Time Resolved Microwave Interferometry Measurement of the Electron Density in a Pulsed 1,3-Butadiene Discharge

Pulsed plasmas containing organic precursors are becoming increasingly common for multiple applications. To understand the nature of such discharges, in-situ time resolved microwave interferometry measurements of the electron density in a 60 W pulsed inductively coupled 1,3-butadiene discharge have been made. Measurements were also made for continuous wave plasmas at 40, 50, 60 and 70 W power for comparison. The data shows that the time averaged electron densities are independent of pulse width at a particular duty cycle. In addition, time averaged values increase approximately linearly with increasing duty cycle. Such linearity in average density is tied to the ambipolar loss rate. This knowledge is important for understanding the growth kinetics of plasma polymerized films.     

Chlorella minutissima—A Promising Fuel Alga for Cultivation in Municipal Wastewaters

It is imperative to slash the cost of algal oil to less than $50 bbl^?1 for successful algal biofuel production. Use of municipal wastewater for algal cultivation could obviate the need for freshwater and the nutrients—N and P. It would also add CO₂ through bacterial activity. Chlorella minutissima Fott et Nova dominated the entire phycoflora year around and through each stage of the wastewater treatment at the oxidation pond system of Wazirabad (Delhi) in India. The ability to grow so profusely in such varied and contrasting situations made this alga unique. Besides pollution tolerance, it grew heterotrophically in dark under acidic conditions and as a mixotroph in presence of light over a range of organic C substrates. It could utilize both ammoniacal and nitrate nitrogen, survived anaerobicity, 5% NaCl and ?10 bar of osmotic stress. C. minutissima grew at pH 4–11 and raised the pH set initially by 1 to 3 units in 7.5 h. It showed gigantism and largely kept afloat in presence of utilizable organic carbon, while flocculated in mineral medium and on aging. The alga also possessed potential for biofuel production. The studied parameters indicate why C. minutissima was a potential biomass builder in municipal sewage and could be used to determine which other alga(e) may serve the purpose.     

Thermoluminescence characteristics of inorganically and organically capped ZnS:Cu nanophosphors

ZnS:Cu nanophosphors were prepared by wet chemical methods and characterized by X-ray diffraction (XRD). The typical morphologies of the nanophosphors were investigated by scanning electron microscopy (SEM). The thermoluminescence (TL) properties of inorganically and organically passivated ZnS:Cu nanophosphors were investigated after γ-irradiation using a ⁶⁰Co source at room temperature. The TL glow curve of capped ZnS:Cu showed variation in TL peak and intensity as the capping agent was changed. Amongst the synthesized samples the TL glow curve of SiO₂ capped ZnS:Cu showed the highest TL intensity. It has been found that TL response of SiO₂ capped ZnS:Cu is linear in the range 10-550 Gy. A discussion of the obtained results is also presented.     

Ultrasonic degradation of polymers: effect of operating parameters and intensification using additives for carboxymethyl cellulose (CMC) and polyvinyl alcohol (PVA)

Use of ultrasound can yield polymer degradation as reflected by a significant reduction in the intrinsic viscosity or the molecular weight. The ultrasonic degradation of two water soluble polymers viz. carboxymethyl cellulose (CMC) and polyvinyl alcohol (PVA) has been studied in the present work. The effect of different operating parameters such as time of irradiation, immersion depth of horn and solution concentration has been investigated initially using laboratory scale operation followed by intensification studies using different additives such as air, sodium chloride and surfactant. Effect of scale of operation has been investigated with experiments in the available different capacity reactors with an objective of recommending a suitable type of configuration for large scale operation. The experimental results show that the viscosity of polymer solution decreased with an increase in the ultrasonic irradiation time and approached a limiting value. Use of additives such as air, sodium chloride and surfactant helps in increasing the extent of viscosity reduction. At higher frequency operation the viscosity reduction has been found to be negligible possibly attributed to less contribution of the physical effects. The viscosity reduction in the case of ultrasonic horn has been observed to be more as compared to other large capacity reactors. Kinetic analysis of the polymer degradation process has also been performed. The present work has enabled us to understand the role of the different operating parameters in deciding the extent of viscosity reduction in polymer systems and also the controlling effects of low frequency high power ultrasound with experiments on different scales of operation.     

Non-neural BOLD variability in block and event-related paradigms

Block and event-related stimulus designs are typically used in fMRI studies depending on the importance of detection power or estimation efficiency. The extent of vascular contribution to variability in block and event-related fMRI-BOLD response is not known. With scaling, the extent of vascular variability in the fMRI-BOLD response during block and event-related design tasks was investigated. Blood oxygen level-dependent (BOLD) contrast data from healthy volunteers performing a block design motor task and an event-related memory task requiring performance of a motor response were analyzed from the regions of interest (ROIs) surrounding the primary and supplementary motor cortices. Average BOLD signal change was significantly larger during the block design compared to the event-related design. In each subject, BOLD signal change across voxels in the ROIs had higher variation during the block design task compared to the event-related design task. Scaling using the resting state fluctuation of amplitude (RSFA) and breath-hold (BH), which minimizes BOLD variation due to vascular origins, reduced the within-subject BOLD variability in every subject during both tasks but significantly reduced BOLD variability across subjects only during the block design task. The strong non-neural source of intra- and intersubject variability of BOLD response during the block design compared to event-related task indicates that study designs optimizing for statistical power through enhancement of the BOLD contrast (for, e.g., block design) can be affected by enhancement of non-neural sources of BOLD variability.     

Absence of morphotropic phase boundary effects in BiFeO<Subscript>3</Subscript>–PbTiO<Subscript>3</Subscript> thin films grown via a chemical multilayer deposition method

We report an unusual behavior observed in (BiFeO₃)_1−x –(PbTiO₃) _x (BF–xPT) thin films prepared using a multilayer chemical solution deposition method. Films of different compositions were grown by depositing several bilayers of BF and PT precursors of varying BF and PT layer thicknesses followed by heat treatment in air. X-ray diffraction showed that samples of all compositions show mixing of two compounds resulting in a single-phase mixture, also confirmed by transmission electron microscopy. In contrast to bulk compositions, samples show a monoclinic (M_A-type) structure suggesting disappearance of the morphotropic phase boundary (MPB) at x=0.30 as observed in the bulk. This is accompanied by the lack of any enhancement of the remanent polarization at the MPB, as shown by the ferroelectric measurements. Magnetic measurements showed an increase in the magnetization of the samples with increasing BF content. Significant magnetization in the samples indicates melting of spin spirals in the BF–xPT films, arising from a random distribution of iron atoms. Absence of Fe²⁺ ions was corroborated by X-ray photoelectron spectroscopy measurements. The results illustrate that thin film processing methodology significantly changes the structural evolution, in contrast to predictions from the equilibrium phase diagram, besides modifying the functional characteristics of the BP-xPT system dramatically.     

Second order symmetric duality in nondifferentiable multiobjective fractional programming with cone convex functions

In the present paper, we consider Mond-Weir type nondifferentiable second order fractional symmetric dual programs over arbitrary cones and derive duality results under second order K?F-convexity/K?F-pseudoconvexity assumptions. Our results generalize several known results in the literature.     

Dehydration of 1,4-dioxane through blend membranes of poly(vinyl alcohol) and chitosan by pervaporation

Blend membranes prepared from poly(vinyl alcohol) (PVA) and chitosan (CS) were crosslinked with glutaraldehyde and used in the pervaporation dehydration of 1,4-dioxane. Membranes were characterized by Fourier transform infrared spectroscopy (FTIR), thermogravimetric analysis (TGA), differential scanning calorimetry (DSC) and X-ray diffraction (X-RD) to assess, respectively, the intermolecular interactions, thermal stability and crystallinity. Equilibrium sorption studies were carried out in pure liquids and binary mixtures of different compositions of water + 1,4-dioxane mixtures to assess the polymer–liquid interactions. The crosslinked membrane showed a good potential in breaking the azeotrope of 82 wt.% aqueous 1,4-dioxane giving a selectivity of 117 with a reasonable water flux of 0.37 kg/m² h. The effect of operating parameters such as feed composition, membrane thickness and permeate pressure was evaluated.