Comparison of the boundary theory with the contact rule of phase regions and Gupta’s method

The phase boundary theory and the contact rule of phase regions are compared, and some weaknesses of the latter are manifested. The comparison between the Gupta’s method and the boundary theory method for constructing multicomponent isobaric sections is also presented.     

146Ce核的八级形变带和准γ带

通过测量²⁵²Cf自发裂变所产生的瞬发γ射线, 对¹⁴⁶Ce核的高自旋结构进行了重新研究, 结果更新了以前报道的能级纲图, 把八级形变集体带扩展到更高的自旋, 并且重新构建了可能的准γ带结构. 此外, 用反射不对称壳模型(RASM)对¹⁴⁶Ce核的八级形变带进行了计算, 低自旋处的计算结果与实验数据符合得很好.     

Synthesis of a Novel Aromatic Diamino-bridged Bis（β-cyclodextrin） and its Inclusion Complexation with Dyes Molecules

Bridged bis(β-cyclodextrin)s (CDs), as a very important family of CD derivatives, have been known that they can significantly alter the molecular binding ability and selectivity toward a variety of guests in comparison with parent cyclodextrin. Their two…     

System dependence of the correlation function of IMFs in Ar + Sn at 35 MeV/u

The inclusive reduced velocity correlation functions of the intermediate mass fragments were measured in the reactions of ³⁶Ar + ^112,124Sn at 35 MeV/u. The anti-correlation is observed to be stronger in ³⁶Ar + ¹²⁴Sn system than that in ³⁶Ar + ¹¹²Sn. The difference of the correlation functions between the two reactions is mainly contributed by the particle pairs with high momenta. A three body Coulomb repulsive trajectory model is employed to calculate the emission time scale of the IMFs for the two systems. The time scale is 150 fm/c in ³⁶Ar + ¹¹²Sn and 120 fm/c in the ³⁶Ar + ¹²⁴Sn, respectively.     

多段构件组成的压杆平面内稳定

分析由若干段等截面或者变截面构件组成的压杆平面内稳定问题．从由三段等截面构件组成的压杆平面内稳定问题出发，对两端为变截面、中间为等截面构件组成的压杆的平面内稳定问题进行了分析，得出和两端为等截面构件情况类似的屈曲荷载计算公式．并对两端固接的情况进行了研究分析．     

Characterization of iron surface modified by 2-mercaptobenzothiazole self-assembled monolayers

A self-assembled monolayer of 2-mercaptobenzothiazole (MBT) adsorbed on the iron surface was prepared. The films were characterized by electrochemical impedance spectroscopy (EIS), X-ray photoelectron spectroscopy (XPS), Fourier transform infrared reflection spectroscopy (FT-IR) and scanning electron microscopy (SEM). Besides, the microcalorimetry method was utilized to study the self-assembled process on iron surface and the adsorption mechanism was discussed from the power-time curve. The results indicated that MBT was able to form a film spontaneously on iron surface and the presence of it could protect iron from corrosion effectively. However, the assembling time and the concentration influence the protection efficiency. Quantum chemical calculations, according to which adsorption mechanism was discussed, could explain the experimental results to some extent.     

Ag纳米颗粒的光吸收和透射电镜研究

用硼氢化钠作还原剂,制备出两种相对稳定的含银纳米颗粒的水溶胶,用透射电镜（TEM）和光学吸收谱对这些颗粒进行了表征.当被还原的银离子较少时,所形成的银纳米颗粒较小,吸收峰呈现二极等离子体共振吸收峰.当被还原的银离子较多时,银纳米颗粒尺寸变大,并出现二极和四极共振吸收峰.在Ag纳米颗粒形成后,对其溶液稀释,发现其峰形保持不变,而峰位会出现红移,最大红移量可达到10 nm.透射电镜研究表明,低浓度溶胶中的Ag纳米颗粒尺寸较为均匀,平均直径12 nm.高浓度溶胶中的纳米颗粒尺寸呈双尺寸分布特点,少量颗粒直径小于14 nm,大部分颗粒直径大于20 nm.     

Multi-objectives fuzzy models for designing 3D trajectory in horizontal wells

In this paper, multi-objective models for designing 3D trajectory of horizontal wells are developed in a fuzzy environment. Here, the objectives of minimizing the length of the trajectory and the error of entry target point are fuzzy in nature. Some parameters, such as initial value, end value, lower bound and upper bound of the curvature radius, tool-face angle and the are length of each curve section, are also assumed to be vague and imprecise. The impreciseness in the above objectives have been expressed by fuzzy linear membership functions and that in the above parameters by triangular fuzzy numbers. Models have been solved by the fuzzy non-linear programming method based on Zimmermann [1] and Lee and Li [2]. Models are applied to practical design of the horizontal wells. Numerical results illustrate the accuracy and efficiency of the fuzzy models.     

肿瘤微波热疗的温度场预示及热损伤研究

本文将热损伤的产生和影响引入到肿瘤的微波热疗中。运用微波能量比吸收率SAR的分布分析了微波在组织中的传输和吸收过程,并对微波热疗过程中的温度场、热损伤分布以及血液灌注率的变化进行了数值模拟。     

高功率固体激光放大系统相位自校正方法研究

就光学元件间低频相位误差叠加提出用相关系数作为叠加相位结果的估计参量，并通过模拟计算和验证实验证明了相关系数能有效地对低频相位叠加结果进行比较估计，在此基础上就高功率固体激光放大系统中放大片的选取和安装提出了自校正方法并实现了自校正过程。