Structures and stabilities of 3d-transition metal-benzene organometallic clusters

In the gas phase, we have successfully synthesized organometallic clusters, M_n(benzene)_m (M=3d transition metal atoms), by using a laser vaporization method. The measurements of mass spectra and ionization energies (E_i) have revealed that the organometallic clusters can take two types of structures; layered sandwich structures (m = n + 1) and metal clusters saturatedly covered with benzenes. For early transition metals of Sc, Ti, and V, only the multiple decker sandwich structure clusters were preferentially produced, in which benzene and metal atoms are alternately piled up. For late transition metals of Co and Ni, the metal clusters saturatedly surrounded by benzenes were also produced as well as the sandwich clusters. Furthermore, the E_is of M₁(benzene)₂ (M = Sc-Ni) were systematically measured and their electronic properties will be discussed.     

Diffusion-controlled reaction. V. Effect of concentration-dependent diffusion coefficient on reaction rate in graft polymerization

The effect of diffusion on radiation-initiated graft polymerization has been studied with emphasis on the single- and two-penetrant cases. When the physical properties of the penetrants are similar, the two-penetrant problem can be reduced to the single-penetrant problem by redefining the characteristic parameters of the system. The diffusion-free graft polymerization rate is assumed to be proportional to the v power of the monomer concentration C, in which the proportionality constant a = k_pR/k, where k_p and k_t are the propagation and termination rate constants, respectively, and R_i is the initiation rate. The values of v, w, and z depend on the particular reaction system. The results of our earlier work were generalized by allowing a non-Fickian diffusion rate, obtained from an extension of the Fujita free-volume theory, which predicts an essentially exponential dependence on the monomer concentration of the diffusion coefficient, D = D₀ [exp(δC/M)], where M is the saturation concentration. It was shown that a reaction system is characterized by the three dimensionless parameters v, δ, and A = (L/2)[aM^(v?1)/D₀]^1/2, where L is the polymer film thickness. Graft polymerization tends to become diffusion controlled as A increases. Larger values of δ and v cause a reaction system to behave closer to the diffusion-free regime. The transition from diffusion-free to diffusion-controlled reaction involves changes in the dependence of the reaction rate on film thickness, initiation rate, and monomer concentration. Although the diffusion-free rate is w order in initiation rate, v order in monomer, and independent of film thickness, the diffusion-controlled rate is w/2 order in initiator rate and inverse first-order in film thickness. The dependence of the diffusion-controlled rate on monomer is dependent in a complex manner on the diffusional characteristics of the reaction system.     

Anomalous NMR behavior of meso compounds with remote stereogenic centers on addition of chiral shift reagent or chiral solvating agent

A problem has arisen in using chiral shift reagents (CSR) and chiral solvating agents (CSA) to determine meso and racemic forms of diastereoisomers in which the stereogenic centers of the molecules are separated by achiral spacers. It is found that NMR signals of both meso and racemic forms of diastereoisomers may exhibit doubling on addition of CSR/CSA, which means that unequivocal assignments cannot be made without characterizing the effects for separate meso and racemic forms; this is particularly important for additions of CSR/CSA at relatively low concentrations, which always result in the splitting of some NMR signals of diastereoisomers. The phenomenon is demonstrated in the (31)P NMR spectra of meso and racemic forms of three spermine-bridged gem-disubstituted cyclotriphosphazatrienes, 1a-c, and compared with analogous achiral molecules, the per-substituted spermine-bridged cyclotriphosphazatrienes 2a-d. As expected, only one set of (31)P NMR signals was observed for the achiral compounds 2a-d, even on addition of CSA. Two sets of (31)P NMR ABX multiplets corresponding to meso and racemic diastereoisomers were observed for compounds 1a-c; on addition of CSA, the signals of at least one of the multiplets for each compound separated into more than the expected groups of three lines with an intensity distribution of 2:1:1. To understand this phenomenon, the meso and racemic forms of 1a and 1b and the meso form of 1c have been separated and characterized by X-ray crystallography. On addition of CSA to the racemic forms of 1a and 1b, the (31)P NMR spectrum shows the expected doubling of signals, but, unexpectedly, the same is observed for each of the meso forms of 1a-c. Analogous results using both CSA and CSR have been obtained for the meso and racemic forms of the diastereoisomeric piperazine-bridged macrocyclic-phosphazene compound, 3, whereas no effect was observed for the two meso forms of the doubly bridged macrocyclic-phosphazene compound 4. The phenomenon of doubling of the (31)P NMR signals of the meso form of singly bridged cyclotriphosphazatrienes, 1a-c and 3, is explained by consideration of the equilibrium in solution of independent complexation of a chiral ligand with molecules that have two chiral cyclophosphazene moieties separated by an achiral spacer group. The results show that the stereogenicity of such diastereoisomeric molecules in solution cannot be characterized unequivocally by NMR measurements on addition of either CSR or CSA.     

Synthesis and Characterization of Mononuclear Cobalt(II), Nickel(II), Copper(II), Zinc(II), Cadmium(II) and Dinuclear Uranyl(VI) Complexes with N,N-bis(2-{[(2,2-dimethyl-1,3-dioxolan-4-yl)methyl]amino}butyl) N′,N′-dihydroxyethanediimidamide

In this study, the new vic-dioxime ligand (LH₂) and its complexes with Co^II, Ni^II, Cu^II, Zn^II, Cd^II and UO₂^VI are described. The structures of these complexes were characterized by elemental analyses, i.r., ¹H- and ¹³C-n.m.r. spectra, u.v.–vis. spectroscopy, magnetic susceptibility measurements, conductivity measurements and thermogravimetric analyses (t.g.a.).     

Frequency and voltage-dependent electrical and dielectric properties of Al/Co-doped PVA/p-Si structures at room temperature

In order to investigate of cobalt-doped interracial polyvinyl alcohol （PVA） layer and interface trap （Dit） effects, A1/p- Si Schottky barrier diodes （SBDs） are fabricated, and their electrical and dielectric properties are investigated at room temperature. The forward and reverse admittance measurements are carded out in the frequency and voltage ranges of 30 kHz-300 kHz and -5 V-6 V, respectively. C-V or er-V plots exhibit two distinct peaks corresponding to inversion and accumulation regions. The first peak is attributed to the existence of Dit, the other to the series resistance （Rs）, and interfacial layer. Both the real and imaginary parts of dielectric constant （er and err） and electric modulus （Mr and Mrr）, loss tangent （tan~）, and AC electrical conductivity （aac） are investigated, each as a function of frequency and applied bias voltage. Each of the M~ versus V and Mrr versus V plots shows a peak and the magnitude of peak increases with the increasing of frequency. Especially due to the Dit and interfacial PVA layer, both capacitance （C） and conductance （G/w） values are strongly affected, which consequently contributes to deviation from both the electrical and dielectric properties of A1/Co-doped PVA/p-Si （MPS） type SBD. In addition, the voltage-dependent profile of Dit is obtained from the low-high frequency capacitance （CLF-CHF） method.     

Poly(2-(dimethylamino)ethyl methacrylate) brushes fabricated by surface-mediated RAFT polymerization and their response to pH

In this study, well-defined, high density poly(2-(dimethylamino)ethyl methacrylate) [poly(DMAEMA)] brushes were fabricated by the combination of the self-assembly of a monolayer of RAFT agent and surface-mediated RAFT polymerization. The whole fabrication process of the poly(DMAEMA) was followed by water contact angles, grazing angle-Fourier transform infrared spectroscopy, X-ray photoelectron spectroscopy, and atomic force microscopy. Kinetic studies revealed a linear increase in poly(DMAEMA) film thickness with polymerization time, indicating that the chain growth from the surface was a controlled process. Characterization of the poly(DMAEMA) brushes, such as molecular weight and thickness determination, were measured by gel permeation chromatography, and ellipsometry, and the grafting density was estimated. The pH response of the poly(DMAEMA) brushes was further investigated and the results verified the “brush-like” to “mushroom-like” transition of the poly(DMAEMA) chains due to the reversible protonation/deprotonation upon changing the solution pH.     

Three-Phase Partitioning as a Rapid and Easy Method for the Purification and Recovery of Catalase from Sweet Potato Tubers (Solanum tuberosum)

Three-phase partitioning (TPP) was used to purify and recover catalase from potato crude extract. The method consists of ammonium sulfate saturation, t-butanol addition, and adjustment of pH, respectively. The best catalase recovery (262 %) and 14.1-fold purification were seen in the interfacial phase in the presence of 40 % (w/v) ammonium sulfate saturation with 1.0:1.0 crude extract/t-butanol ratio (v/v) at pH 7 in a single step. The sodium dodecyl sulfate–polyacrylamide gel electrophoresis (SDS-PAGE) analysis of the enzyme showed comparatively purification and protein molecular weight was nearly found to be 56 kDa. This study shows that TPP is a simple, economical, and quick method for the recovering of catalase and can be used for the purification process.     

Ffast Transient Fluorescence Technique to Study Critical Exponents at the Glass Transition

The fast transient fluorescence (FTRF) technique was used to study critical exponents at the glass transition in free-radical crosslinking copolymerization (FCC) for two different monomeric systems, methyl methacrylate (MMA) and styrene (S). Pyrene (P_y ) was used as a fluorescence probe. The fluorescence lifetimes of P_y from its decay traces were measured and used to monitor the gelation process. Changes in the viscosity of the pregel solutions due to glass formation dramatically enhance the fluorescent yield of aromatic molecules. This effect is used to study the glass transition upon gelation of MMA and S monomeric systems as a function of time, at various temperatures and crosslinker concentrations. The results are interpreted in the view of percolation theory. The gel fraction and weight average degree of polymerization exponents β and γ are found to be 0.37 ± 0.02 and 1.66 ± 0.07 in agreement with percolation results.     

Inventory control and pricing for perishable products under age and price dependent stochastic demand

Multistage stochastic programming (SP) with both endogenous and exogenous uncertainties is a novel problem in which some uncertain parameters are decision-dependent and others are independent of decisions. The main difficulty of this problem is that nonanticipativity constraints (NACs) make up a significantly large constraint set, growing very fast with the number of scenarios and leading to an intractable model. Usually, a lot of these constraints are redundant and hence, identification and elimination of redundant NACs can cause a significant reduction in the problem size. Recently, a polynomial time algorithm has been proposed in the literature which is able to identify all redundant NACs in an SP problem with only endogenous uncertainty. In this paper, however, we extend the algorithm proposed in the literature and present a new method which is able to make the upper most possible reduction in the number of NACs in any SP with both exogenous and endogenous uncertain parameters. Proving the validity of this method is another innovation of this study. Computational results confirm that the proposed approach can significantly reduce the problem size within a reasonable computation time.