Stray light analysis of low-level-light optical system with LightTools software北大核心CSCD

为解决低照度微弱信号探测的微光光学系统杂散光问题,研究了杂散光的原理和特性。利用光学系统建模软件LightTools对微光光学系统进行仿真建模,并开展杂散光分析。为减少杂散光,在物镜筒的筒壁加工消光螺纹,并针对不同形式的消光螺纹,开展了能量仿真模拟。仿真结果表明,采用螺距0.35 mm的消光螺纹,能够将杂散光系数从7%降低到4%。仿真分析结果与实验结果一致,为其他微弱信号探测光学系统在设计阶段对杂散光进行消除提供了指导。     

生物可降解高吸水性非织造布的研制

用聚丙烯酸接枝淀粉浆液，在ＰＶＡ非织造布上形成吸水树脂，从而得到高吸水性非织造布。对接枝单体的比例、交联条件、浸轧量及非织造布规格等因素对高吸水非织造布吸水性能的影响进行了讨论了并测定了其生物降解性能。     

函数的逼近及其在下半连续函数可微性中的应用

通过函数的下卷积函数列的逼近方法,在变分原理中从扰动最小值点集的“大小”入手,研究了下半连续函数的可微性。     

飞秒激光-薄膜靶相互作用中超热电子产额和激光转化效率

 在激光能量130 mJ（靶面），脉宽60 fs，波长800 nm，对比度1∶10^-6，激光与靶法线成45°夹角，P偏振，靶面激光峰值功率密度约为7.0×10¹⁷ W·cm^-2，无预脉冲的条件下，采用电子谱仪与经γ标准源标定的LiF热释光探测器（TLD）相配合，测量了飞秒激光-薄膜靶相互作用中产生的超热电子能谱。根据所测的能谱，推算出超热电子的产额和激光能量转化为超热电子能量的效率，在靶法线方向分别为1.19×10¹⁰/sr和4.55%/sr，在激光反射方向分别为1.83×10⁹/sr和0.76%/sr。结果显示，不同方向的超热电子产额和激光转化效率有所不同，原因在于激光-等离子体相互作用产生的超热电子构成各向异性的分布。     

中国陆相油气的形成和运移(Ⅱ)

本文(Ⅰ)着重研究了中国陆相湖盆沉积物中有机质向油气演化的过程.本文(Ⅱ)阐明了现代青海湖沉积物埋藏初期及早期成岩作用过程中有机质的演化特征.其结果表明陆相有机质大量开始向石油转化的深度随不同地区、不同时代、不同类型的有机质而异.最后,运用特征有机化合物、稀有气体同位素等资料,结合构造发展史阐述我国陆相油气运移的类型、规模和途径.指出近油源短距离是陆相油气运移的基本特征.     

我国正负术历史

九章算术大約在公元一世紀編集成书,其中已著录正负术,这是我国古代数学上的光輝成就。正負术的产生有它在数学本身內在的发展,但为什么我国很早就熟悉了正負术,这和我国古代天文学的发展有关。东汉元和二年(85),我国天文学家创制的四分曆中,明白的記載了正負术的方法。它說: “強正弱负也。其強弱相減,同名相去;异名从之,从強进少为弱,从弱退少为強。”四分曆在計算太阳的視位置度数时,以不滿整度数部分用少、半、太来区别。少是1/4,半是2/4,太是3/4。比“少”多一些的叫少强,比“少”少一些的叫少弱。它們间的关系是:     

从极优基未必能迅达最优基：兼与文献[1]作者商榷

本对献[1]提出的“求解线性规划的快速换基迭代法”从多阶段决策的观点阐述并举证了从极优基未必能快速到达最优基的论断。旨在说明用此方法求解一般线性规划问题时不一定能实现快速换基迭代的概念。     

Chemical Oxidation of La2CuO4 Epitaxial Thin Films Grown by Pulsed Laser Deposition

Chemical oxidation is used to induce superconductivity in La2CuO4 expitaxial thin films fabricated by pulsed laser deposition technique. Details about the influence of oxidation time on structural, surface morphology, Raman spectra, and electrical properties have been investigated. The results convince that successful uptake of oxygen occurs in the oxidized films, and the content of the inserted oxygen increases with increasing oxidation interval. The possible mechanism for the excess oxygen insertion into the film is also discussed.     

A Base-Emitter Self-Aligned Multi-Finger Sil-xGex/Si Power Heterojunction Bipolar Transistor

With a crystal orientation dependent on the etch rate of Si in KOH-based solution, a base-emitter self-Migned large-area multi-finger configuration power SiGe heterojunction bipolar transistor （HBT） device （with an emitter area of about 880μm^2） is fabricated with 2μm double-mesa technology. The maximum dc current gain is 226.1. The collector-emitter junction breakdown voltage BVcEo is 10 V and the collector-base junction breakdown voltage BVcBo is 16 V with collector doping concentration of 1 × 10^17 cm^-3 and thickness of 400nm. The device exhibited a maximum oscillation frequency fmax of 35.5 GHz and a cut-off frequency fT of 24.9 GHz at a dc bias point of Ic = 70 mA and the voltage between collector and emitter is VCE = 3 V. Load pull measurements in class-A operation of the SiGe HBT are performed at 1.9 GHz with input power ranging from OdBm to 21 dBm. A maximum output power of 29.9dBm （about 977mW） is obtained at an input power of 18.SdBm with a gain of 11.47dB. Compared to a non-self-aligned SiGe HBT with the same heterostructure and process, fmax and fT are improved by about 83.9% and 38.3%, respectively.     

Measuring Grüneisen Parameter of Lead by High Pressure-Jump Method

Using the technology of pressure jump, variations of temperature associated with pressure from 2.4 GPa to 4.6 GPa are measured for lead. The Grfuneisen parameter is calculated from the thermodynamic relation γ =（Ks/T）（aT/aP）s, in which substitution of △T/△P for aT/aP at median pressure is strictly justified. The correction of temperature change is carried out by analysing the experimental data, which makes the process more approaching to an adiabatic condition. The calculated values of △T/ △ P and γ gradually decrease with the increasing pressure. The decrease trend is consistent with the previous work. The γ values in the range of 2-3 GPa are averagely higher than the results of Ramakrishnan et al., indicating the effect of temperature correction. The improved method is promising for measurements of Grfineisen parameter to higher pressure range.