LSmn系列表面化学性质与胶束化作用

通过表面张力的测定, 研究了十二烷基聚氧乙烯聚氧丙烯醚(LSmn)系列表面活性剂LS36、LS45、LS54在溶液表面吸附和形成胶束的热力学函数随温度的变化. 给出了它们在水溶液中的二组分相图.结果表明, LS36、LS45、LS54的表面活性都较高. 在25～50 ℃范围内, 临界胶束浓度(cmc)和平衡表面张力分别在4.44×10－6～17.3×10－6 mol•L－1和30.1～33.5 mN•m－1之间, 表面吸附和形成胶束的自由能分别在－40.0～－49.5 kJ•mol－1和－27.2～－33.1 kJ•mol－1之间.不论是在溶液表面吸附还是形成胶束均为熵驱动过程.其中LS36由于含具有亲水能力较强的聚氧乙烯基团(EO)成分较低, 因此不论其浊点还是其表面吸附和形成胶束的热力学函数均与LS45、LS54具有较大差异.     

受迫振动演示实验装置

本文叙述用示波器显示来演示受迫振动的实验装置，可直观地向学生展示受迫振动的幅频特性和相频特性。     

单壁碳纳米管自还原法制备负载Pt催化剂及其催化性能

金属Pt是良好的催化加氢、脱氢催化剂, 利用单壁碳纳米管(SWNTs)自身的还原性, 将K2PtCl6溶液中的Pt直接还原并负载在SWNTs表面上, 制备了具有良好催化性能的SWNTs/Pt负载型催化剂. 通过TEM, XPS和TG对材料进行了表征, 研究了K2PtCl6浓度及溶剂对Pt负载量、粒径的影响, 并测试了SWNTs/Pt的催化性能. 实验结果表明, SWNTs负载的Pt颗粒小, 分散均匀, 负载量高, 与SWNTs结合紧密, 催化性能好, 是催化加氢和脱氢反应的良好催化剂.     

演示实验在大学物理教学中的积极作用

本文结合教学工作实际指出演示实验在大学物理教学中的积极作用，并强调在“大学物理讨论课”中引入尝示实验的必要性。     

Real-time three-dimensional infrared imaging using fringe projection profilometry

Infrared thermography determines the surface temperature of an object or human body. It is a promising imaging technology for medical and biological observations due to its contactless and completely non- invasive properties. However, traditional two-dimensional （2D） infrared thermography cannot retain the spatial information, and thus provides only qualitative diagnosis information. A novel real-time three- dimensional （3D） infrared imaging system which takes full advantages of high-speed, high-quality, high- sensitivity, and low-cost in 3D thermograph is presented. We demonstrate the real-time 3D thermal imaging at the speed of 24 frmnes per second （fps）, with resolution of 640 ×480 points. Experimental results demonstrate quantitatively measurement of temperature distribution of 3D surfaces in real-time is realized with this system.     

Effect of oxygen on regulation of properties of moderately boron-doped diamond films

Regulation of oxygen on properties of moderately boron-doped diamond films is fully investigated. Results show that, with adding a small amount of oxygen (oxygen-to-carbon ratio < 5.0%), the crystal quality of diamond is improved, and a suppression effect of residual nitrogen is observed. With increasing ratio of O/C from 2.5% to 20.0%, the hole concentration is firstly increased then reduced. This change of hole concentration is also explained. Moreover, the results of Hall effect measurement with temperatures from 300 K to 825 K show that, with adding a small amount of oxygen, boron and oxygen complex structures (especially B₃O and B₄O) are formed and exhibit as shallow donor in diamond, which results in increase of donor concentration. With further increase of ratio of O/C, the inhibitory behaviors of oxygen on boron leads to decrease of acceptor concentration (the optical emission spectroscopy has shown that it is decreased with ratio of O/C more than 10.0%). This work demonstrates that oxygen-doping induced increasement of the crystalline and surface quality could be restored by the co-doping with oxygen. The technique could achieve boron-doped diamond films with both high quality and acceptable hole concentration, which is applicable to electronic level of usage.     

中环萜类化合物的合成

本文综述了中环萜类化合物的各种合成方法,它们根据成环方式可以分为四类:1.双环或三环化合物的桥键断裂,2.无环化合物的环合,3.常规环化合物的环扩大,4.大环化合物的环缩小。     

Quantum circuits for realizing deterministic and exact teleportation via two partially entangled pairs of particles

Deterministic and exact teleportation can be achieved via two partially entangled pairs of particles [Gu Y J 2006 {\em Opt. Comm.} {\bf 259} 385]. The key point of the protocol is a generalized measurement described by a positive operator-valued measure, which can be realized by performing a unitary operation in the extended space and a conventional Von Neumann orthogonal measurement. By decomposing the evolution process from the initial state to the final state, we construct the quantum circuits for realizing the unitary operation with quantum Toffoli gates, and thus provide a physical means to realize the teleportation. Our method for constructing quantum circuits differs from the usual methods based on decomposition of unitary matrices, and is convenient for a large class of quantum processes involving generalized measurements.     

金属有机源化学气相沉积法生长氧化锌薄膜中氢气的作用及其机理

本文重点探讨了金属有机源化学气相沉积生长ZnO薄膜中氢气的作用与机理.研究表明氢气对ZnO薄膜的结构与性质具有重要的影响.当采用叔丁醇为氧源时,氢气对ZnO薄膜的晶体质量,表面结构和发光性质主要产生负面的影响,同时发现氢气的加入有助于抑制碳的沾污.而当采用笑气为氧源时,测量显示表面变光滑,晶体质量得到提高,发光强度也得到提升.氢气在笑气作为氧源生长ZnO的过程中基本起到了正面的作用.论文最后从氢气降低生长表面能量,提高表面原子迁移能力但存在表面腐蚀作用的方向以上结果给予了较好的解释.研究显示MOCVD生长高质量ZnO薄膜中氢气的优化具有特别重要的意义.     

基于低照度三基色图像去噪及融合彩色图像增强方法研究

现有的各类彩色图像增强方法,主要用于对光照不均匀或弱光条件下已获取的彩色图像进行直接增强,而低照度彩色成像系统获取的彩色图像是由单独采集的三基色图像融合而成。为此提出了基于低照度三基色图像去噪及融合彩色图像增强方法。利用小波变换对低照度条件下独立采集的三基色图像进行去噪;然后将去噪后图像融合成彩色图像,将彩色图像由RGB颜色空间转换为HSV颜色空间;在HSV空间对V进行MSR增强,再对增强后的图像进行S调整;最后再将其转换回RGB颜色空间。采用客观评价方法对选取的去噪增强后图像进行了评价。结果表明:经过去噪和增强后的彩色图像在均值、方差和熵3项指标上均优于三基色直接融合的彩色图像,平均提高幅度为均值11.37%、方差8.46%、信息熵0.44%。该方法可移植到低照度彩色成像系统中,对成像质量的提升具有指导意义。