Schechter Methods of Interpolation and Commutators

We study the relationship between Schechter's methods of complex interpolation and the so called commutator estimates. We obtain new commutator theorems and prove characterizations of the Domain and Range spaces associated with the corresponding quasilogarithmic operator. Our methods also provide a new approach to known results, including the higher order commutator theorems for the complex method recently obtained by R. Rochberg .     

Pesticides in seaweed: optimization of pressurized liquid extraction and in-cell clean-up and analysis by liquid chromatography–mass spectrometry

Chemical residues, such as insecticides and anthelmintics, are frequently redistributed from the aquatic environment to marine species. This work reports on a fast validated protocol for the analysis of azamethiphos, three avermectins, two carbamates and two benzoylurea pesticides and chemotherapeutic agents in seaweeds based on pressurized liquid extraction and separation of analytes by liquid chromatography coupled with tandem mass spectrometry. The variables affecting the efficiency of pressurized liquid extraction, including temperature, number of extraction cycles, static extraction time and percent acetonitrile flush volume, were studied using a Doehlert design. The optimum parameters were 100 °C and one cycle of 3 min with 70 % acetonitrile. Adequate in-cell clean-up of the seaweeds was achieved using 0.8 g of Florisil over 0.1 g of graphitized carbon black on the bottom of the cell. The optimized method was validated using an analyte-free seaweed sample fortified at different concentrations. The limits of quantification ranged from 3.6 μg kg(-1) (azamethiphos) to 31.5 μg kg(-1) (abamectin). The recovery was from 87 to 120 % in most cases at different spiking levels. Finally, the reproducibility of the method expressed as the relative standard deviation and evaluated at concentrations of 10 and 50 μg kg(-1) was in the range 9-14.3 % and 6.1-12.3 %, respectively. The applicability of the method was evaluated with five commercial and 12 wild edible seaweeds, and four target compounds were detected in two wild seaweeds at a concentration below the quantification limit.     

Design of a field flow preconcentration system for cadmium determination in seawater by flow-injection-atomic absorption spectrometry

A field flow preconcentration system (FFPS) for cadmium determination in seawater is described. Seawater samples are collected and preconcentrated in situ by passing them with a peristaltic pump through a minicolumn packed with Amberlite XAD-4 impregnated with the complexing agent 1-(2-pyridylazo)-2-naphthol. Thus, cadmium is complexed, retained, and preconcentrated without the interference of the saline matrix. Minicolumns loaded with cadmium are then returned to the laboratory where they are incorporated into a flow injection system and eluted with a small volume of an ethanolic solution of hydrochloric acid into the nebuliser-burner system of a flame atomic absorption spectrometer. The optimization of FFPS design is presented, and the stability and characteristics of the Cd-loaded minicolumns are studied in detail. The detection limit for Cd in seawater based on an enrichment factor of 1059 was 3.8 ng l(-1). The precision (R.S.D.) obtained for different amounts of cadmium was in the range 4.1-6.5% at the 25-100 ng l(-1) level. Analysis of certified reference materials (SLEW-3 and NASS-5) showed good agreement with the certified value. This procedure was applied to the determination of cadmium in seawater samples from Galicia (Spain).     

Changes in the growth mode of electrodeposited silver layers: Surface rearrangements induced by the presence of lead adatoms

The surface characteristics of Ag electrodeposits prepared on polyfaceted Pt(sc) electrodes have been followed through complete Pb upd/stripping voltammetry. The growth mode of Ag overlayers at constant temperature depends on both the cathodic electrodeposition overvoltage and the silver ion concentration in solution. Ag surface rearrangements can be induced by either holding the potential or Pb upd/stripping cycling in the potential range where the degree of surface coverage by Pb adatoms is between 0 and 1. The voltammograms of Ag overlayers at the monolayer level show considerable changes compared with those obtained for thicker Ag overlayers. The present results allow us to establish a correlation between the development of rough electrodeposits and the surface diffusion properties of metal atoms.     

Application of chromatographic and electrophoretic methodology to the speciation of organomercury compounds in food analysis

Trace metals such as mercury, especially its organic compounds, are an important risk to the environment and to man due to their accumulation in the food chain. For this reason, the routine determination of the very toxic methylmercury, and of other organic and inorganic mercury compounds in marine and land animals, vegetables, fruits and fresh water is of increasing importance in health and environmental control programmes throughout the world. The majority of speciation methods for organomercurials involve a series of fundamental steps for the identification and quantification of samples of biological origin: extraction or isolation from the matrix; derivatisation and concentration; detection; separation of different species of interest and of interference. Each of these steps, as part of the chromatographic analysis of MeHg and of other organomercurials is revised in this study using food samples.     

Electrochemical self-assembly of melanin films on gold

An electrochemical method for self-assembling melanin films on the Au(111) surface from melanin aggregates in alkaline media is reported. Electrochemical data combined with scanning tunneling microscopy (STM), atomic force microscopy, and Auger electron spectoscopy show that the amount and structure of the deposited melanin film depend on the potential (E) applied to the electrochemical interface and deposition time. Film formation takes place at a noticeable rate at E = -1.0 V (vs SCE). High-resolution STM images at the early stages of growth show small particles, 5-8 nm in size and 0.3-0.4 nm in height, forming ordered arrays that follow closely the Au(111) topography. The size of the melanin particles increases as the film thickness increases, reaching 150 nm for deposits grown for 16 h. The deposited films are electrochemically active, showing well-defined redox couples preceding the hydrogen evolution reaction.     

Interdisciplinary study for the evaluation of biochemical alterations on mussel <Emphasis Type="Italic">Mytilus galloprovincialis</Emphasis> exposed to a tributyltin-polluted area

An interdisciplinary approach was employed to monitor the concentration and the effects of butyltin compounds in mussels (Mytilus galloprovincialis). Tissues from animals exposed to a marine area (Vado Ligure harbour) with a high concentration of tributyltin (TBT) were analysed and compared with control samples. TBT concentrations were measured by gas chromatography–mass spectrometry and the protein pattern in gill tissues was studied by proteomic analysis. Several proteomic signatures associated with contaminant exposure were observed; spots that were significantly increased in all contaminated samples were identified by mass spectrometry as fragments of β-tubulin. The degradation of β-tubulin was then confirmed by western blot analysis with specific anti-β-tubulin antibody. The effects observed on mussel gills after exposure in the TBT-polluted area are discussed.     

On the evolution of the rate of polymerization,number and size distribution of particles in styrene emulsion polymerization above CMC

This work is an extension of a communication reported by two of the authors [Carro and Herrera‐Ordoñez, Macromol Rapid Commun 2006, 27, 274], where bimodal particle size distributions (PSD), obtained by asymmetric flow‐field flow fractionation (AFFF, AF⁴), were taken as evidence of certain degree of stability of primary particles. Now, emulsion polymerizations of styrene were performed under conditions employed before by other researchers, intending to examine if the behavior observed is general. The number of particles (N) and PSD were studied by means of dynamic light scattering and AF⁴. By the later, bimodal PSDs were detected in all cases, where the population corresponding to primary particles (diameter <20 nm) depends on reaction conditions. Regarding N, AF⁴ results show that it is constant during interval II, in contrast to DLS results. Primary particle coagulation was evidenced as minimums in N evolution and the rate of polymerization curves, monitored by calorimetry and gravimetry, which are enhanced when higher particle number is generated and/or the ionic strength is increased. These results suggest that particle coagulation is not as extensive as it would be expected according to the coagulative theory. © 2010 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 48: 3152–3160, 2010     

Response surface methodology for the optimization of dispersive liquid–liquid microextraction of chloropropanols in human plasma

Chloropropanols are processing toxicants with a potential risk to human health due to the increased intake of processed foods. A rapid and efficient method for the determination of three chloropropanols in human plasma was developed using ultrasound‐assisted dispersive liquid–liquid microextraction. The method involved derivatization and extraction in one step followed by gas chromatography with tandem mass spectrometry analysis. Parameters affecting extraction, such as sample pH, ionic strength, type and volume of dispersive and extraction solvents were optimized by response surface methodology using a pentagonal design. The linear range of the method was 5–200 ng/mL for 1,3‐dichloro‐2‐propanol, 10–200 ng/mL for 2,3‐dichloro‐2‐propanol and 10–400 ng/mL for 3‐chloropropane‐1,2‐diol with the determination coefficients between 0.9989 and 0.9997. The limits of detection were in the range of 0.3–3.2 ng/mL. The precision varied from 1.9 to 10% relative standard deviation (n = 9). The recovery of the method was between 91 and 101%. Advantages such as low consumption of organic solvents and short time of analysis make the method suitable for the biomonitoring of chloropropanols.