Polymerization of pyromellitic dianhydride with 3,3′-diaminobenzidine in aprotic solvents I. Reaction variables

The solution polymerization of pyromellitic dianhydride with 3,3′-diaminobenzidine to form poly(amide acid amine) was investigated under a variety of reaction conditions. Polymer viscosity and gel formation were highly affected by changes in the order of monomer addition, the type of process (powder or solution), monomer concentration, monomer stoichiometry, and type of solvent. Minor effects were noted with changes in polymerization temperature and the presence of small amounts of water. A limiting intrinsic viscosity of 1.2–1.5 dl/g was observed, regardless of polymerization conditions. The polymerization had a strong tendency to gel at high concentrations and when monomer molar ratios approached 1:1. The conditions which retarded or promoted the formation of macrogel were well-defined, and macrogel but not microgel could be prevented. The polymerization was conducted successfully only in aprotic solvents. No imidazopyrrol-one units were detected in polymer made in polyphosphoric acid at elevated temperatures.     

Thermal degradation of bromine-containing polymers. Part 2—Characteristics and products of degradation of copolymers of 2-bromoethyl methacrylate and methyl acrylate

Reactivity ratios for the system 2-bromoethyl methacrylate (M₁)/methyl acrylate (M₂) have been obtained as follows using a nuclear magnetic resonance spectroscopic technique: r₁ = 2·77 ± 0·03, r₂ = 0·19 ± 0·02. The principal characteristics of the thermal degradation of this copolymer system have been established by the application of Thermal Gravimetry, Differential Scanning Calorimetry, Thermal Volatilisation Analysis and Sub-ambient Thermal Volatilisation Analysis, the products being identified principally by infra-red and NMR spectroscopic analysis. A quantitative analysis of the products of degradation is presented.     

Chiral discrimination within disordered adlayers on metal surfaces

Using a novel non-linear optical technique enantiomeric excess within a translationally disordered overlayer on a metal surface has been monitored for the first time.     

Magnetic penetration depth in V3Si and LiTi2O4 measured by μSR

Muon spin relaxation (SR) studies have been performed in the normal spinel LiTi₂O₄ and the A-15 superconductor V₃Si to measure the magnetic penetration depth . The relaxation rate(T) 1/² in field-cooled measurements shows a sharp increase belowT _c followed by saturation at low temperatures in both systems. This feature implies an isotropic energy gap without anomalous zeros, and most likelys-wave pairing. The low temperature penetration depth (T 0) is determined to be 2100Å for LiTi₂O₄ and 1300Å for V₃Si respectively. Assuming a clean limit relation ^–2 n _s /m ^*, we derive the Fermi temperatureT _F n _s/ ^2/3 m ^* from the relaxation rate and the Sommerfeld constant asT _F ^3/4–1/4. Unlike conventional superconductors, both LiTi₂O₄ and V₃Si have a large ratio ofT _c /T _F 0.01, only slightly smaller than those ratios in more exotic superconductors.We thank C. Ballard and K. Hoyle for technical assistance. Work at Columbia University is supported by NSF Grant No. DMR-89-13784 and Packard Foundation (YJU). Ames Laboratory is operated for the U. S. Department of Energy by Iowa State University under Contract No. W-7405-Eng-82. Work at Ames was supported by the Director for Energy Research, Office of Basic Energy Sciences.