, revealing that the emission characteristics of LEDs are influenced not only by the morphology and the particle size of the phosphors, but also by the preparing process of the phosphors.     

Hydrothermal Synthesis and X‐Ray Structural Characterization of Manganese,Nickel, and Cadmium Coordination Polymers Containing 2,3‐Pyridinedicarboxylate as Multidentate Ligands

Three divalent transiton‐metal complexes of 2,3‐pyridinedicarboxylate (2,3‐pda²), [Mn(2,3‐pda)‐(H₂O)3]_∞ ( 7 ), [Ni(2,3‐pda)(H₂O)3]_∞ ( 8 ), and [Cd2(2,3‐pda)₂(H₂O)]_∞ ( 9 ) have been hydrothermally synthesized and structurally characterized. X‐ray diffraction analyses reveal that compounds 7 and 8 are zigzag‐ and linear‐type one‐dimension (1D) coordination polymers, respectively, whereas compound 9 is a three‐dimension (3D) coordination polymer. A simple comparison of the coordination geometries with the available neutral analogues {M_x(2,3‐pda)_x(H₂O)_y}_∞ containing one or two divalent transition‐metal atoms and equal ligands in the presence or absence of coordinated water molecules is also presented.     

β-环糊精在TiO2上的吸附及其对光催化影响研究

用酚酞法测定TiO2悬浮液中β-环糊精(β-CD)的量以及用β-CD溶液平衡的TiO2经过滤、洗涤和干燥后进行漫反射红外光谱和XPS能谱表征．结果表明：β-CD分别在纳米和P25型TiO2表面通过羟基间作用形成化学吸附，吸附量与溶液pH值有关，且最大吸附量在TiO2等电点附近．β-CD可提高两种TiO2对甲基橙光催化脱色速率.提高的效率与溶液pH值有关．实质上，提高的效率与β-CD在TiO2表面吸附量和甲基橙在TiO2表面的静电吸附量有关，即与甲基橙-β-CD—TiO2三元间的相互作用有关。     

Synthesis and structure of Mn(II) and Zn(II) complexes containing 1,10-phenanthroline unit

The Mn(II) and Zn(II) complexes of N,N′-diisopropyl-1,10-phenanthroline-2,9-dimethanamine have been synthesised, and the structure of the two complexes have been studied by X-ray crystallography.