Simulation of Organic Liquid Product Deoxygenation through Multistage Countercurrent Absorber/Stripping Using CO2 as Solvent with Aspen-HYSYS: Process Modeling and Simulation

In this work, the deoxygenation of organic liquid products (OLP) obtained through the thermal catalytic cracking of palm oil at 450 °C, 1.0 atmosphere, with 10% (wt.) Na₂CO₃ as a catalyst, in multistage countercurrent absorber columns using supercritical carbon dioxide (SC-CO₂) as a solvent, with an Aspen-HYSYS process simulator, was systematically investigated. In a previous study, the thermodynamic data basis and EOS modeling necessary to simulate the deoxygenation of OLP was presented. This work addresses a new flowsheet, consisting of 03 absorber columns, 10 expansions valves, 10 flash drums, 08 heat exchanges, 01 pressure pump, and 02 make-ups of CO₂, aiming to improve the deacidification of OLP. The simulation was performed at 333 K, 140 bar, and (S/F) = 17; 350 K, 140 bar, and (S/F) = 38; 333 K, 140 bar, and (S/F) = 25. The simulation shows that 81.49% of OLP could be recovered and that the concentrations of hydrocarbons in the extracts of absorber-01 and absorber-02 were 96.95 and 92.78% (wt.) on a solvent-free basis, while the bottom stream of absorber-03 was enriched in oxygenated compounds with concentrations of up to 32.66% (wt.) on a solvent-free basis, showing that the organic liquid products (OLP) were deacidified and SC-CO₂ was able to deacidify the OLP and obtain fractions with lower olefin contents. The best deacidifying condition was obtained at 333 K, 140 bar, and (S/F) = 17.     

Seasonal Variability of a Caryophyllane Chemotype Essential Oil of Eugenia patrisii Vahl Occurring in the Brazilian Amazon

Eugenia patrisii Vahl is a native and non-endemic myrtaceous species of the Brazilian Amazon. Due to few botanical and phytochemical reports of this species, the objective of the present work was to evaluate the seasonal variability of their leaf essential oils, performed by GC and GC-MS and chemometric analysis. The results indicated that the variation in oil yields (0.7 ± 0.1%) could be correlated with climatic conditions and rainy (R) and dry seasons (D). (E)-caryophyllene (R = 17.1% ± 16.0, D = 20.2% ± 17.7) and caryophyllene oxide (R = 30.1% ± 18.4, D = 14.1% ± 19.3) are the major constituents and did not display significant differences between the two seasons. However, statistically, a potential correlation between the main constituents of E. patrisii essential oil and the climatic parameters is possible. It was observed that the higher temperature and insolation rates and the lower humidity rate, which are characteristics of the dry season, lead to an increase in the (E)-caryophyllene contents, while lower temperature and insolation and higher humidity, which occur in the rainy season, lead to an increase in the caryophyllene oxide content. The knowledge of variations in the E. patrisii essential oil composition could help choose the best plant chemical profile for medicinal purposes.     

Current status of biodiesel development in Brazil

In recent years, the concept of producing biodiesel from renewable lipid sources has regained international attention. In Brazil, a national program was launched in 2002 to evaluate the technical, economic, and environmental competitiveness of biodiesel in relation to the commercially available diesel oil. Several research projects were initiated nationwide to investigate and/or optimize biodiesel production from renewable lipid sources and ethanol derived from sugarcane (ethyl esters). Once implemented, this program will not only decrease our dependence on petroleum derivatives but also create new market opportunities for agribusiness, opening new jobs in the countryside, improving the sustainability of our energy matrix, and helping the Brazilian government to support important actions against poverty. This article discusses the efforts to develop the Brazilian biodiesel program in the context of technical specifications as well as potential oilseed sources.     

Stereoisomeric Tris-BINOL-Menthol Bulky Monophosphites: Synthesis,Characterisation and Application in Rhodium-Catalysed Hydroformylation

Four stereoisomeric monoether derivatives, based on axially chiral (R)- or (S)-BINOL bearing a chiral (+)- or (−)-neomenthyloxy group were synthesised and fully characterised by NMR spectroscopy and X-ray crystallography. The respective tris-monophosphites were thereof prepared and fully characterised. The coordination ability of the new bulky phosphites with Rh(CO)₂(acac), was attested by ³¹P NMR, which presented a doublet in the range of δ = 120 ppm, with a ¹J(¹⁰³Rh-³¹P) coupling constant of 290 Hz. The new tris-binaphthyl phosphite ligands were further characterised by DFT computational methods, which allowed us to calculate an electronic (CEP) parameter of 2083.2 cm⁻¹ and an extremely large cone angle of 345°, decreasing to 265° upon coordination with a metal atom. Furthermore, the monophosphites were applied as ligands in rhodium-catalysed hydroformylation of styrene, leading to complete conversions in 4 h, 100% chemoselectivity for aldehydes and up to 98% iso-regioselectivity. The Rh(I)/phosphite catalytic system was also highly active and selective in the hydroformylation of disubstituted olefins, including (E)-prop-1-en-1-ylbenzene and prop-1-en-2-ylbenzene.     

The production and destruction of the C-related 969 meV absorption band in Si

Data are reported on the production of the 969 meV absorption line as functions of the carbon concentration and radiation dose in FZ and CZ silicon. With increasing dose of 2 MeV electrons the absorption first increases and then decreases. Simple equations are presented which describe the growth and decay. It is shown that, in favourable circumtances, carbon concentrations as low as 10¹⁴ cm⁻³ can be detected in silicon by means of the 969 meV absorption line. We verify that the 969 meV line anneals out at temperatures >500 K but may increase between 450 and 500 K. We show that the increase is largest in samples irradiated at room temperature to a small dose relative to the carbon concentration.     

Grid structure impact in sparse point representation of derivatives

In the Sparse Point Representation (SPR) method the principle is to retain the function data indicated by significant interpolatory wavelet coefficients, which are defined as interpolation errors by means of an interpolating subdivision scheme. Typically, a SPR grid is coarse in smooth regions, and refined close to irregularities. Furthermore, the computation of partial derivatives of a function from the information of its SPR content is performed in two steps. The first one is a refinement procedure to extend the SPR by the inclusion of new interpolated point values in a security zone. Then, for points in the refined grid, such derivatives are approximated by uniform finite differences, using a step size proportional to each point local scale. If required neighboring stencils are not present in the grid, the corresponding missing point values are approximated from coarser scales using the interpolating subdivision scheme. Using the cubic interpolation subdivision scheme, we demonstrate that such adaptive finite differences can be formulated in terms of a collocation scheme based on the wavelet expansion associated to the SPR. For this purpose, we prove some results concerning the local behavior of such wavelet reconstruction operators, which stand for SPR grids having appropriate structures. This statement implies that the adaptive finite difference scheme and the one using the step size of the finest level produce the same result at SPR grid points. Consequently, in addition to the refinement strategy, our analysis indicates that some care must be taken concerning the grid structure, in order to keep the truncation error under a certain accuracy limit. Illustrating results are presented for 2D Maxwell’s equation numerical solutions.     

Comparative bioavailability of two zolpidem hemitartrate formulations in healthy human Brazilian volunteers using high-performance liquid chromatography coupled to tandem mass spectrometry

To assess the bioequivalence of two zolpidem hemitartrate formulations in 30 healthy volunteers. Plasma samples were obtained over a 24 h period. Plasma concentrations of zolpidem were analyzed by liquid chromatography coupled to tandem mass spectrometry with positive ion electrospray ionization using multiple reaction monitoring. Values of peak concentration (C_max), area under curve (AUC), half-life, elimination constant, volume of distribution and clearance showed statistically significant differences when comparing women (604.34 ng h/ml, 127.36 ng/ml, 4.4 h, 0.18 1/h, 50.56 L and 8.55 L/h, respectively) and men (276.1 ng h/ml, 70.9 ng/ml, 3.3 h, 0.26 1/h, 91.42 L and 24.34 L/h, respectively), receiving the same dose (5 mg), respectively. The geometric means with corresponding 90% confidence interval for Test/Reference percentage ratios were 99.73% (CI 93.69–106.16) for C_max, 97.44% (90% CI = 91.85–103.37%) for area under curve of plasma concentration until the last concentration observed (AUC_last) and 98.30% (90% CI = 92.48–104.49) for the area under curve between the first sample (pre-dosage) and infinity (AUC_0–inf). Since the 90% CI for AUC_last, AUC_0–inf and C_max ratios were within the 80–125% interval proposed by the US Food and Drug Administration, it was concluded that zolpidem hemitartrate formulation (5 mg orodispersible tablet) is bioequivalent to the zolpidem hemitartrate formulation (Patz SL 5 mg sublingual tablet) with regard to both the rate and the extent of absorption. A new formulation of zolpidem 2.5 mg may be useful in women for the same clinical benefits as the 5 mg formulation in men.