共沉淀法制备LiMn_xCo_yO_2的显微结构及其电化学性能

通过共沉淀法制备前驱体,随后在900℃下经不同时长烧结得到了层状LiMn_xCo_yO_2。X射线衍射、扫描电镜和透射电镜的研究结果表明,层状LiMn_xCo_yO_2的晶体结构是菱面体点阵,空间群是R3m,点阵常数与LiCoO_2非常接近。不同烧结时长下得到的样品在扫描电镜下均呈球状,随着烧结时间延长,球形规整度变得更好。对不同样品的电化学性能测试表明,烧结时间越长,样品中Mn的相对含量越高,其首次充放电比容量和循环性能越好。     

Suppressed formation of CO2 and H2O in the oxidative coupling of methane over La2O3/MgO catalyst by surface modification

Oxidative coupling of methane (OCM) is a promising way to convert methane into C_2 hydrocarbons. However, CO_2 and H_2O are by-products of the reaction. To utilize the higher activity of lanthanum oxide and save its usage, MgO supported La_2O_3 catalyst was prepared. Surface modification of the catalyst with nitric acid was made to suppress the formation of the by-products. Experimental results indicated that the addition of nitric acid increased the surface oxygen species with binding energy of ca. 531.7 eV and at the same time reduced the pore volume of the catalyst. These effects of nitric acid finally led to the increase of C_2 selectivity and the decrease of the by-products formation. Hydrogen selectivity was found about 14%- 18% over the catalysts adopted in this work.     

中国微量元素科学研究现状、意义、问题和对策

通过"从统计数字看现状"、"从科研成果看意义"、"从社会现象看问题"和"为持续发展想对策"等四个方面高度概括了中国微量元素科学研究走过的30多年历程,为该学科今后的持续发展提供了方向性的意见和讨论的基础。     

导电聚苯胺/TiO_2微/纳米球的制备及其结构表征

采用具有八面体形貌的氧化亚铜为模板,制备了聚苯胺/TiO2(PANI/TiO2)微/纳米球,TiO2纳米粒子很均匀地分散在聚苯胺中.研究了不同TiO2/苯胺(TiO2/ANI)摩尔比对PANI/TiO2复合物的结构、形貌和电学性能的影响.实验结果表明,随着TiO2/ANI摩尔比的增加,PANI/TiO2复合物的直径逐渐减小,当TiO2/ANI摩尔比为0.16时,复合物的平均直径为373nm,而当TiO2/ANI摩尔比增加到1.6时,复合物的平均直径降到80nm.PANI/TiO2复合微/纳米球的电导率随着TiO2/ANI摩尔比的增加先升高后降低,当TiO2/ANI摩尔比达到1.6时,电导率由10-4S/cm提高到100S/cm,达到最大值.产物的形貌和结构分别采用扫描电镜、透射电镜、红外吸收光谱和X-射线衍射等手段进行了表征.     

基于LED的色度学实验研究

作为环保、节能、可智能控制的新型光源,发光二极管（LED）广泛应用于人们的现代生活、生产中,更有望替代传统的照明光源。以三基色LED为光源,制作了三路独立可调恒流电源,通过调节三基色光的不同配比实现加法混色,研究设计了加法混色的色度学实验,既可以直接观察混色后的实验现象,又能通过测量光谱数据得到色度参数。LED光源环保...     

Reversible transition between thermodynamically stable phases with low density of oxygen vacancies on the SrTiO3(110) surface

The surface reconstruction of SrTiO3(110) is studied with scanning tunneling microscopy and density functional theory (DFT) calculations. The reversible phase transition between (4×1) and (5×1) is controlled by adjusting the surface metal concentration [Sr] or [Ti]. Resolving the atomic structures of the surface, DFT calculations verify that the phase stability changes upon the chemical potential of Sr or Ti. In particular, the density of oxygen vacancies is low on the thermodynamically stabilized SrTiO3(110) surface.     

Room temperature magnetocaloric effect of La-deficient bulk perovskite manganite La0.7MnO3−δ

Room temperature magnetocaloric effect in La-deficient bulk perovskite manganite La_0.7MnO_3−δ prepared by conventional solid-state reaction has been reported. The maximum value of the magnetic entropy change (about−1.32 J/kg K) and the refrigerant capacity (approximately close to 37 J/kg) had been obtained at 290 K corresponding to a magnetic field variation of 1 T for La_0.7MnO_3−δ. It is the strong Jahn-Teller coupling that changes Mn-O bond length and Mn-O-Mn bond angles and then the canted spin arrangement and induces the strong double-exchange coupling to a comparatively high magnetic transition temperature. This Curie temperature near room temperature with easy fabrication and higher chemical stability makes La_0.7MnO_3−δ a potential candidate as a working substance in magnetic refrigeration technology.     

Characterization and oxidation behavior of NiCoCrAlY coating fabricated by electrophoretic deposition and vacuum heat treatment

Electrophoretic deposition (EPD) was showed to be a feasible and convenient method to fabricate NiCoCrAlY coatings on nickel based supperalloys. The microstructure and composition of the NiCoCrAlY coatings after vacuum heat treatment were characterized by X-ray diffraction (XRD), scanning electron microscope (SEM) and energy dispersive X-ray analysis (EDAX). Isothermal-oxidation test was performed at 1100 °C in static air for 100 h. The results show that the major phases in electrophoretic deposited and vacuum heat treated NiCoCrAlY coating are γ-Ni and γ′-Ni₃Al phases, also there is an extremely small quantity of Al₂O₃ in the coating. Composition fluctuations occur in the coating and a certain amount of titanium diffuse from the superalloy substrate to the top of the coating during vacuum heat treatment. The oxidation test results exhibit that the oxidation kinetics of this coating has two typical stages. The protective oxide layer is mainly formed in the initial linear growth stage and then the oxide layer hinders further oxidation of the coating in the subsequent parabolic growth stage. The coating can effectively protect the superalloy substrate from oxidation. A certain amount of rutile TiO₂ is formed in the coating during oxidation and it is adverse to the oxidation resistance of the coating.     

Influence of superalloy substrate roughness on adhesion and oxidation behavior of magnetron-sputtered NiCoCrAlY coatings

The present study has been conducted in order to determine the influence of superalloy substrate roughness on adhesion and oxidation behavior of magnetron-sputtered NiCoCrAlY coatings. Six types of coating samples with different substrate roughness were tested. The surface roughness and real surface area of both the substrates and coatings were studied by atomic force microscopy (AFM) techniques. The scratch tests performed at progressive loads were employed to evaluate the adhesion of the coatings. Cyclic oxidation tests were performed at 1100 °C in air for 50 cycles, each cycle consisting of 1 h heating in the tube furnace followed by 15 min cooling in the open air. The AFM measurements exhibit that the surface roughness of the sputtered NiCoCrAlY coating increases with the increasing of the superalloy substrate roughness. The NiCoCrAlY coatings present slightly lower roughness than the corresponding superalloy substrate. The scratch adhesion tests indicate that the coatings on substrates with a smoother surface possess better adhesion than on those with a rougher surface. Both the real surface area and oxidation weight gain of the coatings decrease with the decreasing of the superalloy substrate roughness. The NiCoCrAlY coating sputtered on the superalloy substrate with lower roughness provides relatively higher antioxidant protection than that provided by the coating with rougher substrate.     

Detecting communities in clustered networks based on group action on set

In this paper, we propose a well targeted algorithm (GAS algorithm) for detecting communities in high clustered networks by presenting group action technology on community division. During the processing of this algorithm, the underlying community structure of a clustered network emerges simultaneously as the corresponding partition of orbits by the permutation groups acting on the node set are achieved. As the derivation of the orbit partition, an algebraic structure r-cycle can be considered as the origin of the community. To be a priori estimation for the community structure of the algorithm, the community separability is introduced to indicate whether a network has distinct community structure. By executing the algorithm on several typical networks and the LFR benchmark, it shows that this GAS algorithm can detect communities accurately and effectively in high clustered networks. Furthermore, we compare the GAS algorithm and the clique percolation algorithm on the LFR benchmark. It is shown that the GAS algorithm is more accurate at detecting non-overlapping communities in clustered networks. It is suggested that algebraic techniques can uncover fresh light on detecting communities in complex networks.