Ab-initio molecular dynamics simulation on nano-system under external pressure

A new constant-pressure molecular dynamics (MD) method is developed to simulate the dynamic behavior and structure transition of finite system under external pressure. In this method, no artificial parameter is introduced and the computation overheads are very small. As an application, a hard-soft transition of single wall carbon nanotube (SWCNT) under external pressure is found, which is in agreement with the experiments.

     

神光Ⅱ上柱形黑腔辐射驱动冲击波

利用神光Ⅱ的八路三倍频激光装置，驱动柱形黑腔产生的x 射线作辐射源驱动台阶铝样品产生冲击波，获得了清晰的冲击波图像，通过冲击波过台阶样 品的时间差获得冲击波速度和压力分别为31.2km/s和17.5×10⁵MPa.采用软x射线能谱 仪通过激光注入孔测量的辐射温度与采用冲击波法测量辐射温度的结果一致. 关键词： 冲击波 辐射驱动 辐射温度     

Hydrogen indium vacancy complex VInH4 in n-type InP studied by positron-lifetime

Positron-lifetime experiments have been carried out on two undoped n-type liquid encapsulated Czochralski (LEC)-grown InP samples with different stoichiometric compositions in the temperature range 10-300 K. For temperatures below 120 K for P-rich InP and 100 K for In-rich InP, the positron average lifetime began to increase rapidly and then leveled off, which was associated with the charge state change of hydrogen indium vacancy complexes from (V_InH₄)⁺ to (V_InH₄)⁰. This phenomenon was more obvious in P-rich samples that have a higher concentration of V_InH₄. The transformation temperature of approximately 120 K suggests that the complex V_InH₄ is a donor defect and that the ionization energy is about 0.01 eV. The ionization of neutral V_InH₄ accounted for the decrease of the positron average lifetime when the sample was illuminated with a photon energy of 1.32 eV at 70 K. These results provide evidence for hydrogen complex defects in undoped LEC InP.     

Evaluation of closed-vessel microwave digestion method for the determination of trace impurities in polymer-based photoresist by inductively coupled plasma mass spectrometry

A closed microwave digestion method followed by inductively coupled plasma spectrometric (ICP-MS) analysis was evaluated for the determination of trace impurities in photoresist. To optimize the digestion procedure, several digestion parameters such as acid, heating temperature and heating time were evaluated. Besides, the digestion efficiency of used photoresist material and the recovery of analyte elements obtained by the use of gravimetric method and ICP-MS measurement, individually, were also compared to clarify the completeness of digestion. According to our experiments, the gravimetric method was found to be not so relevant to the completeness of digestion, because the remaining sample matrix could cause suppression effect in the subsequent ICP-MS measurement. In view of minimizing blank value and working time, a simple single-step heating program was proposed to mineralize 0.25 ml of photoresist material with 5 ml of nitric acid at 180 °C for 10 min. Based on the comparative study of the analytical results obtained by instrumental neutron activation analysis (INAA) and proposed method, the reliability of proposed method for the determination of trace metallic impurities in photoresist material has been confirmed.     

Comparative investigation of up-conversion luminescence in Tm/Yb-codoped germanate-niobic and germanium-bismuth glasses: effect of phonon density on up-conversion emission

Tm³⁺/Yb³⁺-codoped germanate-niobic (GN) and germanium-bismuth (GB) glasses have been synthesized by conventional melting and quenching method. Intense blue and weak red emissions centered at 477 and 650 nm, corresponding to the transitions ¹G₄→³H₆ and ¹G₄→³H₄, respectively, were observed at room temperature. The possible up-conversion mechanisms are discussed and estimated. GN glass showed a weaker up-conversion emission than GB glass, which is inconsistent with the prediction from the difference of maximum phonon energy between GN and GB glasses. In this paper, Raman spectroscopy was employed to investigate the origin of the difference in up-conversion luminescence in the two glasses. Compared with phonon side-band spectroscopy, Raman spectroscopy extracts more information including both phonon energy and phonon density. For the first time, our results reveal that, besides the maximum phonon energy, the phonon density of host glasses is also an important factor in determining the up-conversion efficiency.     

Electrochemical behavior of Li intercalation processes into a Li[NixLi(1/3−2x/3)Mn(2/3−x/3)]O2 cathode

Li[Ni_xLi_(1/3−2x/3)Mn_(2/3−x/3)]O₂ (X=0.17, 0.25, 0.33, 0.5) compounds are prepared by a simple combustion method. The Rietvelt analysis shows that these compounds could be classified as having the α-NaFeO₂ structure. The initial charge-discharge and irreversible capacity increases with the decrease of x in Li[Ni_xLi_(1/3−2x/3)Mn_(2/3−x/3)]O₂. Indeed, Li[Ni_0.50Mn_0.50]O₂ compound shows relatively low initial discharge capacity of 200 mAh/g and large capacity loss during cycling, with Li[Ni_0.17Li_0.22Mn_0.61]O₂ and Li[Ni_0.25Li_0.17Mn₀.₅₈]O₂ compounds exhibit high initial discharge capacity over 245 mAh/g and stable cycle performance in the voltage range of 4.8 -2.0 V. On the other hand, XANES analysis shows that the oxidation state of Ni ion reversibly changes between Ni²⁺ and about Ni³⁺, while the oxidation state of Mn ion sustains Mn⁴⁺ during charge-discharge process. This result does not agree with the previously reported ‘electrochemistry model’ of Li[Ni_xLi_(1/3−2x/3)Mn_(2/3−x/3)]O₂, in which Ni ion changes between Ni²⁺ and NI⁴⁺. Based on these results, we modified oxidation-state change of Mn and Ni ion during charge-discharge process.     

Synthesis and characterization of white‐light‐emitting polyfluorenes containing orange phosphorescent moieties in the side chain

Two orange phosphorescent iridium complex monomers, 9‐hexyl‐9‐(iridium (III)bis(2‐(4′‐fluorophenyl)‐4‐phenylquinoline‐N,C^2′)(tetradecanedionate‐11,13))‐2,7‐dibromofluorene (Br‐PIr) and 9‐hexyl‐9‐(iridium(III)bis(2‐(4′‐fluorophenyl)‐4‐methylquinoline‐N,C^2′)(tetradecanedionate‐11,13))‐2,7‐dibromofluorene (Br‐MIr), were successfully synthesized. The Suzuki polycondensation of 2,7‐bis(trimethylene boronate)‐9,9‐dioctylfluorene with 2,7‐dibromo‐9,9‐dioctylfluorene and Br‐PIr or Br‐MIr afforded two series of copolymers, PIrPFs and MIrPFs, in good yields, in which the concentrations of the phosphorescent moieties were kept small (0.5–3 mol % feed ratio) to realize incomplete energy transfer. The photoluminescence (PL) of the copolymers showed blue‐ and orange‐emission peaks. A white‐light‐emitting diode with a configuration of indium tin oxide/poly(3,4‐ethylenedioxythiophene):poly(styrenesulfonate)/PIr05PF (0.5 mol % feed ratio of Br‐PIr)/Ca/Al exhibited a luminous efficiency of 4.49 cd/A and a power efficiency of 2.35 lm/W at 6.0 V with Commission Internationale de L'Eclairage (CIE) coordinates of (0.46, 0.33). The CIE coordinates were improved to (0.34, 0.33) when copolymer MIr10PF (1.0 mol % feed ratio of Br‐MIr) was employed as the white‐emissive layer. The strong orange emission in the electroluminescence spectra in comparison with PL for these kinds of polymers was attributed to the additional contribution of charge trapping in the phosphorescent dopants. © 2007 Wiley Periodicals, Inc. JPolym Sci Part A: Polym Chem 45: 1746–1757, 2007     

Molecular dynamics simulation of P-V-T relationship of ZnO with rock-salt structure using pair-wise interactions

Molecular dynamics (MD) method is used to investigate the behavior of the pressure-volume-temperature (P-V-T) relationship, lattice constant and thermal expansivity for ZnO with rock-salt structure at high pressures and temperatures. The interionic potential is taken to be the sum of pair-wise additive Coulomb, van der Waals attraction, and repulsive interactions. The isothermal and isobaric properties are discussed from the corresponding P-V-T relationship, and it is shown that the MD simulation is successful in reproducing the measured volumes of ZnO over a wide range of temperature and pressure. Meanwhile, the equations of state parameters including lattice constant, linear thermal expansion coefficient, and isothermal bulk modulus are calculated and compared with the available experimental data and the latest theoretical results. At an extended pressure and temperature range, P-V-T relationship, lattice constant, and linear thermal expansion coefficient have been predicted. The structural and thermodynamic properties of ZnO with rock-salt structure are summarized in the pressure 0-100 GPa ranges and the temperature up to 3100 K.     

Discovery of a new long-lived isomeric state in 125Ce

A new long-lived isomeric state in the near proton dripline nucleus ¹²⁵Ce has been identified with Schottky mass spectrometry at GSI. The excitation energy E ^* = 103(12)keV and the decay time of 193(1)s have been obtained from a single stored fully ionized ^125m Ce⁵⁸⁺ ion. The data implies an E3 transition and a 1/2⁺ assignment for the spin of the isomer.     

聚能射流的断裂时间

从描述聚能射流失稳的一维近似方程出发，导出了聚能射流断裂时间的近似公式。这个近似公式定量显示了屈服应力、本构关系、粘度和径向收缩效应等对射流断裂时间的影响，在４个不同的特殊近似下，可以自然演化为近１０年来所发表的几个半经验解析公式，并且在合理的参数范围内，公式给出的断裂时间曲线覆盖了射流断裂时间的全部实验点。