中波红外景象投影光学系统消热差设计

针对红外成像系统性能测试与评估的应用需求,设计了一套基于数字微镜器件的消热差的中波红外景象投影光学系统.探讨了红外视景仿真用投影光学系统的像差特性和设计方法,并对投影系统的无热化进行了分析.采用分光板和补偿板方案,解决了大相对孔径条件下投影系统的远心照明分光和像差平衡问题,提高了分辨率和均匀性,增大了视场.系统由远心投...     

荧光动力学的转移函数理论

为描述弱激发条件下存在能量传递的体系中的荧光动力学特性,引进了响应函数和转移函数,并由此建立了新的描述体系动力学过程的系统表述方法。通过一些实例的讨论,表明新方法是系统研究复杂体系荧光动力学的有效手段。 关键词：     

First-Principles Prediction of High-Pressure Phase of CaC6

The lattice dynamics of rhombohedral GaG6 is studied as a function orpressure to probe Its high pressure phase with low superconducting transition temperature using the density functional liner-response theory. The pressureinduced phase transition in CaC6 is attributable to the softening transverse acoustic （TA） phonon mode at the zone boundary X （0.5, 0.0, 0.5） point. The high pressure phase is then explored by performing fully structural optimization in the supercell which accommodates the atomic displacements corresponding to the eigenvectors of the unstable mode of TA（X）. The high-pressure phase is predicted to be a monoclinic unit cell with space group P21/m.     

Single-Proton Pickup Reaction of the Halo Nucleus ^6He on a ^9Be Target at 25 MeV/nucleon

The inclusive differential cross sections of the ^7 Li nucleus in a reaction induced by ^6He on a ^9Be target are measured at an incident energy of 25 MeV/nucleon. Finite-range distorted-wave Born approximation calculations suggest that these ^7 Li particles are formed in a direct single-proton pickup reaction ^9Be（^6He,^7 Li）^8Li. The experimental data can be well reproduced by taking into account of the contributions of both the ground states and the first excited states of ^7Li and ^8Li.     

Light Irradiation through Small Particles and Its Applications for Surface Nanostructuring in Near Field

We investigate the light scattering through small particles and its applications in nanostructuring, such as nanobumping, nanopatterning and dry laser cleaning. The theoretical calculation based on Mie theory provides an exact solution for sphere cavity resonance and plasmon resonance, which are two mechanisms for dielectric and metallic particles assisted surface nanostructuring in near field. The experimental results indicate that nanobumps on glass surface and subwavelength holes array on silicon surface can be formed without cracks with the self-assembly of 1 μm silica particle mask under laser irradiation. It is also found that the scattering wave by 40 nm gold particles can propagate 200 times away in terms of particle radius as recorded by photoresist under the UV light irradiation. Meanwhile, dry laser cleaning of 40nm gold particle on silicon wafer is demonstrated at plasmonic resonance frequency. The total cleaning efficiency is estimated to be 80%.     

范德堡方法在ZnO薄膜测试中的应用

近年来,随着对宽禁带半导体材料,氧化锌薄膜研究的快速发展,对其电学性质的研究也显得尤为重要。主要介绍范德堡方法在ZnO薄膜电学性质测量中的应用,并对初步测量结果作简要的讨论。     

β-delayed neutron decay of 21N

The β-delayed neutron and γ spectra of neutron-rich nucleus ²¹N using β-γ and β-n coincidence measurements were presented in this paper. Thirteen new neutron groups ranging from 0.28 MeV to 4.98 MeV and with a total branching ratio 88.7±4.2% were observed. One γ transition among the excited states of ²¹O, and four γ transitions among the excited states of ²⁰O were identified in the β decay chain of ²¹N. The ungated half-life of 83.8±2.1 ms was also determined for ²¹N.     

利用Pr_(70)Cu_(30)晶界扩散改善烧结钕铁硼废料矫顽力的研究

钕铁硼磁体制备过程中出现的部分块体废料由于矫顽力较低,性能难以满足使用要求.本文主要通过晶界扩散技术来提高废料磁体的矫顽力.采用Pr_(70)Cu_(30)合金作为扩散介质,对烧结钕铁硼废料磁体进行了晶界扩散处理,研究了扩散温度、扩散时间和回火时间对扩散后的磁体性能的影响.结果显示,800℃下扩散3 h,磁体的矫顽力从原来的7.88 kOe(1 Oe=79.5775 A/m)提升至11.55 kOe,提升幅度为46.6%,同时剩磁没有明显降低.扩散后回火对矫顽力的提升有一定的作用.800℃下扩散4h后的磁体在500℃回火3h后,最高矫顽力可达11.97 kOe,比原磁体废料提高了51.9%,接近成品磁体的水平.显微组织分析证实了晶界扩散的作用.扩散处理后的磁体中,主相晶粒间形成了连续晶间相,起到有效的磁隔离作用,有利于矫顽力的提高.研究还发现,Pr_(70)Cu_(30)晶界扩散虽然可以使磁体腐蚀电位上升,但也会增加腐蚀电流密度,不利于磁体抗腐蚀性的改善.本文工作对于提高材料的成品率具有重要意义.     

基于多向联合交汇的柔性视觉形貌测量新方法

针对大尺寸物体形貌测量应用,设计一种视觉形貌测量新方法。该方法是将两套没有公共视场的单目视觉传感器组合起来联合交汇,分别用于位姿测量和单目多位置交汇测量。位姿测量通过求解PnP问题为单目多位置交汇测量提供位姿信息。单目多位置交汇测量利用位姿测量提供的辅助信息通过光束平差解算出待测物的形貌。分析了系统原理,给出位姿测量PnP算法实现过程,介绍了非公共视场相机的标定方法原理,分析了单目多位置交汇测量的原理并给出实现方法。最后进行了测量方法的验证实验,实验结果表明,在3 m×3 m的工作范围内系统测量精度为5 mm,证明该方法可以用于大尺寸物体形貌测量,且结构简单轻便,具有很强的灵活性。     

Ti(C,N)基金属陶瓷磨损机理的研究

研究了Ｔｉ（Ｃ,Ｎ）基金属陶瓷的磨损特性,结果表明,其摩擦学性能优良,耐磨性随占结相Ｎｉ的增加而降低,在干摩擦下其磨损机理同为粘着磨损及硬质相剥落,随Ｎｉ含量的减少,金属陶瓷的粘着减轻,在油润滑条件下,金属陶瓷的磨损机理是犁削及硬质相剥落。