应用波分复用改善像束传像系统像质的研究

本文通过分析空间波分复用系统中包散元件的色散平均效应,用线扩散传递函数研究了像束传像性质,由光学成像的本征理论用像束成像信息量分析了波分复用改善像束传像像质的机制,并从实验上验证了上述分析结论.     

岩盐型ZnO纳米微粒的光电子发射结构

报道了岩盐型氧化锌纳米微粒的X射线光电子发射结构,发现其中3d电子的强烈成键作用,还存在着3d-4sp杂化和离域电子弛豫态的贡献,表现出与纤锌矿型明显的差异. 关键词：     

A DEMONSTRATION OF 1×8 LINEAR ARRAY YBCO TRANSITION EDGE IR BOLOMETER

A high-T_c superconducting array microbolometer has been fabricated by using a YBCO film. Optical measurements gave moderate performance as individual detector, but singnificant improverment appears possible.     

光致折射效应中空间电荷场建立过程的研究

本文推导了包含自衍射及非线性吸收影响、用以描述空间电荷场建立过程的微分方程组,阐明了周期性的空间电荷场与光强干涉条纹之间的相位差在建立过程中所起的作用,并推导了描述条纹倾斜和弯曲的微分方程。通过数值计算找到了硅酸铋(BSO)晶体中能量转移的规律,讨论了材料特性对过程快慢的影响,提出了用CW激光来探讨瞬态过程快慢的可能性。     

三维随机Ising模型的亚稳态性(Ⅱ)

讨论三维格点环面上随机Ising模型当温度趋向零时的亚稳态性,确定从自旋全为-1的组态到自旋全为+1的组态的最大似然路径和临界组态,并计算出从自旋全为-1的组态出发首次到达自旋全为+1的组态的首达时间的渐近对数估计。证明利用一族带指数扰动的Markov链的大偏差估计。     

[二苯并-18-冠(醚)-6]KC60奇异特性的核磁共振研究

报道了用［二苯并-18-冠（醚）-6］修饰的碱金属富勒烯作核磁共振测试的一些结果．这类碱金属富勒烯呈现的奇特物理特性，反映了材料在低于200K温度下的磁有序性及电子磁矩与核磁矩的强相互作用，使共振信号增强，亦反映了超分子化学能调控碱金属富勒烯的物理性能 关键词：     

Effects of Post-Thermal Treatment on Quality of SiC Grown by PVT Method

We report the effects of post-thermal treatment on the quality of 2-inch 6H-SiC wafer cut from a crystal boule grown by physical vapour transportation method. The full widths at half maximum of x-ray diffraction rocking curves measured on sites across the 2-inch wafer become narrower, indicating the quality improvement after a three-step post-thermal treatment. It is found that the most common defects such as micropipes and inclusions can be significantly reduced after the treatment. Our results show that the post-thermal treatment is an effective route to improve the quality of SiC single crystals.     

Modulation Frequency Multiplexed Tunable Diode Laser Spectroscopy System for Simultaneous CO, CO2 Measurements

A modulation frequency multiplexed dual diode-laser system is developed for simultaneous detection of the two most common fire gas products CO and CO2. Simultaneous detection is achieved by modulating each laser at different frequencies, demodulating the signal by a pair of lock-in amplifiers for each gas. Laser beams are combined and detected by one detector after passing through an identical optical path. The experimental results show little performance degradation associated with modulation frequency multiplexing, and no cross-talk between the two multiplexed detection channels is measured.     

�˻����/ͭ�ȵȾ�ѹ��ɢ���ӽ����Ӱ��

As the ITER first wall Be/CuCrZr hot isostatic pressing (HIP) bonding intermediate transition layer, Ti/Cu layer can form a multi-layer intermediate metal phase, and defects such as cracks occur between the Ti/Cu metal phases. CuCrZr was used instead of Be, and a number of CuCrZr/Ti/Cu/CuCrZr joints were fabricated by the same HIP process as Be/CuCrZr to analyze the Ti/Cu joints. The effects of stress relief annealing on joint strength and defect distribution of the joints unannealed, annealed at 400°C and 500°C respectively were studied. The results show that three layers of Ti/Cu diffusion layers are formed on both sides of the intermediate titanium layer, namely Cu₄Ti, CuTi and CuTi₂. The thickness of Cu₄Ti on the pure copper side is thicker than that on the CuCrZr side, so that the crack is almost entirely distributed at the junction of Cu₄Ti and CuTi on the pure copper side where brittle fracture is easy to occur in the tensile samples. As the annealing temperature increases, the generation and propagation of cracks decreases.     

损伤断裂图型演化的统计描述

本文采用动力学演化与随机跃迁并存的模型,研究损伤断裂图型的演化规律。根据演化的终态,损伤演化可分为整体稳定(GS)和演化引起剧变(EIC)两种模式,后者联系于断裂现象。本文引入统计描述,并指出,即使微损伤的连接规律是确定性的,无序介质中断裂的出现亦应以概率分布函数描写。