ICP微等离子体射流在快速成形制造中的应用

本文开展了大气压甚高频感应耦合(ICP)微等离子体射流的特性与应用研究.在150 MHz甚高频,功率为90 W条件下获得温度高达上千度的温热等离子体射流,射流长度近3 cm.随着气流量的增加射流将呈现层流到湍流的转变,长度先增后减;而功率对于射流长度的影响存在着一个上限,当等离子体吸收的能量与扩散损失的能量达到平衡时,射流长度将达到最大.利用这种ICP微等离子体射流进行了微尺寸金属铜的快速成形制造,得到了球冠状和柱状铜金属件.在扫描电子显微镜下观察到沉积物表面最小颗粒尺寸远小于铜粉颗粒;X射线衍射结果显示沉积物表面存在弱氧化物峰,这是沉积过程中空气被射流卷入所致.     

无光滤波六倍频微波信号产生的系统设计

基于两个级联偏振调制器,提出了一种高频谱纯度、稳定的六倍频微波信号产生方法。该方法通过适当调整偏振片的偏振方向、射频驱动信号电压和相位,实现无光滤波器条件下、任何波段六倍频微波信号的产生。利用Optisystem平台搭建的仿真系统,以S波段4 GHz信号为例,验证了该设计系统产生的六倍频信号质量,并分析了非理想射频驱动电压和相位对六倍频信号质量的影响,结果表明：该设计系统能产生最大光边带抑制比、射频无杂散抑制比分别为21.3,15.2 dB的六倍频微波信号;且非理想驱动电压和相位差的偏离应控制在理想值5%的范围之内。     

Ab initio calculations of accurate dissociation energy and analytic potential energy function for the second excited state B1∏ of 7LiH

The reasonable dissociation limit of the second excited singlet state B¹∏ of ⁷LiH molecule is obtained. The accurate dissociation energy and equilibrium geometry of the B¹\Pi state are calculated using a symmetry-adapted-cluster configuration--interaction method in full active space. The whole potential energy curve for the B¹∏ state is obtained over the internuclear distance ranging from about 0.10nm to 0.54nm, and has a least-square fit to the analytic Murrell--Sorbie function form. The vertical excitation energy is calculated from the ground state to the B¹∏ state and compared with previous theoretical results. The equilibrium internuclear distance obtained by geometry optimization is found to be quite different from that obtained by single-point energy scanning under the same calculation condition. Based on the analytic potential energy function, the harmonic frequency value of the B¹∏ state is estimated. A comparison of the theoretical calculations of dissociation energies, equilibrium interatomic distances and the analytic potential energy function with those obtained by previous theoretical results clearly shows that the present work is more comprehensive and in better agreement with experiments than previous theories, thus it is an improvement on previous theories.     

相变域硅薄膜材料的光稳定性

采用RF-PECVD技术，通过改变反应气体的硅烷浓度制备了一系列不同晶化率不掺杂的硅薄膜材料，研究了工艺变化对材料结构的影响及材料光电特性同微结构的关系.随后进行了光衰退试验，在分析光照前后光电特性变化规律的基础上，认为材料中的非晶成分是导致材料光电特性衰退的主要原因.在靠近过渡区非晶一侧的硅材料比普通非晶硅稳定，衰退率较少；高晶化率微晶硅材料性能稳定，基本不存在光衰退；在靠近过渡区微晶一侧的硅材料虽然不是完全不衰退，但相比高晶化率硅材料来说更适合制备高效微晶硅电池. 关键词： 射频等离子体增强化学气相沉积 硅薄膜 Staebler-Wronski(SW)效应 稳定性     

Design and application of a laser beam alignment system based on the imaging properties of a multi-pass amplifier

Image relaying is presented as a technique for aligning beams onto mm-sized target of high power laser. On the basis of summarizing the preceeding work on the near-field image relaying of multiple spatial filters,the far-filed image relaying is suggested firstly. The near-field and far-field image relaying properties of multiple spatial filters in laser beams automatic alignment system are analyzed. A geometrical optics approach and an ABCD ray matrix theory are used throughout. The reasonable and optimum scheme for automatically aligning multi-pass beam paths is presented and demonstrated on the multi-pass amplifier system of the SG-Ⅲ prototype.     

Observation of B(+)-->phiphiK(+) and evidence for B(0)-->phiphiK(0) below eta(c) threshold

We report measurements of the decays B(+)-->phiphiK(+) and B(0)-->phiphiK(0) using a sample of 231 x 10(6) BB pairs collected with the BABAR detector at the PEP-II asymmetric-energy B factory at the Stanford Linear Accelerator Center. The branching fractions are measured to be B(B(+)-->phiphiK(+))=(7.5+/-1.0(stat)+/-0.7(syst)) x 10(-6) and B(B(0)-->phiphiK(0))=(4.1(-1.4)(+1.7)(stat)+/-0.4(syst)) x 10(-6) for a phiphi invariant mass below 2.85 GeV/c(2).     

感性与理性的和谐统一--构建和谐课堂的点滴体会

1感性认识与理性认识的和谐统一 在教育理念不断更新发展的今天，有一个新的课堂环境和课堂教学理念，是每一个教育工作者自身发展的一项重要任务．特别是在高中物理学科的课堂教学中，构建人与自然的和谐统一，就要从身边的自然环境出发，立足于感性认识为本，再升华为理性认识，把二者有机结合起来，才能让学生获得一个情感与理论上的和谐统一，提高学生对物理学科的浓厚兴趣．     

一种新型温度自补偿高灵敏度折射率计

基于高频CO2激光脉冲写入的新型超长周期光纤光栅(ULPFG),提出了一种可实现温度自补偿的新型高灵敏度折射率计。理论与实验表明,新型超长周期光纤光栅不同闪耀阶次谐振峰对外界折射率与温度变化的灵敏度各自不同,特别的是,该光栅存在对外界折变不敏感的谐振峰,测量中除了可以利用该峰实现温度同时测量外,还可以补偿另一个测量折变的谐振峰因温度变化带来的测量误差。该折射率计具有制作简单、成本低、强度好,灵敏度高等优点,当外界折射率在1.43~1.45范围内变化时,其折射率测量灵敏度可达每单位折射率240 nm,在实际工业应用中具有较大的潜在实用价值。     

Construction and cosmic-ray test of the new inner drift chamber for BESIII

A new inner drift chamber has been built which can replace the aged part of the BESIII drift chamber when needed. The design of the new inner drift chamber can minimize the ineffective area in the very forward and backward region and hence reduce the background event rate. With this design, the new inner drift chamber is expected to have a longer lifetime and improved performance due to the lower occupancy. The endplates and the cylinder were machined with high precision. Wire stringing was performed after the mechanical structure was assembled, and good quality of wire stringing was ensured by measurement of the tension and leakage current of the wires. After completion of the physical construction of the new chamber, a cosmic-ray test was carried out to test its performance. The results of the cosmic-ray test show that the new inner chamber achieves a spatial resolution of127 μm and a d E/dx resolution of 6.4%, which satisfies the design specifications.     

Enhanced Exfoliation Effect of Solid Auxiliary Agent On the Synthesis of Biofunctionalized MoS2 Using Grindstone Chemistry

Mass production and commercial availability are prerequisites for the viability and wide application of MoS₂. Here, we demonstrate enhanced grindstone chemistry for a one‐step synthesis of biofunctionalized MoS₂. By adding a SiO₂ auxiliary agent the exfoliation efficiency increases from 16.23% to 58.59% and a rapid and high‐yield exfoliation of MoS₂ is seen. SiO₂ exhibits a fragmentation effect, which reduces the lateral size and facilitates the exfoliation of MoS₂, thus inducing a high‐efficient paradigm in the top‐down fabrication of biofunctionalized MoS₂ nanosheets. The as‐prepared MoS₂‐chitosan (MoS₂‐CS) nanosheets display complete disaggregation and homogeneous dispersion, as well as a high content of chitosan (ca. 20 wt%). As a proof‐of‐concept application, the MoS₂‐CS nanosheets act as a biosorbent for Pb^II removal, exhibiting a good adsorption capacity and recyclability. This green and facile enhanced grindstone chemistry with minimal use of organic solvents and high‐throughput efficiency can be extended to the fabrication of other biocompatible inorganic 2D analogues for a variety of applications.