氩、氢混合等离子体处理对GaAs表面性质及发光特性的影响

介绍了一种氩、氢混合等离子体清洗GaAs基片的实验工艺,深入研究了氩、氢等离子体清洗GaAs表面污染物和氧化层,并活化表面性能的基本原理,同时讨论了气体流量、溅射功率和清洗时间等不同溅射参数对等离子体清洗效果的影响。结果表明,在氩气和氢气流量分别为10 cm³/min和30 cm³/min,溅射功率为20 W,清洗时间为15 min的条件下,GaAs样品的光致发光强度提高达139.12%,样品表面的As-O键和Ga-O键基本消失。     

一类空间连续系统稳定性与分岔的数值研究

空间连续系统的非线性动力学研究，由于其工程背景与复杂性，近年来越来越受到重视。局部狭窄圆管内的流体流动即为空间连续系统。本文采用有限差分方法，将由偏微分方程组描述的空间连续系统约化为由常微分方程组描述的高维离散动力系统。求得了动力系统的平衡解及判断其稳定性的最大Ｌｙａｐｕｎｏｖ指数，求得了动力系统的前三个Ｌｙａｐｕｎｏｖ指数，以此作为系统是否出现分岔的判别条件。     

GaAs光导开关飞秒激光点触发实验及分析

针对光导开关阵列和光纤分束耦合的实际应用环境,提出一种新的实验方案,用于测试当触发光源相对于开关光敏面为点光源时入射位置对输出脉冲的影响.实验证明,不同的入射位置对开关输出脉冲有很大的影响.在入射光从负极向正极扫描过程中输出脉冲逐渐增强,在正极附近输出达到峰值,但在电极边缘处有所减弱.分析表明,这一现象和开关体内电场的分布有密切联系.     

自由基浓度测定方法的再验证及其在煤化学中应用

对前人建立的标准曲线法测煤中自由基浓度进行优化,以DPPH标准样品和基准样品的二次积分面积比值为新参数,结果显示新参数标准曲线法的实测值与理论值相对误差都在5%以内;重复性、复现性实验的相对标准偏差都小于3%。将新参数标准曲线法用于分析不同煤化程度煤和新疆黑山煤(HS)沥青质的自由基浓度,发现随着煤化程度增加,其煤中自由基浓度逐渐增大,从低阶褐煤的8.531×10~(17)/g上升到高阶无烟煤3.37899×10~(19)/g;而在HS煤液化过程中,随着加氢液化温度的升高,其沥青质自由基浓度逐渐下降,从290℃的1.5793×10~(18)/g降到450℃的7.410×10~(17)/g,沥青质自由基浓度变化趋势与其产率变化趋势相一致。     

光学透明陶瓷铝酸镁（MgAl2O4）的制备工艺和性能

本文报导了用金属醇盐法制备主同纯、随细铝酸镁粉末的合成工艺和透明铝酸镁陶瓷的制备工艺，测试了铝酸镁的光学性能、物理和机械性能。结果表明，作为光学材料，透明铝酸鲜具有非常好的机械强度的硬度，有适中的热膨胀系数，在０．３－０．５μｍ波段范围，其透过率不低于８１％，在３－５μｍ波段范围，其透过率达到８７％。     

固相萃取/超高效液相色谱-串联质谱测定水果中5种植物生长调节剂残留量

建立了固相萃取/超高效液相色谱-串联质谱(UPLC-MS/MS)同时测定水果中6-苄基腺嘌呤(6-BA)、噻苯隆、氯吡脲、多效唑和烯效唑5种植物生长调节剂残留量的分析方法。水果样品经乙腈提取,NH2固相萃取小柱进行富集、净化,以二氯甲烷-甲醇(92∶8)为洗脱溶液,浓缩定容后,用Waters ACQUITY UPLC BEH C18(50 mm×2.1 mm,1.7μm)色谱柱分离,流速0.3 m L/min,以水-甲醇为流动相梯度洗脱,于UPLC-MS/MS仪多反应监测(MRM)模式测定,基质匹配标准溶液外标法定量。结果表明,5种植物生长调节剂在5~500 ng/m L浓度范围内呈良好的线性关系,相关系数(r2)为0.996 1~0.999 6。在0.004,0.02,0.1 mg/kg加标水平下,方法的回收率为75.6%~110.5%,相对标准偏差(RSD)为1.2%~12.8%,方法检出限(LOD,S/N≥3)为0.001~0.002 mg/kg,定量下限(LOQ,S/N≥10)为0.003~0.006 mg/kg。该方法操作简便、灵敏度高、准确可靠,适用于水果中5种植物生长调节剂残留量的同时测定。     

射频等离子硫钝化GaAs(100)的表面特性

采用射频等离子方法,对Ga As(100)衬底片表面进行干法硫等离子体钝化,旨在得到性能稳定含硫钝化层。样品经过360℃温度条件下的快速热退火,光致发光(PL)测试表明,钝化后的样品PL强度上升了71%。同时,钝化样品的稳定性测试结果表明,样品放置在实验室空气中30 d,其PL强度未出现明显变化,说明Ga As的等离子体干法硫钝化具有较好的性能稳定性。     

Al2O3/SnO2 Co-Nanoparticle Modified Grafted Collagen for Improving Thermal Stability and Infrared Emissivity

Al2O3/SnO2 co-nanoparticles were prepared with a modified sol-gel technique followed by a thermal treatment process. With these co-nanoparticles the grafted collagen-Al2O3/SnO2 nanocomposites were obtained using a supersonic dispersion method. X-ray diffraction, FT-IR analysis, transmission electron microscopy, TGA/DTA and infrared emissivity test were performed to characterize the resulting nanoparticles and nanocomposites, respectively. The Al2O3/SnO2 co-nanoparticles showed a narrow distribution of size between 20-40 nm and could be uniformly absorbed on the tri-helix scaffolds of the grafted collagen without any aggregation. The nanocomposites possessed better thermal stability and substantially lower infrared emissivity than the grafted collagen and Al2O3/SnO2 co-nanoparticles with an increase of degradation temperature from 39 to 210 ℃ and a decrease of infrared emissivity from 0.850 of the grafted collagen and 0.708 of the Al2O3/SnO2 co-nanoparticles to 0.424, which provided a potential application of the nanocomposites to areas such as photoelectronics.     

LOW-FREQUENCY INTERNAL FRICTION STUDY FOR SrBi2Ta2O9 FERROELECTRIC CERAMICS

Low-frequency internal friction (IF) of SrBi₂Ta₂O₉(SBT) ceramics has been measured at temperatures ranging from 293 to 623 K. Two IF peaks, with their locations around 393 K (P1) and 569 K (P2) (f≈1.58 Hz), respectively, are observed. P1 is found to be associated with a relaxation process with activation energy of 0.97 eV and pre-exponential factor of 3.58×10^-14 s. Peak shape analyses reveal that P1 can be well described by a broadened Debye peak with the width parameter β from 2.70 to 2.92. The mechanism responsible for P1 is proposed to be relaxation of oxygen vacancies near domain walls(DWs). P2 is considered to arise from viscous motion of DWs since it shows characteristics of static hysteresis type. Comparisons for the IF behavior between SBT and Pb(Zr, Ti)O₃(PZT) suggest that in SBT oxygen vacancies are much less localized near DWs than that in PZT. This result provides a possible explanation for the weak DW pinning due to oxygen vacancies in SBT.     

A FURTHER STUDY OF THE THEORY OF ELASTIC CIRCULAR PLATES WITH NON－KIRCHHOFF－LOVE ASSUMPTIONS

ＡＦＵＲＴＨＥＲＳＴＵＤＹＯＦＴＨＥＴＨＥＯＲＹＯＦＥＬＡＳＴＩＣＣＩＲＣＵＬＡＲＰＬＡＴＥＳＷＩＴＨＮＯＮ－ＫＩＲＣＨＨＯＦＦ－ＬＯＶＥＡＳＳＵＭＰＴＩＯＮＳＣｈｉｅｎＷｅｉ－ｚａｎｇ（钱伟长）ＲｕＸｕｅ－ｐｉｎｇ（茹学萍）（ＳｈａｎｇｈａｉＵｎｉ...