POLYMERIZATION OF OCTAFLUOROCYCLOBUTANE IN GLOW DISCHARGE Ⅱ. ESCA AND IR CHARACTERIZATION OF POLYMER STRUCTURE*

In a capacitively coupled discharge with external electrodes, He, H_2, N_2 or Ar were used as plasmagas, polymerization of octafluorocyclobutane was carried out under different conditions by varyingdischarge power, pressure, plasma gas and plasma-gas/monomer ratio. Structure of polymerizedproducts was characterized by IR spectroscopy and ESCA measurement. It was found that therewere six elements in the products, i.e. C, F, Si, O, N and H. The probably existed groups in poly-mers wer investigated. By analyzing the resolved peaks of C_(1S) region in ESCA spectra, effect of thereaction conditions on degree of branching of the polymerized products and the relationship of thepolymer structure wth the mechanism of the competitive ablation and polymerization process werestudied. In addition, polymer deposition process occurring in glow discharge was discussed.     

锰—铈复合氧化物催化剂表面氧的性质

氧化锰催化剂广泛用于一氧化碳常温氧化及汽车尾气的净化等,CeO_2是氧化物催化剂的优良助剂。非贵金属催化剂中添加CeO_2能提高催化剂的氧化活性已有很多报道,但有关Ce对氧化锰结构及表面氧脱附性能影响的研究尚不多见。本文运用XRD、DTA和TPD-MS等手段对共沉淀法制得的Mn-Ce复合氧化物进行了物相结构和脱氧活性研究。     

固体Hp[EuA_4]配合物异构体的研究

合成了化学式为Hp[EuA_4]的配合物(A=对甲氧基苯甲酰苯甲酰甲烷;Hp=六氢吡啶),用X-射线粉末衍射法,荧光光谱及热谱等方法研究了它们的性质,并发现由于合成条件(反应物的摩尔投量比,反应温度,所用溶剂)不同,在固体Hp[EuA_4]配合物中配体空间的排布不同,而有不同的异构体存在。     

CuCrAl和CuCrZr低温液相合成甲醇催化剂的研究

 用络合共沉淀法制备了CuCrAl和CuCrZr复合氧化物液相合成甲醇催化剂，其比表面分别达到119和116m2／g．在5．0～5．5MPa和383K条件下，分别用间歇式和流动式反应釜考察了催化剂的活性和稳定性．结果表明：CuCrAl和CuCrZr的活性均明显高于CuCr；CuCrAl的活性略高于CuCrZr，但甲酸甲酯（MF）的选择性明显低于CuCrZr；两者在12h内未见活性明显下降．甲醇钠在反应过程中部分转化为甲酸钠和NaOH．CuCrAl和CuCrZr有较高的氢解活性可抑制甲醇钠与MF生成甲酸钠，从而有较低的甲酸钠浓度．但是，Al2O3和ZrO2的酸性有利于甲醇脱水，引起甲醇钠水解生成NaOH．溶剂对CuCr基催化剂的活性和选择性有明显影响．对反应机理进行了讨论．     

烯烃氢甲酰化催化剂活性物种的原位1H NMR研究

The rhodium-phosphine complex catalyst Rh(CO)(acac)(PPh3)(Ⅰ) for 1-hexene hydroformylation was studied under the following reaction conditions: CO/H2=1(mole rate), pressure 1.0 MPa, temperature 25-120℃, by using the pressurized in-situ 1H NMR technique. Experimental results indicated that the formation of a rhodium hydride complex from (Ⅰ) began at room temperature and its amount increased with increasing of reaction temperature. This intermediate complex began to decompose at 100℃ and disapeared completely at 120℃. The intensity change of the proton signal was parallel to catalytical activity in hydroformylation of olefins. Under pure CO pressure the proton signal of Ph-H bond was not observed. There was a 0.2 ppm difference in proton chemical shifts of Rh-H bond under pure H2 pressure and under H2+CO pressure. The results showed that the rhodium-hydride carbonyl complex is the active intermediate in the industrial hydroformylation process.     

CuO/TiO2的制备及对NO＋CO反应性能的研究

以三种不同的TiO2为载体，负载6%CuO，在色谱-微反装置上考察了三种Cu6-Ti催化剂对NO＋CO反应的活性。结果表明，由于制备方法不同，活性差别很大，三者活性顺序依次为：Cu6-Ti(T)> Cu6-Ti(S)> Cu6-Ti(nm)，TiO2的比表面积及晶型对活性的影响不明显。H2-TPR结果表明，Cu6-Ti在整个TPR过程中出现了3或4个还原峰，表明有多种CuO物种存在。不同预处理Cu6-Ti的TPR显示，在反应中Cu物种可能以多种价态同时存在。NO-TPD结果亦证明，Cu6-Ti对NO＋CO的反应活性与NO在催化剂表面的解离难易密切相关，而与NO的吸附量关系不大。     

2,6-二(对氨基苯)苯并[1,2-d;5,4-d′]二噁唑的合成和纯化

1 ,2 ,3 三氯苯经过硝化、水解、催化加氢、缩合等四步反应 ,合成了 2 ,6 二 (对氨基苯 )苯并 [1,2 d ;5 ,4 d′]二唑 ,总产率为 70 % .同时 ,研究了一种有效的重结晶 2 ,6 二 (对氨基苯 )苯并 [1,2 d ;5 ,4 d′]二唑的方法 .与其他方法相比 ,该法原料便宜易得 ,产物可作为聚合反应的单体原料 .     

Indirect Determination of Captopril with Sodium Nitrate and Thiocyanate by Floatation Separation of Copper

A new method for indirect determination of captopril (CPT) with NaNO₃ and NH₄SCN by floatation and separation of copper has been studied. In the weak acid, a small amount of Cu(II) can be reduced to Cu(I) by CPT, then Cu(I) reacted with the SCN, which can float on the surface of the liquid phase with NaNO₃. A good linear relationship is observed between the floatation yield (E%) of Cu(II) and the amount of captopril. The linear range is 2?32 mg/L. On the ground, captopril can be indirectly determined by determining E(%) of Cu(II). The method is simple, rapid, reliable and has good selectivity. The developed method can be applied to indirect determination of captopril with satisfactory results.     

N-(2-羧基-1,3,4-噻二唑-5-基)-N''-芳酰基硫脲与芳氧乙酰基硫脲的合成与生物活性

为了寻找高活性的杂环农药,用5-氨基-1,3,4-噻二唑-2-羧酸与芳酰基异硫氰酸酯及芳氧乙酰基异硫氰酸酯反应,合成出18种新的芳酰基硫脲与芳氧乙酰基硫脲,采用红外光谱、核磁共振氢谱和元素分析证明了其结构,初步的生物活性测定试验表明,部分目标化合物具有良好的植物生长调节活性,其中2c,2d,3b和3g具有良好的生长素活性.     

RE(III)与2-羰基丙酸水杨酰腙配合物的合成、表征及热化学

用2-羰基丙酸水杨酰腙与轻稀土硝酸盐反应,合成了7种新的配合物.经元素分析、化学分析及X射线粉末衍射等手段确定了其组成为RE(C10H9N2O4)(C10H8N2O4)·nH2O(RE=La、Ce、Pr、Nd、Sm、Eu、Gd),用红外、紫外、荧光光谱分析对以上配合物的结构进行了表征;用微热量计测定了稀土芳酰腙配合物的溶解焓,发现其溶解焓数据不随稀土原子序数单调变化,而呈转折变化,可认为呈稀土的四分组现象的前两组.