Control of vortex formation from a vertical cylinder in shallow water: Effect of localized roughness elements

Vortex formation from a vertical cylinder in shallow water is controlled by placement of a narrow transverse strip of roughness elements on the bed (bottom surface). A technique of high-image-density particle image velocimetry is employed to obtain global, instantaneous representations of the flow patterns, which lead to phase- and time-averaged patterns of streamline topology and Reynolds stress on planes at and above the bed. Near the bed, the overall form of the streamline topology is maintained, even at larger heights of the roughness elements. With increasing height of the elements, the downstream saddle point is further displaced in the streamwise direction. Correspondingly, the streamwise extent of the negative pocket of the streamwise velocity component, i.e., the region of reverse flow along the bed surface, increases substantially in the streamwise direction. The Reynolds stress in the very near-wake, at locations upstream of the roughness elements, is significantly attenuated, even for small height of roughness. This attenuation occurs not only near the bed surface, but also at the midplane of the shallow water wake, and thereby indicates that the consequence of localized roughness is to exert a global influence. In fact, corresponding patterns of instantaneous velocity and vorticity indicate that consistent formation of large-scale vortices in the very near-wake region is attenuated with relatively small surface roughness on the bed. Downstream of the roughness elements, the patterns of Reynolds stress near the bed surface, as well as at the midplane of the water layer, are significantly altered relative to the case of no roughness. Near the bed, highly concentrated patterns of positive and negative Reynolds stress in the absence of roughness give way to lower-level regions of Reynolds stress in the form of alternating concentrations; the particular pattern depends on the height of the roughness elements. At the midplane of the water layer, the Reynolds stress patterns maintain their same overall form, but the extrema of the Reynolds stress concentrations are attenuated in magnitude and are shifted in the downstream direction, with increasing height of the roughness elements. These observations are complemented by patterns of instantaneous velocity and vorticity.     

An unusual case of acute disseminated encephalomyelitis confined to brainstem

Acute disseminated encephalomyelitis (ADEM) is an immune-mediated demyelinating disorder usually encountered in children or adolescents and characterized by multifocal neurological deficits of rapid onset. Typical target areas of demyelination include the corona radiata, centrum semiovale, periventricular white matter, cerebellar peduncles and brainstem. Involvement of deep gray matter nuclei is also frequent. We report a 6-year-old boy with ADEM who had only brainstem involvement. Serial magnetic resonance images representing the stage of disease and response to steroid treatment are presented.     

Homo‐ and heteropolynuclear copper(II) complexes containing a new diimine–dioxime ligand and 1,10‐phenanthroline: synthesis,characterization, solvent‐extraction studies,catalase‐like functions and DNA cleavage abilities

A series of homo‐, heterodinuclear and homotrinuclear copper(II) complexes containing a new Schiff base ligand and 1,10‐phenanthroline were synthesized. Based on results of elemental analyses, FTIR, ¹H‐ and ¹³C‐NMR spectra, conductivity measurements and magnetic susceptibility measurements, the complexes had general compositions {[Cu(L)(H₂O)M(phen)₂](ClO₄)₂ [M = Cu(II), Mn(II), Co(II)]} and {[Cu₃(L)₂(H₂O)₂](ClO₄)₂}. The metal:L:phen ratio is 2:1:2 for the dinuclear copper(II) complexes and the metal:L ratio was 3:2 for the trinuclear copper(II) complex. The liquid–liquid extraction of various transition metal cations [Mn(II), Co(II), Ni(II), Cu(II), Zn(II), Pb(II), Cd(II), Hg(II)] from the aqueous phase to the organic phase was carried out using the diimine–dioxime ligand. It was concluded that the ligand can effectively be used in solvent extraction of copper(II) from the aqueous phase to the organic phase. Furthermore, catalytic activitiy of the complexes for the disproportionation of hydrogen peroxide was also investigated in the presence of imidazole. Dinuclear copper(II)–manganese(II) complex has some similarity to manganese catalase in structure and activity. The interaction between these complexes and DNA has also been investigated by agarose gel electrophoresis; we found that the homo‐ and heterodinuclear copper complexes can cleave supercoiled pBR322 DNA to nicked and linear forms in the presence of H₂O₂. Copyright © 2009 John Wiley & Sons, Ltd.     

Synthesis of (2-hydroxo-5-chlorophenylaminoisonitrosoacetyl)phenyl ligands and their complexes: Spectral,thermal and solvent-extraction studies

Four different types of new ligands Ar[COC(NOH)R] _n (Ar=biphenyl, n = 1 H₂L¹; Ar=biphenyl, n = 2 H₄L²; Ar=diphenylmethane, n = 1 H₂L³; Ar=diphenylmethane, n = 2 H₄L⁴; R=2-amino-4-chlorophenol in all ligands) have been obtained from 1 equivalent of chloroketooximes Ar[COC(NOH)Cl] _n (HL¹-H₂L⁴) and 1 equivalent of 2-amino-4-chlorophenol (for H₂L¹ and H₂L³) or 2 equivalent of 2-amino-4-chlorophenol (for H₄L² and H₄L⁴). (Mononuclear or binuclear cobalt(II), nickel(II), copper(II) and zinc(II) complexes were synthesized with these ligands.) These compounds have been characterized by elemental analyses, AAS, infra-red spectra and magnetic susceptibility measurements. The ligands have been further characterized by ¹H NMR. The results suggest that the dinuclear complexes of H₂L¹ and H₂L³ have a metal:ligand ratio of 1:2; the mononuclear complexes of H₄L² and H₄L⁴ have a metal:ligand ratio of 1:1 and dinuclear complexes H₄L² and H₄L⁴ have a metal:ligand ratio of 2:1. The binding properties of the ligands towards selected transition metal ions (Mn^II, Co^II, Ni^II, Cu^II, Zn^II, Pb^II, Cd^II, Hg^II) have been established by extraction experiments. The ligands show strong binding ability towards mercury(II) ion. In addition, the thermal decomposition of some complexes is studied in nitrogen atmosphere.     

Preparation of quaternized dimethylaminoethylmethacrylate grafted nonwoven fabric for the removal of phosphate

Dimethylaminoethylmethacrylate (DMAEMA) grafted polyethylene/polypropylene (PE/PP) nonwoven fabric was prepared by radiation-induced graft polymerization. Grafting conditions were optimized and about 150% DMAEMA grafted samples were used for further experiments. DMAEMA graft chains were later quaternized with dimethyl sulphate for the removal of phosphate ions. Adsorption experiments were conducted with quaternized DMAEMA grafted fabric for phosphate removal at low (0.5–25 ppm) and high phosphate concentrations (50–1000 ppm). Adsorbed phosphate amounts at pH 7 were found to be 63 mg phosphate/g polymer and 512 mg phosphate/g polymer for low (25 ppm) and high phosphate concentrations (1000 ppm) respectively showing the efficiency of the adsorbent material in removing phosphate. The pH effect on phosphate adsorption showed that the quaternized DMAEMA grafted nonwoven fabric can adsorb phosphate over a wide pH range (5.00–9.00) indicating that adsorbent material can effectively remove different forms of phosphate ions, namely H₂PO₄^?, HPO₄^2? and PO₄^3? in aqueous solution at this pH range where the species exist. Competitive adsorption experiments were also carried out with two concentration levels at pH 7 to investigate the effect of competing ions. Phosphate adsorption on quaternized DMAEMA grafted nonwoven fabric was found to be higher than the other competing ions at two concentration levels. At high concentration level, the adsorption order was phosphate>nitrite>bromide>sulphate>nitrate whereas at low concentration level, the order was phosphate?sulphate>bromide>nitrite>nitrate.     

Modeling stock index returns by means of partial least‐squares methods: An out‐of‐sample analysis for three stock markets

We analyze the underlying economic forces of the stock markets in Germany, the U.K. and the U.S. Identifying a number of variables evincing return predictability, we follow a partial least‐squares (PLS) approach to combine these observables into a few latent factors. Conditional on European markets, our findings indicate (i) superior prediction performance of PLS‐based schemes in comparison with both, a random walk and a first‐order autoregressive benchmark model, (ii) consistent profitable trading on the German and British market, (iii) profitable linear forecast combinations, (iv) the U.S. stock market is diagnosed as informationally efficient. Copyright © 2010 John Wiley & Sons, Ltd.     

Synthesis,Antimicrobial Activity and Semi-conducting Properties of Novel 2-(4-Chloro-1-Naphtyloxy)-2-Oxoethyl Methacrylate with 2-(Diethylamino)Ethyl Methacrylate Copolymers

The free-radical initiated copolymerization of 2-(4-chloro-1-naphtyloxy)-2-oxoethyl methacrylate (ClNOEMA) with 2-(diethylamino) ethyl methacrylate (DEAEMA) was carried out in 1,4-dioxane solution at 70 ± 1°C using 2,2′-azobisisobutyronitrile (AIBN) as an initiator with different monomer-to-monomer ratios (ranging from 0.15 to 0.85) in the feed. The copolymer composition obtained by elemental analysis led to the determination of reactivity ratios employing Fineman-Ross (F-R) and Kelen-Tüdös (KT) linearization methods. These parameters were also estimated using a non-linear computational fitting procedure, known as reactivity ratios error in variable model (RREVM). The prepared homo and copolymers were tested for their antimicrobial activity against bacteria and yeast. These copolymers have been converted into novel salts by reaction with the iodemethane (CH₃I). The copolymers and the corresponding salts have been characterized fully by a range of spectroscopic analysis techniques. The electrical conductivity dependence of temperature of the polymers were measured and the polymers exhibit the semi-conducting behavior, confirming that the electrical conductivity increases with increasing temperature. The poly(CINOEMA-co-DEAEMA) polymer doped by CH₃I for 15 min shows the highest conductivity. The optical band gap, activation energy and room temperature conductivity values of these polymers were obtained. These electronic parameters suggest that the poly(CINOEMA-co-DEAEMA)s doped by CH₃I for 15 min is an organic semiconductor with the thermally activated conduction mechanism.     

Synthesis of Some Polymer‐Metal Complexes and Elucidation of their Structures

In this study, the nine coordination polymers of Fe(III), Co(II) and Ni(II) salts have been synthesized using polyacrylamide (PAA), polt(ethylene glycol) (PEG) and poly(vinyl alcohol) (PVA) and their structures were characterized by magnetic and conductivity measurements, ultraviolet‐visible (UV‐VIS), FTIR spectroscopy and thermogravimetric analysis (TGA). The structures of Fe(III) complexes in the all coordination polymers were found as tetrahedral. The structures of PAA‐Co(II) coordination polymer was determined as octahedral geometry whereas PEG‐Co(II) and PVA‐Co(II) complexes showed as tetrahedral structure. PAA‐Ni(II) and PEG‐Ni(II) complexes have octahedral geometry, whereas PVA‐Ni(II) has a square planar structure. Besides, the stress‐strain experiments of PVA‐metal coordination polymers obtained rubber‐like structure were carried out and the value of breaking‐strain of PVA‐Ni(II) complex was found to be about 17% of vulcanized natural rubber. The conductivities of the resulting polymer‐metal complexes were measured by four‐probe technique and were found in the range 10^?5?10^?6 Scm^?1. Thus, it was suggested that they can be used in the field potential application of conducting polymers. TGA results revealed that among the complexes PEG‐Fe(III) and PVA‐Fe(III) complexes have the highest thermally stable.     

Dendronized polymers via Diels–Alder “click” reaction

A modular approach toward the synthesis of polymers containing dendron groups as side chains is developed using the Diels–Alder “click” reaction. For this purpose, a styrene‐based polymer appended with anthracene groups as reactive side chains was synthesized. First through third‐generation polyester dendrons containing furan‐protected maleimide groups at their focal point were synthesized. Facile, reagent‐free, thermal Diels–Alder cycloaddition between the anthracene‐containing polymer and latent‐reactive dendrons leads to quantitative functionalization of the polymer chains to afford dendronized polymers. The efficiency of this functionalization step was monitored using ¹H and ¹³C NMR spectroscopy and FTIR and UV–vis spectrometry. © 2009 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 48: 410–416, 2010